Question

Y parameter

Practice Problem 19.4
Obtain the y parameters for the circuit in Fig. 19.19
6Ω
2Ω
Answer: y11 0.625 S, y12= -0.125 S, y21 0375 S, y22 0.125 S
3Q
2ig
19.4
Hybrid Parameters
Expand
Transcribed Image Text

Practice Problem 19.4 Obtain the y parameters for the circuit in Fig. 19.19 6Ω 2Ω Answer: y11 0.625 S, y12= -0.125 S, y21 0375 S, y22 0.125 S 3Q 2ig 19.4 Hybrid Parameters

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Article 300 The is defined as the area between the top of direct-burial and the finished grade. a. N...

A: Direct burial cable is a kind of cable which is designed to be buried under the ground without the e...

Q: How was the value of the capacitor derived?

A: Click to see the answer

Q: can you please explain what a supernode is, how do I apply it in this question.

A: To find the value of V1 and V2 by super-node concept in the given circuit:

Q: A 230-kV, three-phase transmission line has a per phase series impedance of .... (please see attache...

A: We only answer the first three parts of a question on this platform, unless specified otherwise. Sin...

Q: Also show that the power balance is achieved

A: In the given circuit, apply Kirchhoff’s current law at node Vx as follows,

Q: 1. For the following functions: calculate the unisided Laplace transform; determine the poles for La...

A: For any continuous time function x(t), the unisided Laplace Transform is expressed by equation (1). ...

Q: 3. For the following circuit determine (include and show all the steps): (4 marks) a. Total impedanc...

A: consider that the total impedance of the circuit is Z.

Q: Please help with A,B and C. Also, please make it legible sometimes it's too small so it's blurry.

A: As referenced, Gain should be in term of input and output resistance also.In this way, drawing an in...

Q: Airframe Electrical System Question: Name 10 wire insulation characteristics that must be considered...

A: Ten wire insulation characteristics that must be considered when selecting the best wire insulation ...

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: A single phase transmission line has two parallel conductors 1·5 metres apart, the diameter of each ...

A: Given,The spacing between the two parallel conductors is,

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: What is the force on an electron in an electric field of 5000 N/C?

A: Formula to find the Force of an electron in an electric field is given below.

Q: Explain how to use the ohmmeter portion of a VOM

A: A VOM(volt-ohm-milliammeter) is also known as multimeter. It is used to measure voltage, current and...

Q: The transfer function H(f) = Vout/Vin of a filter is shown in Figure P3. The input signalis given by...

A: For steady-state output of the filter for an any sinusoidal input signal having a filter transfer fu...

Q: Branch-circuit overcurrent protection devces are not required to be accessible to occupants of guest...

A: According to Article 240 (Overcurrent Protection) of National Electrical Code (NEC), each occupant r...

Q: Airframe Electrical System What is minimum number of conductor strands required in aircraft quality ...

A: Carbon steel or corrosion resistant steel wire are generally used in manufacturing of the aircraft c...

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A: STEP BY STEP METHOD:From the circuit, write the expression for io(t) as follows:

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: Given,The length is 15 km.The inductive reactance is,

Q: Question is screenshotted below: Table 2:  Resistor Value R1 3kOHM R2 1kOHM R3 2.5kOHM R4...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: Airframe Electrical What are the three connector contact densities?

A: Electrical connector is a device which is used to connect conductors of different wires. Electrical ...

Q: Methodology about cctv surveillance system

A: Shut circuit TV (CCTV), otherwise called video observation is the utilization of camcorders to trans...

Q: uunection current 0.5mA is to be used. 02: a) Derive the equations of balance for Hay bridge to dete...

A: Hay bridge is a modified version of Maxwell\'s bridge and the circuit diagram is given below 

Q: Exercise 4.3.2: Inverting amplifier. About The inverting-amplifier circuit shown below uses a resist...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: explain in detail aplease

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: Find out the electric field strength at 60 km away from a transmitting station of 35 kW power.

A: Electric field strength will be : 

Q: Please help with B,C, and D. Also, please make it legiable sometimes it's too small so it's blurry.

A: The internal circuit diagram for an inverting OP-amp (pratical OP-amp) is  drawn in the figure.

Q: In an n type semiconductor at T 300 K, the electron concentration varies linearly from 1017 to 3 x 1...

A: The mathematical expression for the diffusion current density due to diffusion of electrons in a n-t...

Q: Resistor Value R1 3kOHM R2 1kOHM R3 2.5kOHM R4 2.0kOHM  Table 2   Please answer second qu...

A: Considering the circuit number two,

Q: Two parts to this question, please answer both. Thank you. Assume that even though the supply voltag...

A: The given circuit is redrawn as shown in Figure 1.

Q: A substation receives 6000 kVA at 6 kV, 0.8 p.f. lagging on low voltage side of a transformer from a...

A: The single line diagram of the system is shown below:

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: Article 300 cable or nonmetallic raceway-type wiring methods installed in a groove, to be covered by...

A: cable or nonmetallic raceway-type wiring methods installed in a groove, to be covered by wallboard, ...

Q: These are two parts to the ONE problem. The number 2 is just a follow up question.

A: Figure 1 shows the Thevenin resistance at the terminals a-b. (By removing load resistor and current ...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

Q: A. The modified equivalent circuit of a transformer is given in the following figure. X2 х, N N2 R2 ...

A: For Transformer-Primary MMF = secondary MMF

Q: 3.40 Find Vi and V in the circuit shown in Figure P340. FIGURE P3.40 2 kn R2 V2 4 kn 2000 i 5 V 3 kn...

A: Consider the given circuit,

Q: What is the time constant for a 47 H inductor in series with a 470 Ω resistor? Part 1. (a) What is ...

A: Given Data: The value of inductor (L) is 47 H.The value of resistance of a resistor (R) is 470 ohms....

Q: 1. FIGURE 52 shows the one-line diagram of a simple three-bus power system with generation at bus I....

A: Convert the line impedances into admittances, using Y=1/Z 

Q: 1._____ must not be installed beneath openings through which materials may be moved, such as opening...

A: Article NEC 225.19 (D) (3) shows ‘Building Openings’ states that, the overhead branch-circuit and fe...

Q: for the fig2.24 find (a) R and (b) the power supplied by the 250V source

A: Mark the branches with their currents and nodes-

Q: Find out the expression of the output voltage.  Refer to the following diagram for the same.

A:  Given circuit diagram is shown below,

Q: Find out the Electric field strength 90 km away from a transmitting antenna transmitting 50 kW power...

A: Write the expression to find the electric field strength at a point from a transmitting antenna as f...

Q: A plane electromagnetic wave is having a frequency of 20 MHz. If the value of relative permitivity a...

A: Velocity (V)  of a plane wave in a lossless medium can be expressed in the following way:

Q: A signal is sampled at Nyquist's rate. This will ensure that the analog signal can be recovered from...

A: According to Nyquist’s sampling theorem, a signal can be recovered from its samples without any loss...

Q: If a 100-Ω resistor is connected across the terminals of a 12-V battery, how much is the current, I?

A: To find the value of current in resistor with the value of resistance 100Ω and a voltage of 12V appl...

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

Q: 2.18 Given the circuit shown in Fig. P2.18, find da soivsott Bo elsaim beicluder o lu a) the value o...

A: PSPICE Simulation:Draw the circuit diagram in PSPICE as shown in Figure 1.

Q: Service-drop conductors must have a minimum of __ vertical clearance from final grade over residenti...

A: Service drop conductors is used to transfer electric power to consumers. These conductors must be ab...