Question

Predict the product obtained when 1-pentyne reacts with NaNH2 in NH3 followed by MeI

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Science
Chemistry

General Chemistry

Related Chemistry Q&A

Find answers to questions asked by students like you.

Q: What is the pH of a 0.22M NaH2PO4 solution?

A: NaH2PO4 is a weak.Ka for NaH2PO4 is 6.23×10-8.Calculate concentration of H3O+:

Q: Draw the major organic product of the indicated reaction conditions. Be sure to clearly depict the g...

A: Click to see the answer

Q: The exclusion principle is sometimes described as the quantum version of the principle that no two o...

A: This description is appropriate.

Q: What are some ways to visualize a TLC plate? Why may it be necessary to have more than one method to...

A: TLC works on the basic principle of separation of compounds based on the interaction of the sample w...

Q: Naturally occurring titanium exists as five stable isotopes. Four of the isotopes are: 46Ti with a m...

A: The mass of the fifth isotope of titanium can be calculated as

Q: The gap between valence and conduction bands in silicon is 1.12 eV. A nickel nucleus in an excited s...

A: Given, the energy gap between the valence and conduction band is 1.12eV and the wavelength of the ga...

Q: During a physicsn experiment, an electron is accelerated to 93% of the speed of light.What is the sp...

A: 1 m/s = 2.237 mi/hr

Q: How do I solve number 3? I found the average.

A: Actual value = 30 mLMean value = 29.977 mL

Q: What is Henry’s law? For what kinds of calculations is Henry’s law useful?

A: According to Henry’s law, the solubility of a gas is directly proportional to the partial pressure o...

Q: A sample of solid NH4NO3 was placed in an evacuated container and then heated so that it decomposed ...

A: A sample of solid NH4NO3 was placed in an evacuated container and then heated so that it decomposed ...

Q: Show by 2 net ionic equations how NaHCO3 may act as a buffer.

A: Click to see the answer

Q: 1. Which substance below would you predict to most readily enter the gas phase from the liquid phase...

A: The lower the boiling point of the compound, most readily enters into gas phase from liquid phase.Th...

Q: The following questions refer to the equilibrium shown here: 4NH3(g) + 5O2(g)  4NO(g) + 6H2O(g)What ...

A: According to Le chatelier’s principle, the equilibrium will be shifted in such a manner in order to ...

Q: Fory Liters (40 L) of a gas were collected over water when the barometer read 622.0 mm Hg and the te...

A: 1 mm Hg = 133.322 PaTherefore 622 mm Hg = 622 x 133.322 Pa = 82926.2 PaVapor pressure of water at 20...

Q: You are considering purchasing a new NMR instrument so that you can do H1 NMR. Suppose one instrumen...

A: The energy difference (ΔE) in the spin states under the external magnetic field (Bo) can be calculat...

Q: What does it mean to say that a substance is soluble in another substance? Which units are used in r...

A: What is meant by a substance soluble in another substance is to be explained. The units that are use...

Q: Is this the correct synthesis of the proposed reaction?

A: Based on the given reaction, all the steps seems to be fine except the oxidation of methyl group to ...

Q: A bottle of sodium hydroxide (NaOH) was found to contain 1.23 lb of this chemical. Express the amoun...

A: The conversion factor can be described as the numerical factor that is used to convert one set of un...

Q: Lithium iodide has a lattice energy of −7.3 × 102(kJ/mol) and a heat of hydration of −793 kJ/mol. Fi...

A: Given that the lattice energy of lithium iodide is -7.3×102 k J/mol and a heat of hydration of -793 ...

Q: True or false? During one half-life, the mass of a radioisotope is reduced by half. Explain.

A: Click to see the answer

Q: Which of the following is false and WHY? a) an orbital can accommodate at most 2 electrons b) orbita...

A: (a)According Pauli Exclusion Principle, no two electrons should not have same four quantum numbers i...

Q: please find attachment.

A: 13.Chiral carbon is said to the carbon attached to four different groups.  The molecule is said to b...

Q: Explain how the relative strengths of solute–solute interactions, solvent–solvent interactions, and ...

A: Salvation is the process of interaction of solvent particle with solute particle which assist the st...

Q: The half‑equivalence point of a titration occurs half way to the equivalence point, where half of th...

A: Given that,Number of moles of monoprotic weak acid = 0.34 molesKa of monoprotic weak acid = 6.3×10-5

Q: Calculate the wt% of a 2.50m Pb(NO3)2 aqueous solution.

A: The molality of the solution can be described as the ratio of moles of substance to the mass of the ...

Q: Calculate the solubility of argon in water at an atmospheric pressure of 0.360 atm (a typical value ...

A: Atmospheric pressure is 0.360atm.From the table mole fraction of argon is 9.34×10-3.

Q: Determine the number of atoms of each element in the empirical formula of a compound with the follow...

A: The molar mass of carbon is 12.01 g/mol and the mass of carbon is 54.95 g. The moles of carbon is ca...

Q: The volume of a unit cell of diamond is 0.0454 nm^3 and the density of diamond is 3.52g/cm^3 Find th...

A: 1 nm3 = 10-21 cm3

Q: I know how to get the answers I just do not know how it wants me to type it in?

A: Given information:Atoms of Co is 2.26×1024Mole of F is 7.70

Q: What are the important diagnostic peaks in this IR spectra? Fingerprint region <1500cm^-1 is not ...

A: The important diagnostic peaks in given IR spectra is given in step two.

Q: Calculate the pH of a solution which is 0.50 M in HA (a weak acid) and 0.80M in NaA. (Ka for HA = 3....

A: Henderson-Hasselbalch equation explains the relationship between pH of solution and pKa of acid for ...

Q: The solubility product (Ksp) of Ca3(PO4)2 is 1.3 ×10. In a 0.02 M solution of Ca(NO3)2, the solubili...

A: The dissociation of Ca3(PO4)2 in the given calcium nitrate solution occurs as,

Q: Polonium crystallizes with a simple cubic structure. It has a density of 9.3 g/cm3, a radius of 167 ...

A: Given data:

Q: Why would you add a piece of filter paper to your TLC developing beaker (jar)?

A: Click to see the answer

Q: 16-15. Use both the van der Waals and the Redlich-Kwong equations to calculate the molar volume of C...

A: Given the temperature(T) and pressure are 200 K and 1000 bar,The critical properties of carbon monox...

Q: Given the equation 2A(g)  2B(g) + C(g). At a particular temperature, K = 1.6 × 104.If you mixed 5.0 ...

A: The given reaction is as follows,

Q: a 9.48 kg sample of steel contains 0.08058kg og carbon and 0.1896kg of manganese. How many kg of mag...

A: A 9.48 kg sample of steel contains 0.08058 kg of carbon and 0.1896 kg of manganese. The mass of mang...

Q: How do you answer 13, 14, and 15?

A: Conversion of 16 nm to mm should be given.Unit conversion from nm to in mm can be done using the for...

Q: Enter the symbol of the element which would have 18 electrons and +1 charge.

A: An atom is a smallest particle which is capable of existing independently. It has equal number of pr...

Q: The dissociation energy of the hydrogen molecule (i.e., the energy required to separate the two atom...

A: 1 eV = 1.6 x 10-19 JAverage kinetic energy is given by following equation.

Q: What is the difference in the suffixes -ane, -ene, and -yne? This is in refrence to the hydrocarbon ...

A: The base name always depends on the number of carbon atoms present in the base chain. For one, two, ...

Q: What are three steps involved in evaluating the enthalpy changes associated with solution formation?

A: The steps involved in enthalpy changes with solution are;Step 1: Separate the solute components: The...

Q: Calculate the wavelength (m) for an electron with a mass of 9.11 x 10-31kg and a kinetic energy of 9...

A: Click to see the answer

Q: How does the solubility of a solid in a liquid depend on temperature? How is this temperature depend...

A: The solubility of a solid in a liquid generally increases with increase in temperature. When tempera...

Q: A). The density of osmium is reported by one source to be 22,610kg/m3. What is the density in g/cm3?...

A: A.) The density of osmium is reported by one source to be 22,610kg/m3. This is to be converted into ...

Q: How does the solubility of a gas in a liquid depend on pressure? How does this pressure dependence a...

A: Solubility is defined as the amount of gas that is present dissolved in a solution.As per Henry's la...