L=200m 25° Problem 1: A car having a mass of 1000 kg accelerates from 20 km/h to 80 km/h on a steep uphill road. The car travels 200 meters along the road during the acceleration. The slope of the road from horizontal is 25". Perform the following analysis: a. Find the change in kinetic energy of the car in kJ. b. Find the change in potential energy of the car in kJ.

L=200m 25° Problem 1: A car having a mass of 1000 kg accelerates from 20 km/h to 80 km/h on a steep uphill road. The car travels 200 meters along the road during the acceleration. The slope of the road from horizontal is 25". Perform the following analysis: a. Find the change in kinetic energy of the car in kJ. b. Find the change in potential energy of the car in kJ.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Water from a fire hose is directed horizontally against a wall at a rate of 500 g/s and a speed of 4.2 m/s. Calculate the force exerted on the wall, assuming the water’s horizontal momentum is reduced to zero.
An 80-kg block rests on a horizontal plane. Find the magnitude of the force P required to give the block an acceleration of 2.5m/s² to the right. The coefficient of kinetic friction between the block and the plane is μk = 0.25.
Water enters a large rigid tank steadily at a rate of V . = 0.5 m3/s, and exits through a large rectangular opening through which the velocity changes linearly in the vertical direction from 4 m/s to 5 m/s. Knowing that the tank is full, determine the magnitude of the velocity through the circular opening at the top whose diameter is D = 15 cm.
The 5-kg ball A revolves at a constant speed ? in a horizontal circle as shown in Figure Q2. If ? = 50° and ? = 7.9m. Explain how r and the mass of the ball should be adjusted if the speed of the ball is to be increased.
Shown in the figure below is a small decorative wheel fitted with flat paddles so the wheel turns about its axis when acted upon by a blown stream of air. Assuming that all the air in a 15-mm-diameter stream moving at 0.35 m/s strikes one paddle and is deflected by it at right angles, compute the force exerted on the wheel initially when it is stationary. The air has a density of 1.20 kg/m3 . The paddle is on a horizontal plane.
A particle travels along a straight line with an acceleration of a = (13 - .2s) m/s2 , where s is in meters. Determine the velocity of the particle when s = 10 m if v = 5 m/s at s = 0.
A 500 N block is resting on an inclined plane and is subjected to a constant force of 600N acting parallel to the inclined plane. After the block has moved 3 m from rest along the inclined plane the force 600N is removed. The inclined plane has a slope of three vertical to four horizontal. Coefficient of friction is 0.20 a. Which is the following gives the distance that the black will move further along the inclined plane until it will stop? b. Which of the following gives the velocity of the block when this for 600 Newton was removed? c. Which of the following gives the velocity of the block when it returns to its initial position?
an open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its own vertical axis at constant angular speed. what will be the depth of water (in meters) in the tank when it is brought to rest from an angular speed of 200 rpm.
The disk weighs 220 N and the bar weighs 110 N. The coefficients of friction between the disk and the inclined surface are μs = 0.6 and μk =0.5. What is the largest couple M that can be applied to the stationary disk without causing it to start rotating?
Consider the shaded area shown in (Figure 1). Suppose that a = 7 in. and b = 5 in. Determine the moment of inertia of the shaded area about the x-axis.
A 60-kg car accelerates 5 m down the incline from its resting position as shown in Figure 1. Given that VA = 2 m/s and the coefficient of kinetic friction along AC is µK = 0.2 (b) Calculate the time taken from A to B
1. Determine the velocity of the jet at A in m/s. 2. Determine the velocitv of the it at C in m/s 3. Determine the constant acceleration of the jet in m/s2