Prepare a 1:200 dilution of the 20 mM Coomassie solution to measure the max wavelength—you need 2 ml for the absorbance measurement but the dilution does not matter as long as the absorbance is in the range of 0.2 to 0.6. Set the initial wavelength at 450 nm. Blank the spec with a tube containing 2 ml water. Use the 1000 ul pipette for water because you need to deliver the same amount of water in each tube for the next exercise. Why is it when the calculations are done for the given values above, the value for ml is 0.01 for coomassie blue?

Prepare a 1:200 dilution of the 20 mM Coomassie solution to measure the max wavelength—you need 2 ml for the absorbance measurement but the dilution does not matter as long as the absorbance is in the range of 0.2 to 0.6. Set the initial wavelength at 450 nm. Blank the spec with a tube containing 2 ml water. Use the 1000 ul pipette for water because you need to deliver the same amount of water in each tube for the next exercise. Why is it when the calculations are done for the given values above, the value for ml is 0.01 for coomassie blue?

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter8: An Introduction To Optical Atomic Spectrometry

Section: Chapter Questions

Problem 8.8QAP: The Doppler effect is one of the sources of the line broadening in atomic absorption spectroscopy....

See similar textbooks

Similar questions

The Doppler effect is one of the sources of the line broadening in atomic absorption spectroscopy. Atoms moving toward the light source encounter higher-frequency radiation than atoms moving away from the source. The difference in wavelength experienced by an atom moving at speed v (compared to one atrest) is / = v/c , where c is the velocity of light. Estimate the line width (in nanometers) of the lithiumline at 670.776(6707.76 Å) when the absorbing atoms are at a temperature of (a) 2000 K and (b) 3120 K.The average speed of an atom is given by v=8kT/m , where k is Boltzmann’s constant, Tis the absolute temperature, and m is its mass.
Calculate the wavelength of (a) the sodium line at 589 nm in diamond, which has a refractive index of 2.419. (b) the output of a ruby laser at 694.3 when it is passing through a piece of acrylic sheet (Plexiglas©), which has a refractive index of 1.49.
The L lines for Ca, Zn, Zr, and Sn have wavelengths of 36.3, 11.9,6.07, and 3.60 Å, respectively. Estimate the wavelengths for the L lines for the elements listed in Problem 12-3.
1a. A solution of dissolved ozone in water gives a percent transmittance of 83.4% when measured at 258 nm using a path length of 5.00 cm. The molar absorptivity of ozone at 258 nm is 2950 L/mol.cm. Calculate the absorbance of this sample and the concentration of ozone in the sample.
If a solution has an absorbance value of 0.518 at a wavelength of 460 nm, what is the percent transmittance of this solution at this wavelength?
1. Calculate the energy and frequency of the electromagnetic radiation that has a wavelength of 134 nm. At what region of the electromagentic radiation does this belong? 2. A solution containing 4.48 ppm KMnO4 has an absorbance of 0.265 in a 1.00 cm cell at 520 nm. If the percent transmittance of an unknown solution is 63.2%, what is the absorbance of the solution? Calculate the concentration of the unknown solution.
What value of absorbance corresponds to 45.0% T? If a 0.010 M solution exhibits 45.0% T at some wavelength what will be the percent transmittance for a 0.020 M solution of the same substance?
mass of copper = 2.494g; Wavelength = 830.6 Volume of volumetric flask - 50 ml Here's the absorbance of all the test tube
A 50.0 mg sample was dissolved in acid and then diluted to a total volume of 50.00 mL. If 1.000 mL ofthis solution was then diluted to 50.00 mL with water. If this diluted solution had a transmittance of 0.275 at520 nm, what is the concentration of KMnO4 in ppm in this diluted solution, assuming no interference fromother species at this wavelength?
Using the ε value obtained from the gradient of an absorbance vs concentration plot, how would you calculate the concentration at which light is equally absorbed and transmitted by a sample?
You are required to measure a sample that absorbs at a wavelength of 300 nm and 4 µm.What would you use as your light source? Justify your answer.
Beer's Law states Question 3 options: A. the relationship between transmittance and concentration is linear. B. none of these. C. the relationship between absorbance and transmittance is logarithmic. D. the relationship between absorbance and concentration is linear.