In a study of the drug release in a thin film solvent activated drug delivery system, the cumulative drug release % of Carbidopa at different times is shown in the below table. What was * ?the value of k used in that study Cumulative% drug release (Carbidopa) Time (Hr) 0.0 0.5 30 0.8 41 1.0 44 1.5 56 2.0 67 2.5 77 3.0 84 4.0 99

In a study of the drug release in a thin film solvent activated drug delivery system, the cumulative drug release % of Carbidopa at different times is shown in the below table. What was * ?the value of k used in that study Cumulative% drug release (Carbidopa) Time (Hr) 0.0 0.5 30 0.8 41 1.0 44 1.5 56 2.0 67 2.5 77 3.0 84 4.0 99

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter14: Chemical Equilibrium

Section: Chapter Questions

Problem 94AP

See similar textbooks

Similar questions

When ionic compounds crystallize from a supersaturated solution, the crystallization front that is, the barrier between the crystalline solid and the supersaturated solution typically travels at a constant speed through the solution until it reaches the boundaries of the system, then stops. What order of rate law is described by this behavior?
From the following data (ESSAY DPPH & METHANOL), make a graph of the adjusted model Concentration (x-axis) vs. % inhibition (y-axis), provide the equation that is given and explain its behavior in a broad way. Do this activity step by step please
The U.S. Federal Water Pollution Control Act P.L. 92-500,specifies legally acceptable methods for testing wastewater. The analysis of cyanide is performed according to the methods set out in the "Standard Methods for the Examination of Water Wastewater". This method indicates that it should be added prior to wastewater mercury chloride I (HgCl), to decompose the complex cyanides and thus be able to take a sample to perform the content analysis of cyanide. However, it should also be noted that the Illinois Pollution Control Board (IPCB) has established wastewater quality standards that limit the content of mercury (such as Hg) at 0.0005 ppm maximum in any effluent. A company that has a wastewater treatment plant applies 200 mg of mercury chloride per day before each cyanide analysis. a) Will this company comply with the maximum allowable limit of mercury according to the IPCB if discharges 100,000 gal/day of effluent and performs a daily cyanide analysis?
Given that CuBr would precipitate later than CuI in a solution containing equimolar concentrations of Br- and I-, it can be concluded that: A. Ksp,CuI < Ksp,CuBr B. Ksp,CuI > Ksp,CuBr C. Ksp,CuI = Ksp,CuBr D. Cannot be determined
The student then determined ΔH neutralization for the reaction of sodium hydroxide and acetic acid, using the procedure described in this module. The student added 100.0 mL of 0.8500M NaOH to 100.0 mL of 0.8404M acetic acid. Prior to and following the mixing of the acid and base solutions, the following temperature-time data were collected. g) Identify the limiting reagent and briefly explain why it is limiting. h) Find ΔH neutralization for the reaction.
(a) What are the units usually used to express the rates ofreactions occurring in solution? (b) As the temperatureincreases, does the reaction rate increase or decrease?(c) As a reaction proceeds, does the instantaneous reactionrate increase or decrease?
(a) Most commercial heterogeneous catalysts are extremelyfinely divided solid materials. Why is particle sizeimportant? (b) What role does adsorption play in the actionof a heterogeneous catalyst?
The first step in the heterogeneoushydrogenation of ethylene is adsorption of theethylene molecule on a metal surface. One proposed explanation for the “sticking” of ethylene to a metalsurface is the interaction of the electrons in the C—C π bond with vacant orbitals on the metal surface. (a) If thisnotion is correct, would ethane be expected to adsorb to a metal surface, and, if so, how strongly would ethane bindcompared to ethylene? (b) Based on its Lewis structure,would you expect ammonia to adsorb to a metal surfaceusing a similar explanation as for ethylene?
For the reduction 2FeCl3 + SnCl2 =====➔ 2 FeCl2 + SnCl4 in aqueous solution the following data were obtained at 25oC t(min) 1 3 7 11 40 Y 0.01434 0.02664 0.03612 0.04102 0.05058 Where y is the amount of FeCl3 reacted in moles per liter. The initial concentrations of SnCl3 and FeCl3 were respectively, 0.03125, 0.0625 moles/L. a.)Show that the reaction is third order (derive the rate law), and b.) calculate the average specific rate constant.
Which is true with distribution coefficient? A partitioning of a compound exist between a mixture of two immiscible phases at equilibrium It explains the process when species move from one phase to another phase in immicibel system It is used to predict the amount of solute that can be extracted from a solution during extraction All are correct Only I and II are correct Only III is correct none of the atatement is correct
Explain why scientists do not use a standard set of steps for everyinvestigation they conduct.
Potassium dichromate has several industrial applications. To determine the purity of the salt that will be used in different industrial processes, a sample mass equal to 2.660 g was dissolved and quantitatively transferred to a 500.00 mL flask. An aliquot of 25.00 mL of this solution was treated with excess KI and the released iodine was titrated with 0.1000 mol L-1 sodium thiosulfate, spending 27.00 mL. Calculate the purity of the analyzed salt. Data:K = 39.10 O = 16.00 Cr = 52.00 I = 126.9 S = 32.07