If a→-b→ = 2.4c→, a→+b→ = 2.1c→, and c→=1.9î+5.1ĵ, then what are (a) the x component of a→, (b) the y component of a→, (c) the x component of b→, and (d) the y component of b→?

If a→-b→ = 2.4c→, a→+b→ = 2.1c→, and c→=1.9î+5.1ĵ, then what are (a) the x component of a→, (b) the y component of a→, (c) the x component of b→, and (d) the y component of b→?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter9: Solids And Fluids

Section: Chapter Questions

Problem 4WUE

See similar textbooks

Related questions

Q: Consider air at P = 1.00 atm. The average molecular mass of air is approximately 29 u (atomic unit).…

Q: (II) What is the likely identity of a metal (see Table 10–1) if a sample has a mass of 63.5 g when…

A: Given that the mass in air is 63.5g and the mass in the water is 55.4g.

Q: indicate the following lattice points (211) , (111) and (1 0 1) in an orthorhombic lattice structure…

A: Representation of indices (211)

Q: What is a ⋅ b if a = 3i − j and b = 2i + j + 4k? Exactly one option must be correct) Top of Form…

A: Given; a=3i-j b=2i+j+4k Determine; The value of…

Q: A sample of pure gold has a mass of 15.8 g. Calculate the number of moles in the sample and gold…

Q: A crystal of a chemical sodium weighs 6.43g in air and 2.83g when immersed in a fluid having a…

Q: Which length better represents the size of molecules made of few (less than 10) atoms? Group of…

A: The maximum radius of an atom is about 105 times the radius of the nucleus which is R=10-15 m .Thus…

Q: An isolated LiCl molecule has its chloride ion (mass = 35 u) at x= 0 pm , and its lithium ion (7 u)…

A: Given data: Maas (m1) = 35 u at x1 = 0 pm Mass (m2) = 7 u at x2 = 202 pm Required: Centre of mass

Q: 4. A 5.00-g silver coin at 35.0°C drops 100.0 m to the ground. Assuming 70.0% of the change…

Q: A = 1.05i + 1j + 1.08k B = 0.98i + -0.81j + -0.92k What is the angle (in degrees) between the bonds…

Q: In the figure below, the actual mass of a piece of an alloy is 85 g (mass in air) and an apparent…

A: mass of an alloy in air (m) = 85 g apparent mass of alloy in water = 73 g

Q: 39) Which of the following formulas shows the Law of cosines? O A. c^2=a^2+b^2-4ac+cos A OB.…

A: According to cosine rule if two sides of the triangle (a and b) and angle (θ) between them is given…

Q: Archimedes’ principle can be used to calculate the density of a fluid as well as that of a solid.…

A: Given: The mass of iron is mFe=390 g. The apparent mass is mapp=350.5 g. Part (a) Write the…

Q: 1. is an example of a semiconductor material a. silicon b. gold c. silver d. carbon 2. Omar…

A: 1 ans:- a ) silicon :- silicon is a semiconductor. b) gold :- it is conductor…

Q: These are the densities of several materials: 1) Aluminum: 2.70 g/cm3 2) Benzene: 0.879 3) Copper:…

Q: One mole of 'nickel (6 × 1023 atoms) has a mass of 59 grams, and its density is 8.90 grams per cubic…

A: String stiffness of wire considering it as macroscopic

Q: A BCD O O O OWhich of the following terms is generally referred to both liquids and gases? A.…

A: Solution 1 :- Let us check the given options- Option A Colloid : A colloid is a type of solution in…

Q: cube 9.65 cm on each side is made of a metal alloy. After you drill a cylindrical hole 2.61 cm in…

Q: The active element of a certain laser is made of a glass rod 28.0 cm long and 1.80 cm in diameter.…

Q: molecule in air?(Consider Oxygen, Nitrogen, and carbon dioxide as diatomic molecule structure which…

A: kinetic energy of one molecule =f ×(1/2)kT k =boltzman's constant

Q: Please help me with all the parts in this question, there are multiple parts, double and triple…

Q: A cube 9.75 cm on each side is made of a metal alloy. After you drill a cylindrical hole 3.21 cm in…

Q: "In the methane molecule, CH4, each hydrogen atom is at a corner of a regular tetrahedron with the…

A: Let the two vectors corresponding to the adjacent C-H bonds be denoted by r1 and r2. Let the angle…

Q: Calculate the average density of the atmosphere, given that it extends to an altitude of 120 km.…

A: We are given,

Q: In solid KCI the smallest distance between the centers of a. potassium ion and a chloride ion is 314…

A: The crystalline structure of KCl is face-centred cubic. The total number of ions present in one unit…

Q: What is the average energy of vibration of the molecules in a solid if the temperature is T = hf…

A: The solid has three degrees of freedom. According to equipartition theorem, each degree of freedom…

Q: A comic book scenario: you've been given a 316 g sample of what is claimed to be vibranium taken…

A: Given Data : The mass of the vibranium sample is given as mv = 316 g. = 0.316 Kg…

Q: 88.0 g of carbon dioxide gas occupies a volume of 0.300 m3 when its temperature is 270 c. What is…

A: Given Mass of carbon dioxide is given as m=88.0 g Volume of the gas is V=0.3 m3 Temperature of the…

Q: A molecule (made up for this problem, so it may not actually exist in nature) has the chemical…

Q: A monoclinic lattice has the following unit cell dimensions: a = 5.00 A° , b =10.0 A° , c =8.00 A° ,…

A: A monoclinic lattice has the following unit cell dimensions: a6.12 A, b 7.05 Å, c = 4.21 Å, and B=…

Q: The coordinates of unit a, of the atoms in a body-centered cubic lattice are (0,0,0), (0,1,0),…

Q: Let's consider the three atoms composing the molecule now have different masses and coordinate,…

A: Given M1= 142.54 kg M2= 82.55 kg M3= 8 kg D1= (3,6) D2= (1,6) D3= (5,9)

Q: A proton, which is the nucleus of a hydrogen atom, can be modeled as a sphere with a diameter of 2.4…

A: It is given that,

Q: The active element of a certain laser is made of a glass rod 34.0 cm long and 1.30 cm in diameter.…

A: The expression for the increase in the length of the glass, ∆L=αL0∆T Substitute, ∆L=9×10-6…

Q: An irregularly shaped piece of metal of density 7.8g/cm3 weighs 429 grams when completely immersed…

A: Given values: Metal density, ρm=7.8 g/cm3ρm=7.8 g/cm3 Apparent mass of the metal in nitrobenzene,…

Q: There is relatively little space between atoms in solids and liquids, so that the average density of…

A: a)Density of nucleus is,

Q: A 19.3g mass of gold in the form of a cube is 1cm long on each side( somewhat smaller than a sugar…

Q: A cube 7.81 cm on each side is made of a metal alloy. After you drill a cylindrical hole 1.62 cm in…

Q: The following data was taken during an experiment with a sample of 0.7 kg. Analyze the data chart…

Q: Why is it valid to represent the structure of a crystalline solid by the structure of its unit cell?

A: Because in a crystalline solid these unit cell repeats itself to form the complete solid.

Q: Archimedes’ principle can be used to calculate the densityof a fluid as well as that of a solid.…

A: Given : Mass of iron when it is in air (M) = 390 g Apparent mass of iron when it is completely…

Q: These are the densities of several materials: 1) Aluminum: 2.70 g/cm3 2) Benzene: 0.879 3) Copper:…

A: Density=massvolume volume of cylinder =πr2h here r=5.7 cm h=0.79 cm so…

Q: The fundamental vibrational wavenumber ( ṽ) for 1H 127I molecule is 23096 cm-1 A. Determine the…

A: Given that, The vibrational wavenumber for 1H 127I molecule is 23096 cm-1 ν-1 = 23096 cm-1

Question

If a→-b→ = 2.4c→, a→+b→ = 2.1c→, and c→=1.9î+5.1ĵ, then what are (a) the x component of a→, (b) the y component of a→, (c) the x component of b→, and (d) the y component of b→?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Trending now

This is a popular solution!

Step by step

Solved in 7 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Why is it valid to represent the structure of a crystalline solid by the structure of its unit cell? What are the most important constraints in selecting a unit cell?
1.If 400 kg of methylated spirit occupies volume of 0.50 m, what is its density? a) 8 x102 kgm-3 b) 8 x10-2 kgm3 c)2 x10-2 kgm-3 d) 1.25 x10-3 kgm-3 2. A slice of bread is squeezed into a little ball. Which quantity does NOT change? a) mass b)volume c) density d) width 3. The relative density of brass is 8.4. Which of the following is the best statement that can be made? a) Brass is heavier than water. b) Water is heavier than brass. c) 100 cm of brass is heavier than 100 cm of water. d) 100 cm of water is heavier than 100 cm' of brass.
What is a ⋅ b if a = 3i − j and b = 2i + j + 4k? Exactly one option must be correct) Top of Form a) 3 b) 5 c) − 2 d) 0.4
In the methane molecule, CH4, each hydrogen atom is at a corner of a regular tetrahedron with the carbon atom at the center. In coordinates where one of the C-H bonds is in the direction of i + j + k (i-hat + j-hat + k-hat) an adjacent C-H bond is in the direction of i - j - k (i-hat minus j-hat minus k-hat). What is the angle between these two bonds? " a) 100 degrees b) 109 degrees c) 200 degrees d) 209 degrees
A crystal of a chemical sodium weighs 6.43g in air and 2.83g when immersed in a fluid having a specific gravity of 0.880. What is the density of this element?a. 1.5718g/cm3 b. 1.5623g/cm3 c. 1.5321g/cm3 d. 1.5410g/cm3
You are using a thin layer of epoxy to bond a Silicon chip to a pure aluminum plate that acts as a heat sink (epoxy layer 0.0200mm). The Silicon chip (k = 149.0 W/(m-K) is 0.200 mm thick, and has dimensions of 25.0mm by 25.0mm. The pure aluminum plate is 0.850cm thick, and has the same dimensions as the Silicon chip. The hot side of the silicon chip is measured to be 62.0°C; the cold side of the pure aluminum plate is measured to be 31.0°C. Assuming steady-state conduction (with the thin layer of epoxy acting as contact resistance, see Table 3.2.) determine the heat transfer rate through the chip. Do not add in an addition resistance due to the thickness of the epoxy layer, this has been incorporated into the contact resistance.
A monoclinic lattice has the following unit cell dimensions: a = 5.00 A° , b =10.0 A° , c =8.00 A° , and β = 110◦. Calculate the unit cell dimensions of the corresponding reciprocal lattice.
For a Wheatstone bridge with R1 = 432.1 Ω, R2 = 55.2 kΩ, and Rk = 6654.543 Ω, what is Rx ? For a Wheatstone bridge with R2 /R1 = 55, and Rk = 300Ω, what is Rx ?
Why is it valid to represent the structure of a crystalline solid by the structure of its unit cell?
why do they mix x component and y compenent together? i thought you have 2 separate equations one for x and y compenent?
The active element of a certain laser is made of a glass rod 34.0 cm long and 1.30 cm in diameter. Assume the average coefficient of linear expansion of the glass is equal to 9.00 10-6 (°C)−1. The temperature of the rod increases by 64.0°C. (a) What is the increase in its length? cm(b) What is the increase in its diameter? cm(c) What is the increase in its volume? cm3
The v = 0 to v = 1 vibrational transition of the HI molecule occurs at a frequency of 6.69 × 1013 Hz. The same transition for the NO molecule occurs at a frequency of 5.63 × 1013 Hz. Calculate (a) the effective force constant and (b) the amplitude of vibration for each molecule. (c) Explain why the force constant of the NO molecule is so much larger than that of the HI molecule.