Q2] for the following circuit fill in the blanks (answer in phasor form): V = 5 sin 10t 452 www 0.2 H

Q: The figure below shows a mobility Nyquist plot representing the response of a single mode. The three…

A: The given Nyquist plot represents the response of a single mode. Now, as per the data given in the…

Q: WA (↑ 2 5 lov 15 + VX- 10 SOV

A:

Q: Solve the problems below. Show your solution. 1. A 5-kW AC motor has a power factor of 65% lagging…

A:

Q: 1. Determine the total resistance and the current along 3 ohms in downward direction. 50V + 65 M 85…

A:

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: We need to find out the total bandwidth for given signal .

Q: Output data ratio of a 8-bit PCM-TDM system sampling 24 voice channels, comparing these using u-law…

A: Given- Number of voice channels = 24 , Frequency , f =8 kHz ,   To find- Output data of 8 bit PCM…

Q: 2) Assume we have two infinite line currents with uniform charge densities +PI and -PI . They are…

A: We need to find out the electric field due given line charge density .

Q: Question- What is the average output of a semi-converter connected to a 120 V, 50 Hz supply and…

A: Given- 120 V,50 Hz supply, Firing angle=π/2, To Find- The average output of the semi-converter.

Q: Solve the average power and dc voltage. What will be the average power if we take the 5-ohm bulb…

A:

Q: 9. The time constant of the circuit shown in the figure below is A. 25 sec. B. 0 sec. C. .025 sec.…

A: We need to find out time constant of given circuit , it is a RC circuit .

Q: There are three switches in the given circuit shown below. The resistance of the lamps is given in…

A:

Q: If the following signals are added. Determine y(1). yl(n) = {-3, 2, 0.5, 1.3, -2.1, -0.9} y2(n) = {…

A:

Q: Solve for all the currents by Mesh Current Analysis. 10 Ω 220 V www 40 Ω 20 Ω 30 Ω 50 Ω 240 V

A:

Q: Question 8 Compute the power absorbed by the 10 Q resistor in the circuit.

A: We need to find out power absorbed by given resistor , first we will find out the voltage across the…

Q: Given the equation for current, i (t) = at + b A, calculate the total value of charge in Coulomb…

A:

Q: solution: VI 412 super mode. 2√2 www 30v V2 V3- V1 = 22 15 A V3 30 8.2 How did it become like that??…

A:

Q: Q.4 A signal_x(t)= K sinc²(t) + L sinc(2t) is used to form another signal y(t)= K ·[1+x(−Lt+M)]…

A: Please find below the answer.

Q: In general terms, the capacitance is ? determined by =Q/V0 True O False

A: In this question,  We need to choose the correct option  We are solving this Problem using the…

Q: The expression of Norton's current (IN) in the circuit shown below is?

A: We need to find out norton current for given circuit , norton current is the short circuit current .

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of VDC Calculate…

A: We need to find out the average value and swing for output voltage and we need to design the given…

Q: analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz. The…

A: We need to find out number of bits per sample , first we will find out the number of level then we…

Q: 2.34 The input-output pair shown in Figure P2.34-1 is given for a stable LTI system. LE -1 0 1 xo[n]…

A:

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of Voc Calculate…

A: From the input waveform given, the value of input voltage is  Vin = 10V

Q: Determine: Sinusoidal Signal C Carrier Signal a. Bandwidth of the AM signal b. The total modulating…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: Obtain the Fourier transform of the "switched-on" exponential function shown in Fig f(t) 1 e-ot

A:

Q: discuss the basics of DSB-SC signal and where it is applied.

A: A form of amplitude modulation is DSB. Double side band is referred to as DSB. On either side of the…

Q: Write a matrix equation that determines the loop currents shown to the right.

A: It is given that:

Q: 5. The rod given in the figure is made up of two different materials. 25 cm 70 cm Both have square…

A:

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Given:  Daily Maximum demands: 150kW, 70kW, 120kW, 60kW, 200kW   The maximum demand is150kW…

Q: -Find the Fourier transform of x(t) = 2 sin (5 πfet) Plot the signal of x(t) in the time domain and…

A:

Q: V 7. Find i, in the circuit in Fig. 3.46. 4 A www ΤΑ www

A:

Q: 3. Determine and sketch Vout for one complete cycle. 15 V 0 -15 V EN 15 V Vm 我 0 T -15 V HIN T (a)…

A:

Q: 9 = B(-1-j2.829) (-1-j2.829 + 1-j2.829) 9 = B(-1-j2.829) (-j5.658) 9 = B(-16 + j0.1768) B =…

A: This is a basic problem of complex equation. The detailed explanation is given in the next step.

Q: For the op-amp shown in the following figure, if R1 = 100 2 and Rf = 1 k2, the overall voltage gain…

A: We need to find out the gain for given non inverting amplifier .

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: 1. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A:

Q: 1. For all questions, assume T = 300K unless specified, VT = kT/q = 0.026V, q= 1.6x10-19, ni =…

A:

Q: load is connected to a 210 V, 50 Hz supply. If it has resistance of 300 and a capacitor of 0.25 mF,…

A: Given, V=210 V f=50 Hz R=30 Ohm C = 0.25 mF

Q: Measure the voltage across each resistor, and record your readings in Table 1.

A: Given

Q: 1. At 250 K, the activation energy for a gas-phase reaction was determined to be 6.500 kJ mol ¹.…

A: Solution !! The expression in terms of moles for the distribution of molecular energies, nE =…

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent? * 1=…

A: Given, VL=220 V cosϕ= 0.71 lag P= 21437 W I = ?

Q: 4...

A: Given: Consider the following Simulink diagram: To find: Determine the equation implemented by the…

Q: Find ix using mesh analysis.

A:

Q: In the circuit shown in the given figure, a current of 5A flows from the supply source. Switch S is…

A: Current = 5A Inductance = 2 H Resistance = 10 Ω

Q: Q2.) A CRT has deflecting plats of 4mm longs, and 2000μm a part. The screen is 500mm away from the…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: A GaAs laser operating at 800nm has a 500-μm length and a refractive index n=3.7. what are the…

A: SOLUTION GIVEN-->                  Wavelength of LASER λ…

Q: Determine the impedance of a 200 ohm resistor in series with an 8 mH inductor in the s-domain

A: We need to find out the impedance for series  RL circuit.

Q: The functions of Network Layer are: O Logical Addressing, Routing, Path Determination Translation,…

A: This is a problem of data communication and networking. The detailed solution is given in the next…

Q: 3. Determine the voltage across the 40-ohm resistor. 60V(+ 255 M 40: 12.02 M 18n :80 180 18

A:

Q: 5 A 7. Find i, in each of the circuits in Fig. 3.46. Ο ΣΗ ΣΑΣ IA

A: Given circuit:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.