List the advantages of having one ignition coil percylinder.

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: Calculate the forces in the ribs of the Muslim shown in Figure (1) and are the ribs of the Muslim in…

A:

Q: True or False? The diesel fuel’s antiknock quality ismeasured by the cetane rating

A:

Q: A 3 3 B 100 N 3

A:

Q: A 15 m building use cast iron pipes in their piping system. The water tank located on the top of the…

A:

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

A: Given data: rc = 9 Need to determine the volume at state 2.

Q: Determine the magnitude of the pin force at A. Assume W = 675 lb, a = 2.7 ft, b = 2.0 ft, r = 9 in.…

A:

Q: A vertical pole consisting of a circular tubeof outer diameter 5 in. and inner diameter 4.5 in.…

A: Introduction: When external loads are applied to a beam, they must be limited in order to maintain…

Q: 4.An overhang beam is applied with a uniformly distributed load as shown in Figure Q4. a. Derive an…

A:

Q: H when losses are neglected. FIG. 9.41 jet, 9.22. Show that the locus of maximum points of the jet…

A: Write the expression of parabola. XX'=4YY'

Q: 1- Threshold shown in Figure (2), calculate the reactions in datums A, F a 1.5 m 1.5 m 450 N A A…

A:

Q: 10. A stream of 2 kg/s of CH, at 1.6 bar and and 140 K is compressed adiabatically to 50 bar and 400…

A: Given: The mass flow rate of methane, m = 2 kg/s The initial pressure of methane, P1 = 1.6 bar The…

Q: The piston of the hydraulic cylinder gives pin A a constant velocity v = 2.9 ft/sec in the direction…

A: The figure shows the piston of the hydraulic cylinder in which the piston moves with constant…

Q: Which of the following is probably not the cause of avibrating clutch?a. Excessive crankshaft end…

A: (a) Excessive crankshaft end play is cause of knocking sound when we use clutch. But Vibrating…

Q: Incorrect Question 6 What are the Miller indices for plane 2 in the image shown? -0.2 nm- (020)…

A: Given: Let us consider the given image, To find: The Miller indices for plane 2.

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

A:

Q: label the maximum and minimum ordinates. (Minimum ordinates are freque values.) 13 kN/m 4-m (2) (3)

A: Given as,

Q: An air-standard Otto cycle has a compression ratio of 9. At the beginning of compression, P1 = 100…

A:

Q: 30 kN 60% 1.0 m Find the reactions in datums A and B for the threshold shown in Figure 3. 3.0 m 125…

A: ◆ The roller support at B can resist only one vertical reaction. It is unable to resist horizontal…

Q: CALCULATIONS 4.1 Using the given pulley radius and the weight values, calculate the torque applied…

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub…

Q: The stagnation pressure and temperature at the entry of a nozzle are 5 bar and 500 K respectively.…

A: Introduction: Flow rates are affected by feed pressure and the viscosity of the sprayed liquid.…

Q: A household freezer operates in a room at 20°C. Heat must be transferred from the cold space at a…

A: Room temperature, TH=20oC=20+273=293 KCold space temperature, TL=-20oC=-20+273=253 KHeat transferred…

Q: Consider the portion of an excavator shown. At the instant under consideration, the hydraulic…

A: Given Velocity = 7 in/s Acceleration = 3 in/s2 Change in angle = 14 deg/sec = 14×π180=0.244 rad/s To…

Q: 3.1 figure 2 shows a cross-sectional view of an concrete dam wall. the width of the dam wall is 25…

A:

Q: or the given force on the following figure, write in vector form using the units vectors i ndj. FN =…

A:

Q: A 1- Threshold shown in Figure (2), calculate the reactions in datums A, F and E 1.5 m 1.5 m 450 N…

A:

Q: nciple of superposition and (a)find the possible values of r, (b) th =1kg, k=100 N/m, Y=0.2 m, and…

A: Given as,

Q: Suppose you are dropping five small pieces of clay randomly onto a board devided into squares (five…

A: Given:   To find: N= ?

Q: True or False? Disc brakes are not as likely to fadeduring heavy braking as are drum brakes.

A: Given data : Disc brake  Drum brake

Q: X 35 kPa 40 kPa 95 kPa

A: As stated in question, Stress along x-direction = σx = -95 kPa Stress along y-direction = σy = -35…

Q: The buildup of minerals and deposits inside the coolingsystem is called __ .a. organic soilb.…

A: Here we are talking about the types of contaminants

Q: The sprinter begins from rest at position A and accelerates along the track. If the stationary…

A:

Q: Part 1 Consider joint I. The Free-Body diagram is shown. All members are assumed to be in tension.…

A: Part 1: Concept: If three links are connecting at a point and out of which two links are collinear…

Q: 30% Fig-5 Fig-6 6. Find the value of 0 if the blocks A and B shown in Fig.6, have impending motion.…

A: Given-Information:- A = 20kgB = 20kg μA = μB = 0.25 To-Determine:- The value of q

Q: 100 kgs/min of water flows inside a copper tube (5 cm interior diameter) to be heated to a…

A:

Q: List five advantages the use of piezoelectric injectorshas over solenoid-based injectors.

A: Given Injectors To find Advantages of piezoelectric injectors over solenoid-based injectors

Q: The car is traveling at a speed of 58 mi/hr as it approaches point A. Beginning at A, the car…

A: Given:   VA = 58 mi/hr =58×52803600=85.07 ft/s Let Velocity at B = VB aA-B = 6.1 ft/s2 aB-C = 2.6…

Q: 5. A body of mass 10kg moving with a velocity of 1 m/s is acted upon by a force of 50N for two…

A: Given, Mass of the body = m = 10 kg Initial velocity of the body = u = 1 m/s Force acting on the…

Q: The moment of force P about point A shown in the figure is equal to P= 5N 2 m O 10 05 ..... The rope…

A:

Q: A steam turbine carrying a full load of 46 MW uses 77.7 kg/s of steam. The turbine efficiency is…

A: Given:  Turbine load = 46 MW ms = 77.7 kg/s of steam turbine efficiency = 78% exhausts steam…

Q: A mass on a spring is shown below. Let y(t) be the displacement of the spring as a function of time…

A:

Q: A fertilizer delivery system is shown in the figure. The hose is made of a material whose…

A: Solution: Given Data: CR=0.12d=25 mmD=30 mmR=1.3 mV=5.4 m/sη=75%SG=1.1h=10 m - 1.2 m = 8.8 m

Q: strength is non-vector quantity O vector and non-vector quantity 0 vector quantity O Not from the…

A: Given question: Strength is  non-vector quantity vector and non-vector quantity vector quantity not…

Q: At a certain location, wind is blowing steadily at 7 m/s. Determine the power generation potential…

A: Given that: Velocity of wind = 7 m/s Diameter of blade of wind turbine = 80 m It is required to…

Q: The velocity of a particle which moves along the s-axis is given by v = 17 + 2t7/6 where t is in…

A: Velocity, V=17+2t7/6at t=0; s=0t=5.1 s

Q: The throat diameter of a perfect venturi meter is 1.59 inches and is placed horizontally in a pipe…

A:

Q: What is the best way to lift a vehicle when preparingto remove an engine?a. Frame contact hoistb.…

A: Given Vehicle is lifted to remove an engine To find Best process for lifting vehicle

Q: a A Production Oil Company plans to run a 22,300-ft string of 47 lb/ft, P-110 grade, 7.625- in.…

A: Since you have posted multiple questions, I will answer the first question for you.

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

A:

Q: i. A shaft system ABCD consists of a solid bar BD and hollow bar AB is subjected to torque as shown…

A:

Hermetic Compressors

A compressor is a device that is used to increase the pressure of gas from low pressure to high pressure. The compressor is like a control volume, where in and out of mass occurs along with the interaction of energy with the surroundings in the form of heat and electricity.