Start your trial now! First week only $4.99!*arrow_forward*

Question

how to convert 257 to Octal numbering system?

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: Problem 1.(Practice with DTFT.) Find the DTFT for each of the following signals. If needed, use DTFT...

A: The discrete-time signal is, The discrete-time Fourier transform (DTFT) of the signal is determined...

Q: Realize the circuit in Figure 7.3. (Rf1=6,8k, Rf2=8,2k, Rs=2k)- Dual power supply is +12 and -12.- U...

A: Circuit diagram is given as ;

Q: Explain with the help of proper diagram and necessary derivation, How Op-Amp can be used as invertin...

A: Inverting amplifier: When the output of the operational amplifier is connected to the inverting (-) ...

Q: i,(t) = A1 · cos(1000t + 90) + A2 • cos(2000t – 90) Assume the system is in steady state. Find the c...

A: The circuit diagram is,

Q: Calculate the apparent power, real power, andreactive power for the circuit shown in Figure.Draw the...

A: (a) From the given circuit, Capacitive inductance is given by,

Q: For the circuit given below, the value of the Transmission parameter D is j150 j100 -j200 200

A: To calculate the transmission parameter D first perform the delta to star conversion on the below-dr...

Q: Please answer the problem below

A: Click to see the answer

Q: iii) Estimate the stepping angle of the Variable Reluctance Stepper Motor with, 20 number of teeth o...

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...

Q: 1

A: From the basics of switching theory, the following can be concluded: 1. Switches in parallel constru...

Q: 9 In the filter circuit shown in Figure P6.29: Rs = 5 k2 C = 56 nF R = 100 k2 L= 9 µH Determine: a. ...

A: As per our guidelines we can only answer a maximum of three sub-parts at a time. Please resubmit the...

Q: Q5

A: As per our guidelines we can only answer a single question at a time. Please resubmit the other ques...

Q: a. Determine the frequency responseVout( jω)/Vin( jω) for the circuit of Figure P6.1. b. Plot the ma...

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...

Q: Whether it is right or wrong

A: The deal transformer poses the properties: The leakage flux in the ideal transformer are zero all t...

Q: 3

A: The generated voltage can be expressed as In this case, the following information is given:

Q: 5 Using phasor techniques, solve for the voltage v in the circuit shown in Figure P4.55. i(t) = 10 c...

A: The circuit diagram is shown below: First, we calculate the inductive impedance due to the capacito...

Q: You are working at a company that explores new ways of generating and storing energy in an effort to...

A: (a) The parameters of the large solenoid are given, the energy stored in the solenoid is given by ...

Q: Two parallel three-phase loads are connected to a three-phase a connected source through a line. The...

A: The delta connected source supplies the two parallel-connected loads in which one load is in star an...

Q: The switch in the circuit of Figure P5.58 opens att = 0. It closes at t = 10 seconds.a. What is the ...

A: The circuit diagram is, The switch in the circuit opens at t = 0 s and closes at t = 10 s. a). The...

Q: I need help with this problem

A: Drawing the circuit diagram showing all loads (ceiling fan) in a home, Each load (ceiling fan) show...

Q: 8.23 Find an expression for the gain of the circuit of Figure P8.23. 1/6 F ww O Vout 1/6 F,

A: From the circuit value of capacitance is, Capacitive impedance is given by ,

Q: 0.5 Problem 1 Consider the following closed-loop system with Gp(s) : s+0.5 R(s) E(s) C(s) 1- e-Ts G,...

A: Fig:Given closed loop system

Q: A single-phase transformer used for street lighting(high-pressure sodium discharge lamps) converts 6...

A: (a) The given single-phase transformer is step down transformer as the output voltage at the seconda...

Q: For a given diode network in the figure below, find output the voltage Vo. V, = lova DI D2 lo V

A: Given circuit is = Diodes are Si diode so forward voltage drop is 0.7 (V).

Q: A. in the circuit shown below, find the value of the resistor R that can make the circuit operate at...

A: A. According to the maximum power transfer theorem, maximum power will be transferred when the valu...

Q: a. By calculations show that: V. v = (2 sin(@.t) + d × cos[(wc – wm)t] – d x cos[(@c + wm)t]) Vm (so...

A: In this problem, the expression of the modulated voice signal going out of the mobile phone is given...

Q: 2 Determine the frequency so that the current I, and the voltage V, in the circuit of of Figure P4.5...

A: Write the expression for the load impedance in the circuit, which consists of the circuit elements R...

Q: Find the Thevenin equivalent of the circuit external to the 2 Ω resistor and use the result to find ...

A: To find the Thevenin equivalent circuit external to the 2Ω of the given circuit is. ...

Q: Draw the pattern for Q assuming -ve edge triggered JK flip flop

A: The truth table of JK flip-flop with a negative edge triggered is,

Q: A transformer with the following rating is tested to find its equivalent circuit parameters. 240 : 1...

A: Given that rating of transformer is 500VA ,240/120V @60 Hz From open circuit test:120V, 0.6A and 30W...

Q: Reply fast the Norton equivalent circuit.

A: According to the Norton equivalent circuit, it states that any complex network can be transformed in...

Q: Discuss the general conditions under which a source-follower or a common-gate amplifier would be use...

A: The common gate amplifier would be used as: The common gate amplifiers are needed to obtain the vol...

Q: Hi need solved 7.79 sedra smith

A: The given data of the Common base Amplifier is, RL = RC = 10kΩ, Rsig. = 50Ω. Now, first, draw the co...

Q: 2

A: Consider the given Boolean Expression,

Q: Assume a knee voltage of 0.7V and B-120 for all transistors. Determine the Ve. 5VDC CO 1 0M2 3002 Vc

A: Redraw the circuit diagram,

Q: 1+K 1.332/(S^3+4S^2+5S+2)=0 (i). Identify the characteristic equation.

A: The equation is given as:

Q: Describe in your own words with proper diagram and characteristics curve : why the application of a ...

A: P-type depletion type MOSFET is shown below: The relation between the output drain current and the ...

Q: 5 kW radar with 25 GHz frequency uses a single antenna with a gain of 20 dB. The receiver has noise ...

A: Write the given data,

Q: Evaluate the z-transform and Region of Convergence (ROC) for the following signals. Sketch the ROC, ...

A: On applying the z transform to the given sequence, The given sequence converges for all values of ...

Q: Show how a full adder can be implemented using a decoder.

A: Implementation of full adder using 3×8 decoder as follows Although truth table of full adder is is s...

Q: Question is on image

A: Click to see the answer

Q: QUESTION1: After the instructions 'MOV IE, #83H’ and 'MOV IP, #01H’ being executed, what interrupt s...

A: Once the instruction “MOV IE #83H” is executed. MSB enables all the interrupts. The IE register will...

Q: What is Thevenin equivalent circuit.?

A: According to the Thevenin’s theorem, any complex circuits which are linear can be converted into the...

Q: a. Find the equivalent impedance ZL shown inFigure P4.66(a), as seen by the source, if thefrequency ...

A: (a) Write the expression for the equivalent load impedance as seen by the source in the circuit (a).

Q: A current of 10 A rms flows when a single-phasecircuit is placed across a 220-V rms source. Thecurre...

A: Write the given values in the question.

Q: Open loop gain of an opamp is infinite. Use this statement to establish virtual short circuit in o...

A: For an ideal operational amplifier (opamp), the inverting and the non-inverting input terminals have...

Q: Determine the currents I1, I2, I3, I4, I5, and I6 for the electrical network shown below.

A: Let i1, i2, and i3 are the currents in the given direction in the loops starting from left. Write th...

Q: Question 3 on image

A: It is given that the input disturbance is constant. Consider the input disturbance is a unit step. T...

Q: The radiation resistance and the loss resistance of a pyramidal horn antenna are 50.55 ohm and 20.23...

A: The radiation efficiency of an antenna depends on the radiation resistance (Rr) and the loss resista...

Q: Please find the sequence of the image in correct form and then solve it.

A: Evaluating the value of the fault current for the single line to ground fault:

Q: Is it true?

A: Whenever the impedance is seen from the other side of the transformer it is given as: