In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic voltmeter is 100 V. A short-circuit current measured at the same terminals by an ammeter of negligible resistance is 5A. If a load resistor of 802 is connected at the same terminals, then the current in the load resistance will be

In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic voltmeter is 100 V. A short-circuit current measured at the same terminals by an ammeter of negligible resistance is 5A. If a load resistor of 802 is connected at the same terminals, then the current in the load resistance will be

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.30P: Reconsider Problem 3.29. If Va,VbandVc are a negative-sequence set, how would the voltage and...

See similar textbooks

Similar questions

Explain the difference between cumulative- and differential-compounded connections.
In the network given in figure use nodal analysis to determine (a) the voltage at nodes 1 and 2, (b) the current in the j4 ohm inductance, (c) the current in the 5 ohm resistance, and (d) the magnitude of the active power dissipated in the 2.5 ohm resistance.
Write the application of extra super tension that have rating 132KV and what used for?
With no load attached, the voltage at the terminalsof a particular power supply is 50.8 V. When a 10-Wload is attached, the voltage drops to 49 V.a. Determine vS and RS for this nonideal source.b. What voltage would be measured at the terminalsin the presence of a 15- load resistor?c. How much current could be drawn from this powersupply under short-circuit conditions?
Electrical Engineering _ Energy Conversion Systems pls findthe question by using computer line. pls find fast.
The currents drawn by the receivers in a given network are given in the figure. Accordingly, active taking into account the current distribution, the point where the greatest voltage drop occurs, and Determine the distribution of the balancing currents in the arms, taking into account their directions.
In the circuit shown, convert to current-source conductive circuit and using node analysis determine the loadcurrents IA and IB.
Wiat is the difference between a real independent voltage source and an ideal independent voltage source? Give an example of a real voltage source and explain how it differs from the ideal.
Calculate the load current in mA shown in the circuit below
a) Explain the construction of LVDT. Identify some suitable examples according to their applications.b) Discuss contacting and non-contacting tachometers.
For the given circuit in Figure below, find the open circuit voltage VTH and the short circuit current IN across the terminal. then, find R TH by using the RTH=VTH/IN equation and find RTH with replacing voltage source with short circuit. Let’s assume we connect RL (load resistance) to the circuit between points A and B, what should be the value of RL in order to have max power transfer.
Electrical Engineering _ Energy Conversion Systems pls find the question by using computer line. pls find fast.