In this lab, you used rotary evaporation to remove the neutral organic solvent. Rotary evaporation is an example of a distillation except under conditions of a reduced pressure atmosphere. What effect does a reduction in atmospheric pressure have on the observed boiling point? Explain your answer.

In this lab, you used rotary evaporation to remove the neutral organic solvent. Rotary evaporation is an example of a distillation except under conditions of a reduced pressure atmosphere. What effect does a reduction in atmospheric pressure have on the observed boiling point? Explain your answer.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter85: Vacuum Distillation, Manometers

Section: Chapter Questions

Problem 2P

See similar textbooks

Related questions

Q: What should you do and not do when mixing the organic and aqueous phases during a liquid extraction?…

A: The amount of a substance that moves into the solvent depends on the interaction between substance…

Q: 4. Why is important to allow the saturated solution to cool down slowly during the…

A: Recrystallization is purification method. Solid substances are purified using Recrystallization…

Q: if you isolate more than one crop of crystal what must you do before combining them. (related to…

A: A widely adopted method in purifying compounds is recrystallization. In this method, the pure…

Q: How does the volume of a solvent affect the purity of the material in recrystallization?

Q: If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the…

A: The loss of water happening during the inital heating or during the second heating is not relevant

Q: When performing a distillation, the boiling point is measured: below the side arm of the distilling…

Q: 2-propanol and water are mixed in three different ratios in this experiment to test the effects of…

A: 1.) The ratio of given for propanol/H2O is 2:3 so we can assume the volume of propanol is 2x and…

Q: Give some reasons that would lead you to purify a liquid by using vacuum distillation rather than by…

A: Distillation under reduced pressure is called vacuum distillation and is generally employed for…

Q: . Any organic solvent waste generated in this experiment should be collected in your fume hood and…

A: Organic solvents may be Carcinogenic, Toxic, corrosive, radioactive material, explosive. If we…

Q: 8. Why should you boil the sample solution right before reaching the end point?

Q: During heating, some solution of NaCl splattered out of the evaporating dish. How would this affect…

A: Given: During heating, some solution of NaCl splattered out of the evaporating dish.

Q: 10. Describe how you can decide whether your recrystallized trphenylmethanol is pure or not ?

A: Triphenylmethanol is an organic white crystalline compound. It is insoluble in water and petroleum…

Q: Assume that charcoal and sugar are the two main impurities in the sample of benzoic acid. Explain…

A: Given is recrystallization of benxoic acid.

Q: What is an effective way of preventing irregular ebullition or bumping of the mixture during…

A: The question is based on the concept of experimental chemistry. we have to suggest an effective way…

Q: You were given a mixture of two miscible solvent A and B that you are tasked to separate. You know…

A: The mixture consist of two miscible solvent A and B which has different boiling points. Hence, the…

Q: How are solvents chosen for recrystallization? (single solvent or mixed-solvent system).

A: "Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: How can a fractionating column be prepared from a standard distillation column? Select one: Pack…

A: The fractionating column is fitted above the distillation flask containing the mixture of liquids to…

Q: Describe the temperature-composition diagram. What did you observe with the temperature of the vapor…

A: Type of chart used to show conditions at which thermodynamically distinct phases occur and coexist…

Q: To purify benzil crystals and get rid of any leftover traces of benzoin, what would be the best…

Q: Assume there is confusion as to the nature of a liquid that is being distilled off from 1,4…

Q: What are the criteria for a good recrystallization solvent?

A: Recrystallization refers to the phenomenon where solid compounds are purified. In the…

Q: Why is it necessary to allow enough time for your samples to dry?

A: during the organic synthesis, product may contain the impurity due the presence of the solvent

Q: Why is important to allow the saturated solution to cool down slowly during the recrystallization?

A: Recrystallization is most useful purification technique. It is used for purify solid compounds.

Q: What effect would the incomplete drying of a sample (e.g., the incomplete removal of a…

A: The melting point will be lowered and broadened.

Q: In general describe how a mixed solvent recrystalization works.

A: To do a mixed solvent crystallization, dissolve the solid to be crystallized in the smallest amount…

Q: What is the effect of an insoluble impurity, such as charcoal, on the observed melting point of a…

Q: Explain how these terms relate to ternay phase diagram Raffinate Solute Carrier Extract

A: Extraction is the process which is used to separate the components from the mixture. It is an…

Q: Why is the collection done through a 10% Na,CO, solution? Remove traces of acids or neutralizes the…

A: The alcohol functional group in a molecule is observed by the presence of -OH group. For example,…

Q: Based on your results, how does rate of crystal growth effect the purity of a recrystallized…

A: When the crystals of any compound are impure due to any reason. They can be recrystallized by the…

Q: Distillation Curve 110 100 90 80 70 60 50 40 20 40 60 100 120 Volume (drops) 13. Based from the…

A: Distillation is a technique in which the mixture of liquid can be separated.

Q: Use an apparatus similar to that shown and assume that the round-bottom flask holds 10 mL and that…

A: Given information: Volume of holdup = 12ml Pressure = 760 mmHg = 1 atm Boiling point = 100°C =…

Q: Outline three differences in the experimental set up between fractional distillation and steam…

A: Steam and Fractional distillation have different their principal and boiling point

Q: Draw a FIVE STEP Schematic diagram of the procedure on how to separate pure crystals of CuSO4 , Alum…

A: given- CuSO4 , Alum and Benzoic acid

Q: While determining the pressure during the Dumas experiment, if the barometric pressure reported were…

A: Given: The barometric pressure reported was lower than the actual vapour pressure in the Dumas…

Q: what is the freezing method on separating alcohol to the mixture and its step by step process

A: Separating Alcohol Through Freezing: Start with a liquid that is 5%-15% alcohol. You'll need a…

Q: surface contamination after cooling the acetanilide in the recrystallization experiment

Q: What are you looking for specifically when doing the microscale boiling point? What causes the…

A: A liquid boils when its vapour pressure equals to the atmospheric pressure. Boiling point of a…

Q: 2. During heating, some solution of NaCl spattered out of the evaporating dish. How would this…

A: The question is based on the concept of experimental chemistry. We have to evaluate the impact of…

Q: (i) Name any fraction, which is obtained higher up the distillation column than gas oil, and give…

A: The answer is attached-:

Q: While performing a crystallization, you obtain a light tan solution after dissolving your crude…

A: It is observed that a light tan solution is obtained and because of this, it is better to filter it…

Q: You are tasked with performing a recrystallization. You have 3 potential solvents to use, but you…

A: The solution is given below -

Q: what is the role of methanol for extracting chlorophyll? What molecular force holds your…

A: Chlorophyll is a fat soluble hydrophobic compound. Methanol is hydrophobic solvent. Methanol is a…

Q: Explain through a laboratory experiment: How is recrystallization of Acetone possible? Can it or how…

A: Recrystallization of acetone is almost not possible.

Q: While performing the Dumas experiment, if the outside of the flask were not completely dry (Part I),…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: When conducting a recrystallization what should generally be true when comparing the compounds…

A: Recrystallization is an experimental technique of separating pure compound from the solution…

Q: Draw a five-step Schematic diagram of the procedure on how to separate pure crystals of CuSO4 , Alum…

A: Answer - CuSO4 - Copper(II) sulfate, also known as copper sulphate, are the inorganic compounds…

Q: What properties should ideally be possessed by a recrystallization solvent?

Q: Based on your observations during our experiment, would water make a suitable solvent for the…

A: In the water, the solubility of fluoride ion is much higher than the solubility of benzoic acid. So,…

Q: Select the best solvent (only one) for the recrystallization of each compound (benzoic acid,…

A: Interpretation- To select the best solvent (only one) for the recrystallization of each compound…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Based on your observations during our experiment, would water make a suitable solvent for the recrystallization of benzoic acid that is significantly contaminated with fluorene using the method employed in our experiment? If not, suggest a technique that might be used to improve the outcome using water as the solvent. Simple and fractional distillation was the method used during the lab to purify substances and purified substance was separated from solvent using filtration.
Assume there is confusion as to the nature of a liquid that is being distilled off from 1,4 dimethoxybenzene. Describe a simple technique you could use to prove the nature of the substance being distilled off.
The method of extraction for Roman chamomile is: Choose one answer. a. cold-press extraction b. steam distillation c. water distillation d. solvent extraction
How are solvents chosen for recrystallization? (single solvent or mixed-solvent system).What are the properties of a good solvent system? How are crystals collected?
What is an effective way of preventing irregular ebullition or bumping of the mixture during distillation?
If 80% of a desired compound is extracted into the organic phase in each step (leaving 20% in the aqueous layer), how many extractions are necessary to ensure that at least 99% of the compound has been recovered in the organic phase? 1 extraction 2 extractions 3 extractions 4 extractions
Why can't a mixture of water and diethyl ether be used for recrystallization?
How does the volume of a solvent affect the purity of the material in recrystallization?
Look up the structures and melting points for acetanilide and salicylic acid.Predict whether the rate of cooling during a recrystallization process will have any effect on thepurity of the crystals formed.
When isolating the solid after recrystallization using vacuum filtration what solvent should you use to aid in the rinse from the Erlenmeyer flask to the vacuum filter funnel? (Only pick one answer) Group of answer choices: Cold ethyl acetate Cold ethanol Hot ethyl acetate Hot ethanol Hot water Cold water None of the above, it should not be risned
Why should the recrystallization solvent have a fairly low boiling point?
What is the problem with using a solvent with a very high boiling point for recrystallization?