Answered: Q2: A triangular pyramid of side 15 mm…

Q2: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal prism of base edge 28mm and height of 50mm centrally. Draw the Isometric view of these solids?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.123RP: The center of gravity of the plane wire figure is located at G. Determine the lengths a and b.

See similar textbooks

Related questions

Q: Find the centroid of the given plate. Where AB = DE = 260mm, CG = BE = HF =240 mm, AB = 2 GB

Q: Consider a region R, which lies above the x-axis and between the circles x² +y° = m and x +y = n°…

Q: If you have the shaded area shown below for multi bodies, can you find the coordinates of the…

A: The each part of shaded area is given below,

Q: Centroid of a rectangle is the midpoint of the area. Justify this statement.

Q: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal…

A: Given: pentagonal prism height = 50 mm pentagonal prism base edge = 28 mm triangular pyramid height…

Q: Q3: A cube of edge 24mm is resting on the top of a frustum of cone of base diameter 60mm and top…

A: Isometric Projection Isometric projection is a method for representing three-dimensional objects…

Q: 2. A thin, homogeneous perimeter of the figure shown to the left. Locate the center of gravity of…

Q: B3. A circular plate of diameter 2 m is vertically placed in water in such a way that the centre of…

Q: Q2: A rectangular block 7ft by 18ft by 32ft long, its load of garbage has its center of gravity 2ft…

A: Given Data Height of rectangular block is : h=7 ft Length of block is : l=32 ft Width of block is :…

Q: Draw the isometric view of frustum of square pyramid of base edge 70, truncated edge 40 and height…

A: Given: base edge = 70 mm truncated edge = 40 mm Height = 50 mm

Q: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal…

A: Isometric view of solids Isometric view is defines a combination three types of views in the single…

Q: 3. The top of the circular table shown to the-bide is 1.2 meters in diameter and weighs 26 kg. If a…

A: Calculated wide the base so that the table not to flip over.

Q: Q2: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal…

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: An elliptical plate, major axis 6 units, minor axis 4 units, is submerged vertically until its…

A: The force on one side of the plate is (12•π•w) lbf. (where, w = specific weight of liquid in…

Q: Q2) what is the length of sides required to maintain a cube shown in figure suspended on water…

A: The weight of the cube can be determined as,

Q: A cube of edge 24mm is resting on the top of a frustum of cone of base diameter 60mm and top…

Q: A hemisphere of radius 80 mm is cut out from a right circular cylinder of diameter 80 mm and height…

A: Given: The radius of the hemisphere is R=80 mm, The diameter of the right circular cylinder is d=80…

Q: For the planar area symmetrical with respect to the x-axis in the figure, the cross-section…

A: Consider the section as shown below, Area ABCD, A1=24a+ca+2aA1=24×1+31+2×1A1=42 cm2Centroid of…

Q: 2.1 A rectangular plane surface is 2m wide and 3m deep. It lies in vertical plane in water.…

Q: Determine the center of gravity of the below figure symmetrical about the y-axis, then discuss your…

Q: A: A half circle of area made from wood, while the other half made from metal. Can you consider the…

A: Centroid is the geometric centre of the figure or it is a point bat which total area is supposed to…

Q: Centroid of an area always lies on the axes of symmetry. Justify this statement.

A: Solution:

Q: Q2: A rectangular block 7ft by 18ft by 32ft long, its load of garbage has its center of gravity 2ft…

A: Given dataVolume of rectangular block V = 7×18×32 ft3Center of gravity is 2ft above To determine the…

Q: A: A half circie of area made from wood, while the other half made from metal. Can you consider the…

Q: Find the mass of a cube of edge a, if the density varies as the sum of the distances from three…

A: Consider a cube of edge a, now it is given that, ρ=k(x+y+z) where, k is the…

Q: 2. Calculate the centroid of the plane area shown in below figure- 2 below. Take hl = 14 cm and h2 =…

Q: B3. A circular plate of diameter 2.5 m is vertically placed in water in such a way that the centre…

Q: a) A homogeneous thin wire as shown in the figure bent. Determine the coordinates of the center of…

A: Centroid of an area is the point located in the area which is considered to be placed at an average…

Q: Draw isometric view of frustum of the square pyramid with 40 mm base edge, 20 mm upper edge and…

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: Q2- The equilateral Lamina ABC is placed parallel to the V.P. and having the following data:- A…

A: Given DataEquilateral triangle so, all sides are equal side=8cm(Given)

Q: The front wheels of a truck support 2000lb, and its rear wheels support 3500lb. The axles are 12ft…

Q: a hemisphere of radius 80 mm is cut out from a right circular cylinder of diameter 80 mm and height…

A: In the given figure, we wil divide the figure into two areas, 1: Volume of the cylinder 2: Volume…

Q: A cube of steel 0.3 m on each side floats in mercury. Using specific gravities of steel and mercury…

Q: What is the resultant force on one side of a 25 cm diameter vertical circular plate standing at the…

A: Given Data : Diameter of circular plate d = 25 cm Height of pool h = 3 m The area of circular…

Q: Consider the rectangular cardboard shown in the figure. If you cut a hole in the material, the…

Q: Find the center of mass of the structure given in the figure below. Assume a uniform thickness of 20…

A: Consider the diagram shown below for the given body.

Q: Q) Determine the center of gravity of the below figure symmetrical about the y-axis, then discuss…

A: Centre of gravity of any body is the point at which the whole mass of body is assumed to be…

Q: Q3: A cube of edge 24mm is resting on the top of a frustum of cone of base diameter 60mm and top…

A: Q3:- Given data:- cube edge = 24mm Cone base diameter = 60mm Cone top diameter = 40mm Axis…

Q: A half circle of area made from wood, while the other half made from metal. Can you consider the…

A: Centroid is the geometric center of the figure at which whole area is assumed to be concentrated.…

Q: Ql: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal…

A: PENTAGONAL PRISM A pentagonal prism consists of two pentagonal foundations such as the top and…

Q: A cube of edge 24mm is resting on the top of a frustum of cone of base diameter 60mm and top…

A: Isometric projection Isometric projection is a method for representing three-dimensional objects…

Q: Centroid of an area always lies on the axes of symmetry. Justify this statement

A: The point corresponding to the geometric center of an object is known as the centroid.…

Q: ree smooth cylinders, each weighing 500 N, is placed inside a smooth ox as shown in the figure.

Q: Find the volume of a regular square pyramid with the base side a and the altitude H.

A: We will be using calculus to calculate the volume of this pyramid let us take the red coloured…

Q: A- The homogeneous 12-cm cube is balanced by a weight as shown in Figure on the beam scale when the…

Q: 3 ft 3 ft 1 ft ft 2 ft

A: Given First area = Quadrant = A Second area = Circle = B Third area =…

Q: 1 m 2 m 1 m 2 m Find the centroid coordinate Xc, of the cross section, with respect to x-axis. Find…

A: Given: Area A1=2×2=4m2 Area A2=1×1=1m2

Concept explainers

Center of Gravity and Centroid

The term center of gravity indicates the position or location of a point about which the whole weight of a body or system is supposed to be concentrated, which means the whole weight of the body or system works through this point. It is closely related to mass distribution. For all positions of the body, the center of gravity would be a single point.

Question

Q2: A triangular pyramid of side 15 mm and axis height of 24mm is resting on the top of a pentagonal
prism of base edge 28mm and height of 50mm centrally. Draw the Isometric view of these solids?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
A rectangular block 7ft by 18ft by 32ft long, its load of garbage has its center of gravity 2ft above as shown in figure ,the metacenter of this configuration is
A cube A is 30cm along each edge and weighs 1450N. It is attached to the square prism B which 15cm x 15cm x 2.4 meters and weighs 4700N/m3 . What height of B (in meters) will project above the surface if the specific gravity of the liquid is 1.50?
Q3 : Determine the center of gravity of the below figure symmetrical about the y-axis, then discuss your results.
An elliptical plate, major axis 6 units, minor axis 4 units, is submerged vertically until its center is 2 units below the surface and the major axis is horizontal. Find the force one side of the plate.
Show that for a regular pyramid of height h and n sides (n = 3, 4, . . .) the centroid of the volume of the pyramid is located at a distance h /4 above the base.
Consider the two blocks on the seesaw below. The wedge is fixed at the center of the seesaw. If the larger box has twice the mass as the smaller, how could the seesaw be balanced? The distance measured from the center of the seesaw where the wedge is located is r. Note: For the larger box, r = rlarge and for the smaller box, r = rsmall
A circular plate of radius 2ft is lowered to a liquid (w=1000 lb/ft^3) so that its center is 4 ft below the surface. Find the force on the lower half of the plate.
a) A homogeneous thin wire as shown in the figurebent. Determine the coordinates of the center of gravity of the wire.b) Calculate the coordinates of the center of gravity, assuming that the region inside the wire is produced from a solid and homogeneous plate.
Find the centroid of the right-triangular area with side-lengths being 3cm, 4cm, and 5cm respectively.
A semicircular plate of radius 5ft rests vertically on its diameter at the bottom of a pool filled with water to a depth of6ft. Assume that the water’s weight density is62.4lb/ft3.•Find the force exerted by the water against on side of the plate.
A crane barge 20 m long, 8 meters wide and 2 meters high loaded at its center with a road roller weighing 100 kg, floats on fresh water with a draft of 1.20 meters (draft is the submerged height of the barge) and has its center of gravity located along its vertical axis at a point 1.5 meters above its bottom. Determine the following: a.) Weight of the barge in kg. b.) Center of buoyancy and the metacentric height from the bottom of the barge. Is the barge stable?