Answered: In a pure Aloha network with G = 1/2,…

In a pure Aloha network with G = 1/2, how is the throughput affected in each of the following cases? a. G is increased to 1. b. G is decreased to 1/4.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 19VE

See similar textbooks

Related questions

Q: 8- A binary source sending x1 and x2 over BSC, if the probability of x1 is 0.4 and probability of…

Q: Consider a system using Go-Back-N protocol over fiber link with bandwidth 1 Gbps and packet size 512…

A: Introduction :

Q: If we now assume that K=10, RS = 100 Mbps, Rd= 100 Mbps, and R = 0.5 Gbps. What are the new…

A: answer : 1. Consider the given data The number of nodes K = 10 The capacity of link of the source…

Q: for a switching network. Calculate the total data times needed when the follow used: (a) Circuit…

A: The answer is

Q: In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a maximum…

A: Efficiency of ALOHA systems An ALOHA system is efficient if a certain percentage of all sent frames…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: . What is the theoretical capacity of a channel for the following case? Bandwidth = 1…

A: What is the theoretical capacity of a channel for the following case? Bandwidth =1MHz SNRdB=20

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: answer : According to above scenario, the point must be noted as, 1. each node transmit at constant…

Q: Calculate the spectral efficiency for an old 56K internet connection modem that can transfer 56,000…

A: To do: Calculate the spectral efficiency for an old 56K internet connection modem that can transfer…

Q: Consider an ethernet with length of the cable is 1800 meter and speed of the signal cable is 3 x…

A: The answer is...

Q: Let's say each user has a 500 kbps need and is online for just 25% of the time. With packet…

A: Answer:-

Q: A delivery truck takes five hours to go from Lubbock to Ft. Worth. It can carry 450 1TB SSDS. If we…

A: The solution for the above given solution is given below:

Q: On a given satellite link of a length 30 Kilometers, the bit rate is given to be 10 Mbps. Assuming…

A: Minimum frame size required = 2Tp*BW.

Q: nd stations. The altitu signal is 3 x 10$ m/s. zation of 50% for a sa - protocol? Assume th size and…

Q: explain and mention the difference between the following packet-switching using data gram and…

A: Step 1:- Packet-witching using datagram is also known as Datagram Packet Switching Packet-switching…

Q: consider a circuit-switched network that connects computers in two remote offices of a private…

A: Figure is provided in next step:

Q: If the signal at the end of a 6km cable has a power value of 2, if you knew that this cable loses…

A: Given length=6km loss=0.5dB/km

Q: Q) In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a…

A: Below I have fill the blanks of the given question:

Q: We have a 1000 m long 10 Mbps communication channel with ARQ protocol. The signal travels at a speed…

A: Automatic Repeat Query (ARQ) is also known as Automatic Repeat Request. In a two-way communication…

Q: tion, polling and token passing access methods perform on high and low

A: Introduction: Below the discuss how contention, polling and token passing access methods perform on…

Q: Consider a network which uses a frame size oT RRo send data on a 1.5 Mbps link with a one-way…

A: Given: Frame Size: 1KB Bandwidth: 1.5Mbps Utilization: 60% Solution:- Transmission delay = Frame…

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: Find the throughput of this system, expressed in terms of packet/slot

A: Formula for throughput for slotted ALOHA is S(threshold) = G*e^-G Where G is the number of…

Q: ) In pure ALOHA protocol the highest throughput is achived when G= and the channel can have a…

A: please check the solution below

Q: If there are x number of devices that are wanting to transmit during a slotted Aloha protocol, what…

A: ALOHA is a multiple access protocol for transmission of data via a shared network channel.

Q: A 1 Mbps link is used to transfer packets of each 10,000 bits long. This includes 500 bits header.…

A: The Answer is in Below Steps

Q: All links in the path between source and destination have a transmission rate of 10 Mbps. Assume…

Q: The Syldavia TGV is equipped with a computer network with CSMA/ CD-type access protocols. The signal…

A: Answer: I have given in brief explanation .

Q: A network with a bandwidth of 20 Mbps can theoretically pass only an average of 12,000 frames per…

A: Answer :-

Q: Design a MAC protocol for an access network where N nodes generate data continuously at a constant…

A: 1st is thar each node transmit at constant rate x bit/sec

Q: How can the effect of each issue 1) Delay Latency, 2) Network Jitter, and 3) Packt Loss be minimized…

A: Introduction: Here we are required to explain how can the effect of Delay Latency, 2) Network…

Q: When compared to conventional networks, throughput loss in wireless networks is much greater. I am…

A: Introduction: When compared to conventional networks, throughput loss in wireless networks is much…

Q: 16. Find the transfer function, G(s) = V.(s)/V;(s), for each network shown in Figure P2.3. [Section:…

Q: Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During…

A: Circuit Switching:- In circuit-switched networks, the resources needed along a path(buffers, link…

Q: Computer A, B C, D and E is arranged in a ring topology. Calculate the propagation delay of sending…

A: All workings are below Explanation: Detailed explanation:

Q: Consider an ethernet with length of the cable is 1800 meter and speed of the signal cable is 3 x…

A: The answer is

Q: Throughput loss in wireless networks is substantially higher than it is in traditional networks. I'm…

A: Introduction: Cabled network A network that uses physical wires and cables to link its computers is…

Q: In a slotted Aloha network with G = 1/2, how is the throughput affected in each of the following…

A: Throughput for slotted ALOHA: The throughput for slotted ALOHA is as follows: Here, G refers to the…

Q: There are 4 packets. Labelled as 1,2,3,4. Implement data gram switching technique on it

A: Datagram Packet switching: It is a packet switching technology in which packet is known as a…

Q: For UTP Cabling Properties of UTP Cabling : We have 8 wires , but we use only 4 wires , why?

A: UTP stands for Unshielded Twisted Pair, a 100-ohm copper cable, the most common and basic cabling…

Q: 1. A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps.What is the…

A: Throughput of PURE ALOHA is S = G X e-2G Here G is average number of frames generated during one…

Q: For example, let's say each user needs 500 kbps and is only active 25% of the time. In order to…

A: Multiplexing is a method of combining and transmitting several data streams over a single channel.…

Q: A signal in a network has a propagation velocity of 1.77x10' m/s and a delay of 4.3 us introduced by…

A: Given that, Velocity= 1.77*108m/s Delay of repeater= 4.3 * 10-6 sec Round trip delay including three…

Q: Parameters are more important for an industrial network compared to office automation networks: 1)…

A: Deterministic networking can be defined as the ability and the capability of the network to provide…

Q: Frames of 1000 bits are sent over a 106 bps duplex link between two hosts. The propagation time is…

A: Introduction :Given ,Frame size = 1000 bits link speed = 106 bps duplex linkpropagation time is 25…

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

In a pure Aloha network with G = 1/2, how is the throughput affected in each of the following cases? a. G is increased to 1. b. G is decreased to 1/4.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

In a slotted Aloha network with G = 1/2, how is the throughput affected in each of the following cases? a. G is increased to 1. b. G is decreased to 1/4.
Let's pretend every user has a need for 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate with a probability of at least 0.90 on a connection capable of 8 Mbps? What benefit does statistical multiplexing have in this case?
Take into account that each user needs 500 kbps and is only online for 25% of the time. Using packet switching, how many people can we accommodate on an 8 Mbps connection with a probability of at least 0.9? What is the statistical multiplexing benefit in this case?
From the IEEE Standard Notation, state the notation of each Ethernet System. For example, the notation 10Base-5 means 10-Mbps transmission rate, baseband mode of transmission, with a maximum segment length of 500 meters. Will give thumbs up after, thanks
When compared to conventional networks, throughput loss in wireless networks is much greater. I am curious as to the specific reasoning for this.
A factor in the delay of a store-and-forward packet-switching system is how long it takes to store and forward a packet through a switch. If switching time is 10 usec, is this likely to be a major factor in the response of a client-server system where the client is in New York and the server is in California? Assume the propagation speed in copper and fiber to be 2/3 the speed of light in vacuum.
Throughput loss in wireless networks is substantially higher than it is in traditional networks. I'm interested in the exact justification for this.
If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is going through it. If each station is theoretically given a capacity of5Mbpsand the number of stations in each LAN segment is equal, then the number of stations in each LAN is:
In a CSMA/CD network with a data rate of 10 Mbps, the minimum frame size is found to be 512 bits over maximum cable length 2500 m. what should be the maximum cable length if we increase the data rate to 100 Mbps?
As another example, consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation
Computer Science Consider the slotted ALOHA protocol with (N+M) devices. N devices transmit with access probability p, and the other M devices transmit with access probability q. Find the throughput of this system, expressed in terms of packet/slot. Explain your answer.
Computer Science Two flows are transmitting at a constant rate of 4Mbps and 8Mbps and compete for service at a 10Mbps link. If the link adopts an RED policy, what is the expected drop probability for each flow?