I need help answering these 3 parts. 1. The size description of an object on the print can best be described as dimensioning. TRUE or FALSE 2. The amount that any one dimension can vary is referred to as the tolerance. TRUE OR FALSE 3. While the MMC of a feature is important, for certain design calculations, it is important to also understand the LMC. TRUE or FALSE

Question

I need help answering these 3 parts.

1. The size description of an object on the print can best be described as dimensioning.

TRUE or FALSE

2. The amount that any one dimension can vary is referred to as the tolerance.

TRUE OR FALSE

3. While the MMC of a feature is important, for certain design calculations, it is important to also understand the LMC.

TRUE or FALSE

 

 

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Mechanical Engineering

Machine Design

Related Mechanical Engineering Q&A

Find answers to questions asked by students like you.

Q: An air-standard dual cycle has a compression ratio of 9.1 and displacement of Vd = 2.2 L. At the beg...

A: Part(a).Given:Compression ratio = 9.1Vd = 2.2LP1 = 95kPaT1 = 290KQtotal = 4.5kJ

Q: AS& Heat Transfer in Steam Heater Water at an average of 70°F is fiowing in a 2-in. steel pipe, sche...

A: Click to see the answer

Q: The 65 mm diameter A992 steel shaft is subjected to the torques shown where  T=900 N.m, Determine th...

A: Given:

Q: What forms of conservation laws apply to thisproblem? (Write out as well as you can)a. Conservation ...

A: Let above the liquid surface as point 1 and point 2 as just after the nozzle.

Q: Question 2 A propped cantlever beam in Figure Q2 is loaded by a triangularly distrnbuted load of max...

A: (2.1)For equilibrium conditions, determine the directions of reactions at points A (RA) and B (RB) a...

Q: Question 3 A Sign is supported by a pole of hollow circular cross section as shown in Figure Q3 The ...

A: Calculate the force due to wind.

Q: I need help solving problems 13, 14, and 15 pertaining to the print attached below.

A: Since we question only one question, we will answer the question no. 13. Please submit the question ...

Q: The jib crane is supported by a pin at C and rod AB. The rod can withstand a maximum tensionof 40 kN...

A: Consider the following free body diagram:Cx and Cy are the vertical and horizontal reactions are the...

Q: True or False: There is only one layout allowed in a drawing file.

A: The geometry of the object is created in the model space and the objects like dimensions, annotation...