Question

A motor nameplate reads 230/460 volts, 30-15 amperes. When connected to a
460-volt supply, how much current will the motor draw fully loaded?

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Electrical Machines

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: What are the vulnerabilities do you see in EIGRP protocol? How one can mitigate that?

A: The EIGRP states for the Enhanced interior gateway routing protocol. It is the advanced routing prot...

Q: For a message signal m(t)= 2 cos 1000t + 8cos 2000πt, (a)Write analytical expressions for FM and PM ...

A: The given signal m (t) as expressed in the question,          Part (A):- To write the analytical ex...

Q: a-parameters impedances (complex Values)

A: Consider the frequency of this network is ω. The capacitive reactive is given by:

Q: A certain operational amplifier has an open-loop gain of 50 V/mV at low frequencies (note carefully ...

A: An open-loop gain of an operational amplifier is given by:

Q: in the attached photo

A: In the circuit shown above, the voltage source is directly connected with the inductor. The equation...

Q: A Y-Y three-phase system has a source of 380 V and a load of impedance of 6+j5 Ohm/phase through a t...

A: The given connection is a three-phase Y-Y balanced connection. The phase voltage for the star conne...

Q: introduce the Behav?or OF the system with transfer Func+ion on the S 5s+ 6s +1O plane c FPnd the pol...

A: As per our guidelines, we can only answer a single question at a time. Please resubmit the other que...

Q: Solve Parts (a),(b)&(c)

A: The given transfer function is, (a). Determining the natural frequency,  

Q: (a) Given VagTh) = 4 V and Ixon) = 4 mA at Vason) = 6 V, determine k and write the gen- eral express...

A: a). Determining the value of k, Writing the general expression for drain current,  

Q: Solve the following, if the radio wave transmitted at an angle of incidence 1.187radians, with a wav...

A: The given data of the radio wave having incidence angle 1.187 radians, with a wavelength of 6m. To d...

Q: Three-phase Circuits1- Explain in details the relation between phase and line voltages and currents ...

A: Since it is not mentioned in the question that which part has to solve so i am solving only first pa...

Q: The power semiconductor device requires protection against sudden rise in voltage and current, so th...

A: (i)  The main causes for the high rate of change of voltage across the device are as follows: 1-Inte...

Q: A coaxial cable has conductor dimensions of a=1.0mm and b=2.7mm. The inner conductor is supported by...

A: In every 2 cm cable, a 5 mm dielectric is present. Write the expression for the per unit length of d...

Q: Given circuit, find voltages VA and VB?

A: Click to see the answer

Q: (a) Given VGSTH) = 4 V and Ipxon) = 4 mA at Vas(on) = 6 V, determine k and write the gen- eral expre...

A: (a) Given values are =

Q: Unilateral Laplace transform given in figure Find y(t) and then find y(1).

A: Click to see the answer

Q: Q.7: For the coupled circuit shown, find the value of mutual inductance "M" and put the dots on the ...

A:                   Fig: Given circuit

Q: A 3-phase magnetic contactor rated at 400 A, 440 V possesses a relay coil connected to 2-phase of th...

A: First determine the per phase voltage of the magnetic contactor rate at 440 V.                 The ...

Q: A Y-Y three-phase system has a source of 380 V and a load of impedance of 6+j5 Ohm/phase through a t...

A: Click to see the answer

Q: 1. In free-space (µo, €o, No), H-field is defined as below. H = & sin y (H/m) (a) E-field in a phaso...

A: The H-field is defined as,     Here H0 =1 Part (A):- To calculate the electric field in a phasor fo...

Q: Find V1 and V2 using mesh analysis.

A: Click to see the answer

Q: Consider a unity-feedback control system whose open-loop transfer function is K G(s) s(s² + s + 0.5)...

A: A unity-feedback control system whose transfer function is,                                  

Q: Hi can you help me about this question? The figure shows a vehicle crash test simulation. Since the ...

A: (a) When the car is pushed a distance x(t) in the right direction. Write the expression for the forc...

Q: The instantaneous value of a voltage is u(t)=100√2sin(ωt +90o)V.Write it's phasor in an exponential ...

A: Click to see the answer

Q: B) The following diagram Shows and H-bridge, a circuit used to control the direction of DC Motors, C...

A: Find the diagram to control the direction of a DC motor,

Q: Electrical Engineering Question

A: Find the base current IB.

Q: The switch in the circuit has been open for a long time before closing at t = 0. Find i0(t) For t bi...

A: The circuit diagram is shown below The switch is open for a long time then it is closed. The value ...

Q: in the attached photo

A: Given values are = Given circuit is =

Q: Simplify the delta BCD (40 Ω, 16 Ω, and 8 Ω) in the bridge network in image  below using a delta-sta...

A: Click to see the answer

Q: Why use soill moisture sensor in electrical apparatus?!

A: Soil moisture sensor in the electrical apparatus is used to measure the moisture content of the soil...

Q: A sequential circuit with two D flip-flops A and B, two inputs, x and y ; and one output z is specif...

A: (a) Drawing the logic diagram for the circuit by the use of the Boolean algebra:

Q: The circuit is shown has been in operation for along time. At t=0 , the sourcevoltage suddenly drops...

A: The circuit diagram is shown below: For t<0, The capacitor can be replaced by the open circuit w...

Q: Given the circuit below with transistor β = ∞; VBE = 0.7V; diode forward bias voltage is 0.7 V. Find...

A: Click to see the answer

Q: For a parallel RLC circuit operating under initial conditions only: Give detailed discussion of diff...

A: Circuit for parallel RLC circuit with initial condition is =    

Q: 400 We consider the transfer function G(jw) = 2(jw)²+8(jw)+200 1. Determine the static gain K, the u...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: 1. Implement the following functions using: a. Mixing gates. b. NAND gates only. Fl=ABC+CD F2=AB +BC...

A: (a) Write the first function. Draw the logic circuit diagram using mixed gates as necessary.

Q: The switch s opens at t=0. Find the voltage uc!) across the capacitor C, if R, =1000 2, R, = 4 K2, u...

A: Click to see the answer

Q: 1. Is the north magnetic pole of the earth a north polarity or a south polarity?

A: Near the geographic South pole of our earth, the magnetic North pole is located. So, geographic Nort...

Q: a) For the circuit shown in Figure 1: 162 Vx 162 in + is )110 V 362 36Q V1 S120 V2 1032 ) 27 V ЗА 47...

A: Click to see the answer

Q: 3. Given: Ip(on) = 500 mA at VGs =10V, Vr = 1V, Rp = 1KQ , and Vpp = 18 V, Find: (a) Ip

A: Write the expression for the drain current in saturation region for MOSFET and calculate the constan...

Q: The control system shown in Figure (4) has two proportional gains p, and p2. In theory, the larg val...

A: Click to see the answer

Q: Mention the distance and frequency of type of radio waves approximately. Give the values only in the...

A: The given radio waves are briefly defined as: Space waves: These types of waves propagate in 20km of...

Q: Design an op-amp circuit with resistors not less than 10 kΩ that will produce an output voltage of ...

A: Click to see the answer

Q: Solve part (iv) , (v)

A: The circuit diagram is,

Q: What will be the truth table of 2 input NAND gate?

A: NAND gate comes in category of universal gate. It is basically the negation of AND gate.

Q: Electrical Engineering Question

A: Case 1: When RC = 3.3 kΩ. To draw the load line for output, apply the Kirchhoff’s voltage law in the...

Q: Infinite uniform line charges of 5 nC/m lie along the (positive and negative) x and y axes in free s...

A: The formula of the electric field at a distance L by infinite uniform line charge using Gauss law, ...

Q: A Y-Y three-phase system has a source of 380 V and a load of impedance of 6+j5 Ohm/phase through a t...

A: The Y-Y connection is shown below: The source voltage is given. The phase voltage for the star conn...

Q: An enhancement-mode n-channel MOSFET has gate-source threshold voltage VTR = +2V and source-drain co...

A: Circuit according to given data is =   Given values are =

Q: Find the active power (in kW) in the main network and in each branch and the apparent power (in kV A...

A: Click to see the answer