It is well established that the thermal efficiency of a heat engine increases as the temperature TL at which heat is rejected from the heat engine decreases. In an effort to increase the efficiency of a power plant, somebody suggests refrigerating the cooling water before it enters the condenser, where heat rejection takes place. Would you be in favor of this idea? Why?

Q: If I know that the change in entropy of a system where heat was added is 30 J/K, and that the…

A:

Q: How much heat is needed to increase the internal energy of a gas in a piston by 4258 J if the gas…

A: Write the expression for the required heat.

Q: A system does 1.80×108 J of work while 7.50×108 J of heat transfer occurs to the environment. What…

A: Given :

Q: A sample of nitrogen gas undergoes the cyclic thermodynamic process shown in the figure. Which of…

A: Area enclosed by the curve gives the work done which will be given as follows:…

Q: The efficiency of an engine is 0.510.  For every 1.20 kJ of heat absorbed by the engine, how much…

A:

Q: What are the efficiencies of reversible heat engines operating between (a) the normal freezing and…

A: Given Data: (a) The freezing point of water is: TL=0°C=273 K The boiling point of water is:…

Q: How much heat transfer occurs from a system, if its internal energy decreased by 50 J while it was…

A: given that,Internal energy decreased:∆U=- 50 Jwork done:∆W=120 J

Q: A steam engine is operating at its theoretical maximum efficiency of 60%. If the waste heat has a…

A:

Q: 40) A certain heat engine extracts 1.30 kJ of heat from a hot temperature reservoir and discharges…

A:

Q: A steam engine is operated in a cold climate where the exhaust temperature is 0°C. (a) Calculate the…

A: (A)  The theoretical maximum efficiency of the engine is given by the following expression: η=1-TLTH…

Q: The 2nd Law of thermodynamics states that the change in internal energy of a system equals the net…

A: According to 2nd law of thermodynamics states that the change in internal energy of a system equals…

Q: How much heat transfer occurs to the environment per day by an electrical power station that uses…

A: Given: The total amount of heat transfer is 1.2×1014 J. The efficiency of the engine is 42%.…

Q: Shuk Yee and Jason add QH = 43 J to an ideal gas undergoing the process below. What is the thermal…

A: Efficiency(η) is the ratio of output heat/energy(Qo) to the input heat/energy(Qi). i.e. :- η=QoQi It…

Q: Due to design changes, the efficiency of an engine increases from 0.30 to 0.50. For the same heat…

A:

Q: 1.50 mol of an ideal gas with a constant ratio of heat capacities at constant pressure and volume y…

A:

Q: What is the amount of work that a Carnot engine can perform per kilocalorie of heat input if it…

A: Given: The source Temperature (T1) = 450 ⁰C = 723.15 K          The sink Temperature  (T2) = 182 ⁰C…

Q: A proposed ocean thermal-energy conversion (OTEC) system is a heat engine that would operate between…

A:

Q: A heat engine operates with sink temperature 25° with the efficiency of 30%. By how many kelvins…

A: Given: The engine operates with sink temperature 25oC when it have an efficiency of 30%. To find:…

Q: What is the maximum possible coeffcient of performance of a heat pump that brings energy from…

A: The relation between temperature in kelvin and the temperature in Celsius is: Convert the…

Q: A heat pump moves heat from the chilly 8°C air outside a house to the toastier 21°C air inside. The…

A:

Q: If a carnot engine operates between 35 degrees celcius to 76 degrees celcius. What is its thermal…

A:

Q: What does the Second Law of Thermodynamics say about how much work can be done by a heat engine?…

A:

Q: A food department is kept at 212°C by a refrigerator in an environment at 30°C. The total heat gain…

A:

Q: Two heat engines are operated in series so that part of the energy expelled from engine A is…

A:

Q: The inside of your refrigerator is approximately 0°C. Heat from the inside of your refrigerator is…

A:

Q: 9.The heat exhausted to the heat sink by a gasoline heat engine of a SUV is twice the mechanical…

A:

Q: An engine that has an efficiency of 25% takes in 200 J of heat during each cycle. If the engine…

A: heat absorbed in one cycle = 200 J Heat absorbed in 4 cycles = 200 * 4  = 800 joules Heat absorbed…

Q: A 67.5-kg person typically eats about 2250 kcal per day, 21.0% of which goes to mechanical energy…

A:

Q: . If an incandescent light bulb requires 100 units of potential energy to deliver only about 15…

A: Given , Bulb require 100 unit of potential energy to deliver only 15 units of kinetic energy ( in…

Q: What is the ideal efficiency of an automobile engine that operates between the temperatures 600C and…

A:

Q: If a heat engine performs 200 J or work while absorbing 1000 J of heat energy from the hot…

A: Given data The work performed by the heat engine is given as W = 200 J. The heat absorbed by the…

Q: In performing 154.0 J of work, an engine exhausts 65.0 J of heat. What is the efficiency of the…

A: The given values are, W=154.0 JQL=65.0 J

Q: A nuclear power plant operates at 75 % of its maximum theoretical (Carnot) efficiency between…

A:

Q: Is it theoretically possible to devise a heat engine which will create no thermal pollution?

A: Given:  heat engine with no pollution.

Q: A refrigerator works between temperatures TA = 105°C and TB = 5°C and has a quarter of the maximum…

A: Given:T1=105°C=378 KT2=5°C=278 Krate of work done Wt=30 watts

Q: What is the maximum efficiency of a heat engine operating between 68oF and 273 kelvins, the…

A: temperature T_1 =68 F =293.15Ktemperature T_2 =273 K   the maximum efficiency of a heat engine…

Q: A heat engine working between 230.0°C and 520.0°C, takes in 1.401 x 107 J of heat and delivers 4.100…

A:

Q: 32. A gasoline engine takes in 2500 J of the heat and delivers 500J of mechanical work per cycle.…

A: Please note : As per answering quidelines I can answer the first question(Q.32) only. Since this is…

Q: If the heat absorbed by any engine is 530.44 J and if the efficiency of this engine is 66%, then the…

A: Given Heat absorbed Q=530.44J Efficiency η=0.66

Q: Which of the following constitutes a very high efficiency for a useful, working heat engine? a) 200%…

A:

Q: An engineer must design a refrigerator that does 300 J of work per cycle to extract 2100 J of heat…

A: Write the variables with suitable value.

Q: Based on the zeroth law of thermodynamics, explain why a can of soft drink remains at a constant…

A:

Q: In a cyclic process, heat transfers are + 14.7 kJ, – 25.2 kJ, – 3.56 kJ and + 31.5 kJ. What is the…

A: we know that in a cyclic process  net change in internal energy will be zero. and net work will be…

Q: (2) lihäi The coefficient of performance of a heat pump that is removing heat from the cold outdoors…

A: