Answered: (I) Calculate the terminal voltage for…

(I) Calculate the terminal voltage for a battery with aninternal resistance of 0.900Ω and an emf of 6.00 V whenthe battery is connected in series with (a) 71.0 Ωa resistor,and (b) 710Ω a resistor

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter23: Series And Parallel Circuits

Section: Chapter Questions

Problem 36A

See similar textbooks

Related questions

Q: A flashlight bulb rated at 2.0 W and 3.0 V is operated by a 9.0-V battery. To light the bulb at its…

A: The current across the bulb can be obtained as P=VbulbII=PVbulb=2.0 W3.0 V=0.67A

Q: Find io(t) in the circuit of Fig.8 when i,(t) = 10 sin 2t A. i,(1) 0.5 F Fig.8 2. ww

Q: The current through the 20-N resistor in Fig. 19–81 does not change whether the two switches S1 and…

A: Given: The current through 20 ohm does not change.

Q: The value of the voltage when t= 1 ms given that ws is 1500 rad/sec to

A: the values provided in the question are as follows- time =t= 1ms=10-3 ws = 1500 rad/sec to calculate…

Q: In the circuit shown, assume the battery emf is 16.2 V, R= 1.00 MN, and C = 3.20 µF. The switch is…

A: Given,Emf of the battery, E = 16.2 VResistance, = 1.00 MΩCapacitance, C = 3.20 Fswitch is closed…

Q: Can the terminal voltage of a battery ever exceed its emf?Explain.

A: emf of a cell is the potential difference across its terminal in open circuit. Terminal voltage of a…

Q: Given the circuit shown in Fig. 19–38, use the words "increases," "decreases," or "stays the same"…

A: (a) In the figure, resistor R7 is connected in the series with the circuit or other combinations.…

Q: (II) The capacitance of a portion of a circuit is to be reducedfrom 2900 pF to 1200 pF. What…

A: C1=2900 pFC=1200 pFx=Capacitor of unknown capacitance

Q: If you try and measure the voltage of a battery with a voltmeter connected in series, you won't get…

Q: (I) Calculate the current in the circuit of Fig. 19–53, and show that the sum of all the r= 2.0 2…

Q: (II) Electrocardiographs are often connected as shown in Fig. 19–68. The lead wires to the legs are…

A: Given: The time constant is 3.0 s. The capacitance is 3.0 μF.

Q: 1. In which circuits shown in Fig. 19–40 are resistors connected in series? (a) (b) w ww (c) (d)…

A: The resistances are treated as connected in series when the same current flows through the…

Q: Consider a capacitor C that is tully charged by a 10 V power supply. Loter on the resistor R, shown…

Q: (II) Three 1.7 -KΩ resistors can be connected together infour different ways, making combinations of…

A: The first case of the three resistors connected together in series combination. The net resistance…

Q: 2.23 In the circuit shown in Fig. 2.87, determine U, and the power absorbed by the 12-2 resistor.…

A: Calculation: Calculate the equivalent resistance between the 1.2 Ω, 8 Ω and 12 Ω resistors. Req1=1.2…

Q: Determine the equivalent resistance of the circuit shown, the voltage across each resistor, and the…

A: Given: Three resistance 750Ω, 680Ω, and 990Ω are connected with 12.0 V battery as shown in the…

Q: If The pot emtial aliff era ve nce bet wween the t of m electric motor Ls 245V is flowing.hrooth…

A: Given Potential difference between the terminals of electric motor V = 245 V Electric current I =…

Q: 24. (III) Consider the network of resistors shown in Fig. 19-52. Answer qualitatively: (a) What…

Q: (III) Suppose 2.0 MW is to arrive at a large shopping mallover two 0.100Ω lines. Estimate how much…

A: Given data: Input power, P=2 MW =2×106 W Equivalent resistance, R=0.100+0.100=0.200 Ω Voltage,…

Q: "If the time duration of power supply is increased, then the electrical energy will be (keeping…

Q: Two parallel plates, connected to a 40- V power supply, are separated by an air gap. How small can…

Q: + + - A В E F G H I (a) (b) (c) (d) Assume that all the light bulbs and batteries are identical.…

A: In series connection the bulbs are connected in such a manner of single path way for charge flow,…

Q: When two unknown resistors are connected in series with abattery, the battery delivers 225 W and…

Q: Different lamps might have batteries connected in either of the two arrangements shown in Fig.…

A: (a) here the two bulbs are connected in series, so the voltage to the bulb increases and the…

Q: For the circuit shown in Fig. 19–46, what happens when the switch S is closed? (a) Nothing. Current…

A: In a series RC circuit, when a DC voltage supply is applied to a discharged capacitor, the capacitor…

Q: Consider a circuit with three resistors, R1 = 225 Ω, R2 = 155 Ω, and R3 = 135 Ω, connected in…

A: Given: Three resistors, R1 = 225 Ω R2 = 155 Ω R3= 135 Ω, connected in parallel with a 24.0-V…

Q: Att= 0 the switch S is closed with the capacitor uncharged. If C = 20 µF, ɛ = 50 V, and R = 5.0 kN,…

Q: In the circuit of Fig. 6.83, i,(0) = 2 A. Determine %3D 60 io(t) and vo(t) for t > 0. 4e-21 V 3 H 3…

Q: As more resistors are added in series across a constant voltage source, the power supplied by the…

A: Given data: Resistors added in series Voltage source is constant

Q: Suppose you measure the terminal voltage of a 3.200-V lithium cell having an internal resistance of…

A: The terminal voltage is V=E-Ir where E= Emf, I= Current, and r= Internal Resistance.

Q: Suppose you measure the terminal voltage of a 1.6-V alkaline cell having an internal resistance of…

Q: Why is it more dangerous to turn on an electric appliancewhen you are standing outside in bare feet…

Q: Figure 19–44 shows three identical bulbs in a circuit. What happens to the brightness of bulb A if…

A: Redraw the circuit diagram when bulb B is replaced by the short circuit.

Question

(I) Calculate the terminal voltage for a battery with an
internal resistance of 0.900Ω and an emf of 6.00 V when
the battery is connected in series with (a) 71.0 Ωa resistor,
and (b) 710Ω a resistor

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

When the switch shown in Fig. 19–45 is closed, what willhappen to the voltage across resistor R1 It will(a) increase. (b) decrease. (c) stay the same
Suppose E = 10.0 V, R1 = 180 ohms, and R2 = 350 ohms. See attached. What value of R3 do we select so the battery supplies 24mA? I think first we convert latter, then...
Check Your Understanding Consider the electrical circuits in your home. Give at least two of circuits that must use a combination of series and parallel circuits to operate efficiently.
Check Your Understanding If you place a wire directly across the two terminal of a battery, effectively shorting out the terminals, the battery will begin to get hot. Wiry do you suppose this happens?
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?
Refer to Figure 10.17 and the discussion of lights dimming when a heavy appliance comes on. (a) Given the voltage source is 120 V, the wire resistance is 0.800 and the bulb is nominally 75.0 W, what power will the bulb dissipate if a total of 15.0 A passes through the wires when the motor comes on? Assume negligible change in bulb resistance, (b) What power is consumed by the motor?
As more resistors are added in series across a constant voltage source, the power supplied by the source decreases, why?
Suppose you wanted to discharge a C = 350 μF capacitor through a R = 350 Ω resistor down to 1.00% of its origional voltage. How much time would be required in seconds?
Using the exact exponential treatment, determine how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-MΩ resistor to 90.0% of its final voltage.
Two parallel plates, connected to a 40- V power supply, are separated by an air gap. How small can the gap be if the air is not to become conducting by exceeding its breakdown value of E= 4×10 V/m?
Can the terminal voltage of a battery ever exceed its emf?Explain.
Suppose you measure the terminal voltage of a 3.200-V lithium cell having an internal resistance of 5.00 Ω by placing a 1.00-kΩ voltmeter across its terminals. To see how close the measured terminal voltage is to the emf, calculate their ratio.