If input power to Antenna is 100 mW, and Antenna Gain is +12dBi, calculate the transmit power of Antenna in dBm, and mW. If input power to Antenna is 29dBm, and Antenna Gain is +9dBi, calculate the transmit power of Antenna in dBm, and mW.

If input power to Antenna is 100 mW, and Antenna Gain is +12dBi, calculate the transmit power of Antenna in dBm, and mW. If input power to Antenna is 29dBm, and Antenna Gain is +9dBi, calculate the transmit power of Antenna in dBm, and mW.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 3. If the transmitted power is 18 watts, gain of the received and transmitted antennas are 10 dB…

A: The given information is, Determining the gains in normal form,

Q: What are the common problems encountered when using an outdoor antenna? Indoor antenna? What are the…

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…

Q: In a Long range microwave communication system operating at a 9GHz, the transmitting and receiving…

A: given data frequency = 9 GHz R = 10000 m Received power Pr = 10 uW transmitting power Pt = 10 W

Q: 4. Given a symmetrical line-of-sight communication link with a minimum detectable signal of -90 dBw,…

A: line of sight- A "line of sight" is a straight line along which one can see without obstruction.…

Q: For the 50-ft tower, what is the distance if the receiving antenna is at ground level? What if it is…

A: Given: Height of transmission tower, hT=50 ft Receiving antenna is at ground, hR=0 m

Q: Define and give the formula of an Effective area of the antenna with reference to gain?

Q: 2. Compute for the EIRP for a transmitting power of 30W and an antenna gain of 45 dB.

Q: Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and…

A: Given data, The value of the C is 8 dB, The value of I is 20 dB

Q: When the transmitter power is 5W and the communication frequency is 868MHZ, when the transmitter…

A: Transmitter Power, Pt = 5 W Communication Frequency, fc = 868 MHz Tx Antenna Gain, Gt = 1 Rx Antenna…

Q: What is the effective radiated power (ERP) of a repeater with 450 W transmitting power output, 4 dB…

A: It is given that: Transmitting power output=450 WFeedline loss=4 dBDuplexer loss=6 dBCirculator…

Q: Consider an array of four isotropic antennas located at a distance “a” from the center of a…

A: According to the question, consider an array of four isotropic antennas located at a distance “a”…

Q: In Microwave Communication link, two identical antenna operating at 10 GHz are used with power gain…

Q: The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and 20 dB…

A: Given C=8 db I=20 db Coupler is lossless, symmetric and directional

Q: Find out the field strength at 1 km away from a isotropic station of 1 kW power. Solution. The field…

A: Given data: The power radiated by the isotropic station is P=1 kW=1000 W. The distance from the…

Q: 1. What will happen if an antenna is not a part of the radio receiver circuit? 2. What is the effect…

A: As per our policy we can provide answer to first question only. A high frequency electricity is…

Q: How much error in the vertical position occurs if the GNSS antenna is mounted on a 2.25-m pole that…

A: Antenna: It is a device that used to transmit or receive radio or television signals. GNSS…

Q: - Determine the effective isotropic radiated power for an antenna with a directivity D = 43 dB, an…

A: Given Data: D = 43 dB efficiency = 75 % Pin = 50 W

Q: For an antenna system, the transmitted and the received powers are 50 W and 25 W respectively.…

A: For an antenna system, if Pt and Pr represent the transmitted and the received power by the…

Q: 6. Consider a directional antenna that has a gain of 10 dB and radiates 20 Watts. How much power an…

A: EIRP is used to measure the effective power in one direction from an ideal isotropic source. The…

Q: Find the length of Antenna used for transmitting and receiveing speech signal of 3,4 kHz modulated…

A: The solution can be achieved as follows.

Q: 2. WHAT Is THE OPERATING RANGE OF A DIPOLE AnTEnnA 15 GIVEN AS 3.8% of THE BIANOWIDTH OF A 36MHz?

A: We need to tell about the operating range of antenna .

Q: Discuss a good application of planar array antennas and why it's used.

Q: The antenna of transmitter device has been design with antenna gain 2dB transmits the power 500mw at…

A: We need to find received power for given system

Q: How large is the dish diameter that will be required for the dish antenna to produce 60 dB gain at…

A: The diameter of the dish antenna is directly related to the directive gain of the antenna. The…

Q: For a monopole antenna with linearclinear distribution, if the effective length of the monopole is…

A: The radiation resistance of a monopole antenna for linear current distribution can be expressed as…

Q: Compare between the narrowband antenna and broadband antenna.

A: Narrowband antenna covers the frequency range in between 300–3400 Hz whereas broadband antenna…

Q: determine the power at carrier of the antenna resistance one ohm (1 2) Write the AM equation with…

A: We need to calculate power at carrier frequency and modulated signal expression

Q: Define and explain the fundamental antenna parameters radiation density, radiation intensity,…

A: 1. Radiation density :- It is ratio of radiation energy per unit volume of the electromagnetic…

Q: In a microwave communication link, two identical antenna operating at 10GHz are used with power gain…

A: Given: Operating frequency, f = 10 GHz Gain of transmitter and receiver, Transmitted power, Range,…

Q: b) Determine the length of quarter-wave printed monopole antenna for 2.4 GHz, 5.8 GHz and 10 GHz.…

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…

Q: please do it correctly.. A system starts with omnidirectional transmit antennas. This produces a…

Q: In a microwave communication link, two identical antenna operating at 10 GHz are used with power…

A: According to Friis transmission equation, the received power can be expressed as

Q: Q4 / If 65 watts transmitter power is applied to a unity gain antenna with a 900 MHz carrier…

A: Following Data is given in the question Transmitted ower =60 W Carrier Frequency = 900 MHz…

Q: A) What will happen to a propagating signal when the interconnect has frequency-dependent losses?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What are the approximated sizes of a 8X8 antenna array at 60GHZ mmWave and in 6 GHz UWB?

A: we need to determine the antenna size for given frequencies.

Q: Calculating the sample power and fressnel zone radius at 50 Ohm receiver antenna impedance at 5km,…

Q: Consider an array of four isotropic antennas located at a distance "a" from the center of a…

A: According to the question, consider an array of four isotropic antennas located at a distance “a”…

Q: :Q2. Explain the following for the VHF :Frequency :Wavelength :Propagation Via

A: given VHF

Q: Impedance 600 400 200 -200 400 -600 Resistance Reactance -800 20 30 40 50 60 70 80 90 100 110 120…

A: It is given that the given impedance (characteristic) should be match with the coaxial cable…

Q: termine the radio horizon for a transmit antenna that is 100 ft high and a receiving antenna that is…

Q: 1. Determine the following; (a) What is the wavelength of an 800-MHz signal? (b) What is the…

Q: Discuss the Current challenges and solutions for those challenges in the design of modern antenna…

Q: If in a rectangular waveguide for which a = 2b, the cutoff frequency for TE02 %3D mode is12 GHz, the…

Q: Determine the ultrasonic propagation transit time if the sound velocity of the vapour in the tank is…

A: Given sound velocity of the vapour in the tank is 1500 m/s and the distance between the transmitter…

Q: For link to be maintained between a geosatellite and an earth station about 35,786 km apart,…

Q: What are the applications of planar array antennas?

Question

DO NOT COPY FROM OTHER WEBSITES

Correct and detailed answer will be Upvoted else downvoted. Thank you!

If input power to Antenna is 100 mW, and
Antenna Gain is +12dBi, calculate the transmit
power of Antenna in dBm, and mW.
If input power to Antenna is 29dBm, and Antenna
Gain is +9dBi, calculate the transmit power of
Antenna in dBm, and mW.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Define and give the formula of an Effective area of the antenna with reference to gain?
Consider a transmitter with height of 30 meters sending a signal at a frequency of 500Mhz towards a receiver of height 10 meter and at a distance of 20 km. If the median received power by a unity gain antenna at the receiver is -10 dB, find the power transmitted by the transmitter through an antenna of gain 10 dB.
A broadcast transmitter produces about 2.8 KW in the sidebands when modulated at a level of 75%.a.) how much carrier power does the transmitter have under those conditions?b. how much increase in antenna current would result by the 75% modulation if the antenna resistance is 50 ohms?
A mobile phone antenna with a gain of 2 dB transmits a 0.5 W signal to a base station with an antenna gain of 8 dB. Assume the minimum sensitivity of the receiving antenna to be Pr = -110 dBm. If the operating frequency is 700 MHz, what is the maximum allowed distance between the base station and the mobile phone?.
RF Engineering: For an antenna, how is dBi normally measured? Is it normally measured in an anechoic chamber?
What is the power density at a rangeof 6km radiated by a particular antenna ifits gain is 30dBd and transmitter poweroutput is 30W? (Gain must be withrespect to the isotropic radiator)
Consider a communication link with a geostationary satellite such that transmitter receiver separation is 30,000 km. Assume the same transmitter and receiver. If a 100-mili-watt transmitter at 4 GHz is used with transmitting and receiving antennas of 0.5-m2 effective area, what is the received power level in dBm? What implications does this power level have on the receiver design? With a land-mobile satellite terminal, the typical antenna gain is 10 dB or less. What does this imply about the data rates that may be supported by such a link?
Q5) In a superheteridyne receiver, what is the value of the IF frequency?
3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. Compute the bandwidth occupied by the signal, by using the conventional method and Carson’s rule. Sketch the spectrum of each signal, showing all significant sidebands and their exact amplitude.
Calculating the sample power and fressnel zone radius at 50 Ohm receiver antenna impedance at 5km, when the transmitter power is 5W and the communication frequency is 868MHZ and the transmitter antenna gain is 1 and the receiver antenna gain is 2? Calculating the electric field strength on the receiver side and the rms value of the voltage coming to the receiver input?
What is the bandwidth of a narrowband FM signal generated by a 2 kHz audio signal and 110 MHz FM carrier?