Question

i)Utilizing a  J-K flip-flop,  draw and make a four- bit asynchronous (ripple) binary counter

ii)Explain its(from i above) mode of operation and process through which it can be converted to decade counter 

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Digital Electronics

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Design a CMOS logic gate

A: Click to see the answer

Q: Show that the circuit  behaves as a bandpass filter.(Hint—find the transfer function for this circui...

A: (1) Calculate the feedback impedance.

Q: Now suppose the switch in the circuit in  has been inposition b for a long time. At t=0, the switch ...

A: It is given that capacitor is at position a for a long time therefore capacitor will be open circuit...

Q: How can the phase rotation of one alternator be changed in relationship to the other alternator?

A: Phase rotation: It is also called as phase sequence. It is the order in which the waveform of AC vol...

Q: Find the positive common-mode input voltage range for the differential amplifier as shown if VCC = V...

A: Given VCC = VEE = 15 V, RC = REE Calculating common mode input voltage gain

Q: a) Determine the overall current on the circuit with the mixer and crockpot operating. b) Determine ...

A: Click to see the answer

Q: Design the bandpass filter from using a cascade of a fourthorder low-pass Butterworth filter, a four...

A: The circuit diagram for the bandpass filter from using a cascade of a fourth-order low-pass Butterwo...

Q: In a transistor, Ic = 100 mA and If = 100.2 mA. The value of ß is . 1. 100 2. 50 3. about 1 4. 200 I...

A: Click to see the answer

Q: Q1.) The state diagram for a negative edge triggered counter is shown below. Sketch the correspondin...

A: Click to see the answer

Q: In the circuits , the Zener breakdownvoltages of the collector-base and emitter-basejunctions of the...

A: Circuit diagram is given as, Here, in the circuit the collector terminal and base terminal are conn...

Q: what is Special purpose transistors and drivers applications, types , uses disadvantages and advanta...

A: The transistor is a semiconductor device which amplifies switch electronic signals and electric powe...

Q: R1 R3 R4 R2 R5 ' 801 E=200V

A: To determine the power dissipated in the resistor R3 in the given circuit Given: R1 = 6 Ω R2 = 2 Ω ...

Q: Find the dimensions of arectangular box open at the top having volume of 32 m^3

A: Click to see the answer

Q: In the circuit shown below, S1 is opened and S2 is closed simultaneously. Determine (a) the frequenc...

A: Given data: The value of the capacitance is: 4.0 µF The value of the inductance is: 100 mH a) The ex...

Q: 1. 7.1 The switch in the circuit shown has been closed for a long time andis opened at t=0.4. d) Wha...

A: At t = 0- the inductor is short-circuited, the resistance 2 Ω is shorted thus the circuit reduces as...

Q: Enumerate different losses that take place in a loaded shunt motor.

A: There are different losses in dc loaded shunt motor. Armature resistance lasses. When armature curre...

Q: what is rms value of below signallll.

A: Given signal is -

Q: (a) Calculate the sensitivity of the closed-loop input resistance of the series-shunt feedback ampli...

A: a) Calculate the sensitivity of the closed loop input resistance of the series shunt feedback amplif...

Q: Hi, Fourier transforms of x(n) and h(n) signals are given below,  What is the y(n)=x(n)*h(n) ?

A: Click to see the answer

Q: Consider the following three phase balanced circuit. 21020° Vrms j0.5 N 24– j21 N 2102-120° Vrms j0....

A: Given: The given diagram is.

Q: An amplifier has an input resistance of 10 kΩ, an output resistance of 2 kΩ, and an open-circuit tra...

A: Given data, The value of input resistance is Ri = 10 kΩ. The value of output resistance is R0 = 2 k...

Q: What is the radiation resistance of half wave dipole antenna?

A: The radiation resistance of a radiating dipole antenna can be expressed as

Q: R1 = 22 kohm and R2 = 220 kohm in the amplifiercircuit as shown. (a) What is the outputvoltage if vi...

A: Since we only answer up to 3 sub-parts, we will answer the first 3.Please resubmit the question and ...

Q: A 120-V-rms 60-Hz sinusoidal voltage appears across a 500-turn coil. Determine the peak and rms valu...

A: Given:  f = 60 Hz; Erms = 120 V; N = 500 turns Calculate other parameters, The sinusoidal voltage a...

Q: Derive the expression for the current gain I2/I1 of the circuit in terms of the g parameters.

A: The voltage across ZL is: In g-parameters I1 and V2 are dependent on V1 and I2. The equation of V2 ...

Q: Please, I need to solve this question

A: given function F=A'C+AB'C'+B'C

Q: An op amp has a gain of 100 dB at dc and a unity-gain frequency of 5 MHz. What is fB? Write the tran...

A: The actual value of gain (A) is given by: The relation between unity gain frequency (fT), gain of t...

Q: In the above figure, a single line model of a three-phase power system is given. Base power 50MVA, b...

A: Click to see the answer

Q: A permanent-magnet dc motor has RA=0.5 Ω. With no load, it operates at 1070 rpm and draws 0.5 A from...

A: Click to see the answer

Q: What is the voltage gain of the common-emitter amplifier as shown?      Assume βF = 135, VCC = VEE =...

A: The voltage gain (AV) for a common emitter is: Where, The emitter current is “IE”, The Thermal volt...

Q: Draw the Basis logicdiam of adecimal to BCD Encoder

A: Click to see the answer

Q: Using the parts listed in TableP13.36 , design a single-op-amp differential amplifier having a nomin...

A: Differential amplifier with instrumentation quality

Q: A C-S amplifier is operating from a single 9-V supply. What is the maximum value of VGS −VT N that c...

A: Click to see the answer

Q: b. Calculate the output voltage,V, for the circuit shown in figure 4.

A: Click to see the answer

Q: Questions: 1 - why does the speed fall slightly when the d.c. shunt motor is loaded? 2- What is the ...

A: As per policy attempting only first question (1) (i) There are two different explanation for this qu...

Q: A 120-V, 10-A shunt generator has an armatureresistance of 0.6Ω . The shunt field current is 2 A.De...

A: Click to see the answer

Q: The input to an amplifier comes from a transducerthat can be represented by a 1-mV voltage source in...

A: Click to see the answer

Q: what does a sensor do?

A: The sensor means any equipment that computes physical input from its surroundings and changes it to ...

Q: For the RLC circuit shown below, Derive an expression for the transfer function VR(S) v(s) G(s) = Co...

A: Convert each element of the circuit in s domain, then Write Voltage divider rule and find VR(s),

Q: Draw the schematic for a four-input NAND gatewith a depletion-mode load device. What are theW/L rati...

A: Click to see the answer

Q: I need that Electromagnetic Theory questions solving. Thank you by now. I will be very please

A: Click to see the answer

Q: Number 63 and 64

A: We are authorized to do one question at a time so i am solving only question no 63.

Q: In a commercial resolver to digital converter the digital angle Φ is determined to be 20 degrees. Th...

A: Click to see the answer

Q: 1) Consider the circuit shown below of two cascaded high-pass filters. Vin o Vout R R a) Find the (c...

A: a) Calculating vx The expression for vout is given as,  

Q: With all explanation please

A: Butterworth filter: This is a type of filter which is having a flat frequency response in the passba...

Q: 14. Fin 2KL 5KA IKA 0-1uf 1OKA V. -Vo

A: Click to see the answer

Q: Sketch |F(ω)| versus ω when A=10 and τ=0.1. Hint: Remember that|F(ω)| is an even function of ω.

A: Given data: The amplitude of the given waveform A=10 The value of τ=0.1

Q: ppropriate circuit model and determine vC(0", 13 4KA

A: At t = 0­-, the circuit reduces as follows:  

Q: In the circuit shown, R=500Ω, L=0.64H, C=1 μF, and I=−1 A. Theinitial voltage drop across the capaci...

A: Click to see the answer

Q: For the RLC circuit shown below, Derive an expression for the transfer function G(s) =' VR(s) v(s) C...

A:   The expression for I(s) is given as, The given circuit is a series circuit, so the current is equ...