Answered: MCQ: Which is the central node of…

Engineering

Computer Science

MCQ: Which is the central node of 802.11 wireless operations? a. WPA b. WAP c. Access Port d. Access Point

Comptia A+ Core 1 Exam: Guide To Computing Infrastructure (mindtap Course List)

10th Edition

ISBN:9780357108376

Author:Jean Andrews, Joy Dark, Jill West

Publisher:Jean Andrews, Joy Dark, Jill West

Chapter8: Network Infrastructure And Troubleshooting

Section: Chapter Questions

Problem 2TC

See similar textbooks

Related questions

Q: You know the IP address of the receiver but not the MAC address. What are you doing? Group of answer…

A: Answer to the above question is in step2.

Q: Lab computers connected to a layer 2 switch through Ethernet cables (star topology) Two computers in…

A: Lab computers connected to a layer 2 switch through Ethernet cables (star topology) Two computers in…

Q: Host A sends a UDP datagram containing 8880 bytes of user data to host B over an Ethernet LAN.…

A: Given Data:- Host A sends a UDP datagram containing 8880 bytes of user data to host B over an…

Q: Which term is best described as the practice of adding a device's physical address to a wireless…

A: Question is straight forward. We need to find the right option for the question.

Q: Which one of the following is the most popular data link layer connection used in wired networks? a.…

A: Data Link Layer is used in transferring the data between various nodes in network

Q: Task 1. Create VLAN’s, enable switchport mode, and assigning VLAN’s interfaces on each switch.…

A: You can logically partition a Local Area Network (LAN) into distinct broadcast domains using a…

Q: Which layer of the OSI Model handle flow control and error control. Which layer of the…

A: Note: As per policy, only first three parts are answered. The fourth layer: Transport Layer.

Q: Which of the following techniques in the execution phase of the NIST 800-115 standard identifies…

A: Answer: The following techniques in the execution phase of the NIST 800-115 standard identify…

Q: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

A: In a network, the local hosts are able to communicate only within the LAN, but are not able to…

Q: 78. What is the meaning of Bandwidth in Network? a. Transmission capacity of a communication…

A: Answer :

Q: Assume two packets arrive at the same time at two distinct input ports of a router. Assume that…

A: Introduction: The DHCP (Dynamic host configuration protocol) server distributes IP addresses to…

Q: You are an employee for Asianet Solutions, which is an ISP. Rickwell Infrastructures has hired…

A: VoIP is the voice-over-internet protocol used for calling via the internet, it has nothing to do…

Q: What is the fixed address registered in the network adapters that enable computers to connect to the…

A: Media Access Control (MAC) Address MAC address is a 48 bit address which is attached inside the…

Q: 02.15.1 network operates over short range, at low power. True/False ?.

A: 802.15.1 network focus on a low-power and short-range wireless standard to be optimized for devices…

Q: Which of the following device is used to connect two systems, especially if the systems use…

A: Please find the answer below

Q: Which of the following layer decide the transmission rate in a Network? a. Physical layer b. Data…

A: Here, There are many layers in networking with different working.

Q: What is the difference between forwarding and routing? Who is responsible to add entries in the…

A: Forwarding refers to a device sending a datagram to the next device in the path to the destination.…

Q: Your company has 2 routers. One router has 15 NICs and the other has 3. One network is shared…

A: IP Address: 128.0.0.0 Network Address: 128.0.0.0 Usable Host IP Range: 128.0.0.1 - 128.0.0.2…

Q: he network shown using Packet Tracer. Using the correct type of cables, connect all the network…

A: It is defined as a device that connects two or more packet-switched networks or subnetworks. It…

Q: Which of the following is a basic characteristic of the IP protocol? a. connectionless b. media…

A: Given Question Which of the following is a basic characteristic of the IP protocol? a.…

Q: Question 16 Select the appropriate response Which of the following wireless standards has the…

A: Total three questions are related to the networking and its protocals.

Q: q31- Which statement is true regarding packet-switched networks as opposed to circuit-switched…

A: Packet switching: In a network application, the hosts need to send data to one another over…

Q: How to answer this? MODULE 1 - NETWORKS TODAY1.0.5 Packet Tracer - Logical and Physical Mode…

A: GIVEN: How to answer this? MODULE 1 - NETWORKS TODAY1.0.5 Packet Tracer - Logical and Physical Mode…

Q: A manager intends to replace its current 100Base-T network to IEEE 802.11b standard. What important…

A: The important network aspects the manager should focus on is as follows:

Q: How to create subnet (5) in IPv6 network, using 2001:db8::132 host address

A: Create a VPC with a 10.0.0.0/16 CIDR block and associate an IPv6 CIDR block with the VPC. aws…

Q: In X.25 protocol, which of the following performs functions such as connection establishment,…

A: The following step provides the correct answer for the given question with an explanation.

Q: Q9 ) What is the summary route that should be configured on Router 2 so it can reach the LAN…

A: LAN connection is a collection of devices connected together in one location ,example…

Q: CSMA/CD is not adopted by wireless LAN (IEEE 802.11

A: CSMA/CD is not adopted by wireless LAN (IEEE 802.11)

Q: During the encapsulation process, what identifiers are added at the transport layer? Select one: A.…

A: When data arrives at the transport layer, the protocols at that layer begin the encapsulation…

Q: 1- Using the topology given in the Subnetting.pka file, divide the relevant network into subnets.…

A: Subnetting is the рrосess оf steаling bits frоm the HОST раrt оf аn IР аddress in…

Q: Description Assume that you are a network administrator at World University The University has four…

A: before going on how many IP will be wasted if we don't use VLSM technique first let us understand…

Q: On Cisco Packet tracer, how do I get a Gigabit connection to carry only certain VLANs

A: Cisco suggests that you know about the data in this segment. VLANs are a component to permit…

Q: 2. In SDN routers, the routing processor is responsible for communicating with the remote controller…

A: Disclaimer: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: How quickly can a cable customer get data if the rest of the network is inactive? Assume that the…

A: Data may be sent at a rate of up to 10 Megabits per second over a typical Ethernet network (10…

Q: The network with IP address 194.210.80.0 is wanted to be divided into 4 subnets. a- Find new subnet…

A: 194.210.80.0 belongs to class C address where # of network bits is 24 and # of host bits is 8. For…

Q: subnets and hosts a Class C network with the IP address

A: Given :- A Class C network with the IP address and mask of 192.168.10.0/29 is mention in the above…

Q: I NEED THE PACKET TRACER FILE I NEED THE PACKET TRACER FILE I NEED THE PACKET TRACER FILE I NEED THE…

A: The Answer start from step-2.

Q: Supposing you have a packet whose length is 1500 bytes,calculate the transmission delay for the…

A: In given question, we have to first check maximum transmission rate(i.e., Bandwidth) and then find…

Q: etermine the type of IEEE 802.11 standard used by modems available from Internet access providers.…

A: Types of IEEE 802.11 standard used by modem available from the Internet access providers 1. IEEE…

Q: The frame header for a wireless LAN, IEEE 802.11, has two address ‎fields 8_For slotted ALOHA, the…

A: The given information: The frame header for a wireless LAN, IEEE 802.11, has two address ‎fields…

Q: Which of the following devices modulates digital signals into analog signals that can be sent over…

A: Here, four options are given.

Q: You have successfully followed the cabling procedures for a new network connection at a primary…

A: Rollover cable is a cable which is used to connect the computer with the console port of the router.

Q: What are the typical causes of packet loss in a packet switched network? An application layer…

Q: Alex is required to provide information on how many people are using the network at any one time.…

A: In this question, we have asked which network from given options will enable Alex to provide…

Q: The data field of a UDP datagram is 8192 bytes. Use Ethernet to transmit. How many datagrams will be…

A: The total length of the datagram = 8192 + 8 (UDP header) = 8200 bytes Ethernet transmission, the IP…

Q: 14. (Single-choice) Based on the current IP transport network technology, the most important factor…

A: 14) Answer is a) device forwarding delay

Concept explainers

VLAN

VLAN stands for Virtual Local Area Network, and it is created from one or more local area networks. A Virtual Local Area Network (VLAN) is a customized network made up of one or more LANs. It allows a set of devices from different networks to be converted into a single logical network. As a result, a virtual LAN that is managed similarly to a physical LAN emerges.

Question

MCQ:

Which is the central node of 802.11 wireless operations?

	a.	WPA
	b.	WAP
	c.	Access Port
	d.	Access Point

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Why CSMA/CD is not adopted by wireless LAN (IEEE 802.11)? a. due to short length of messages b. due to the hidden terminal problem c. due to weak received signals (fading) d. both b. and c.
Riage's Repetitor O Which of the following is used to link networks? Equipment in a network o Router/Switch/Server/Bridge What format should an IP address take?
Which of the following device copies electrical signals from one Ethernet to another? a. hub b. bridge c. repeater d. passive hub
3) Which of the following devices can be used to connect computers and other end devices in a LAN? a. Router b. Server c. Repeater d. Switch
Which reason is not good for network segmentation? a. To limit access to broadcast domains b. To reduce bandwidth consumption c. To boost networking devices on a network d. To pinpoint network faults
q31- Which statement is true regarding packet-switched networks as opposed to circuit-switched networks? Select one: A. Connectionless. B. Less fault tolerance. C. Limited capacity. D. Provides single route.
What is a device called that takes in an Ethernet packet, checks the web addresses, and sends the packet again to another port with retained web addresses, but with a new MAC address?Group of answer options Router Server layer2 switch modem
Before data can be transmitted in packet switching, they must know ______ address to move on to next hop. IP OR MAC which will the asnwer with explantion pls thank you
Which term is best described as the practice of adding a device's physical address to a wireless router in order to either permit it or deny it access to the network? SSID Disabling Pre-shared Key WPS MAC Filtering
Q1. Which of the following is NOT a function of the data link layer? a) Create a frame of data for transmission between sender and receiver b) Identify which application on the receiving device should process the message c) Provide a way to check for errors during transmission d) Address the receiving device’s network port Q2. Which network device is most concerned with MAC addresses? a) Router b) Packet sniffer c) Web server d) Switch
How quickly can a cable customer get data if the rest of the network is inactive? Assume that the user interface is comprised of the following: (a) 10-Mbps Ethernet (a) Ethernet 100 Mbps (c) Wireless 54 Mbps.
1. You have finished physically installing an access point on the ceiling at your office. At a minimum, which parameter must be configured on the access point in order to allow a wireless client to operate on it? 2: A wing in the hospitals has request requested a solution using multiple WAPs for wireless access. What should be different on each WAP to prevent wireless problems but ensures good roaming and WAP transitions?