Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line voltage of 33 kv: 1- Find the voltage distribution over the unit of the string 2- Find the voltage distribution when the string supplied by a guard ring which add two air capacitance of 0.2 C, 0.15 C respectively to the nearest to the conductor 3- Compare between the efficiency in 1&2 (before and after adding the guard ring)

Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line voltage of 33 kv: 1- Find the voltage distribution over the unit of the string 2- Find the voltage distribution when the string supplied by a guard ring which add two air capacitance of 0.2 C, 0.15 C respectively to the nearest to the conductor 3- Compare between the efficiency in 1&2 (before and after adding the guard ring)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The puncture resistance of the insulator used in an AA cable with a conductor cross section of 150 mm2 is 200 kV / cm for the most convenient layout. Which of the following is the maximum effective value of the voltage that can be applied to this cable with relative dielectric coefficient kapasitesi, = 4.4, and the capacity of the unit length of the cable? Take the dielectric constant 8,86.10 ^ -12)
A copper wire at 20 degrees C, and 164 cmil, has a K value of 10.4 ohms per mi-foot. If the distance to the load is 600 feet (183 m) calculate the resistance of the loop.
High Voltage Technique For the most puncture-related arrangement of a concentric spherical electrode system with a voltage of 100 kV to be applied between the electrodes and with Ed=80 kV/cm (insulator puncture strength), Emax = 0.6. Ed a) Inner and outer sphere radii, b) Maximum and minimum field strengths, c) Equivalent electrode opening and utilization factor, d) Its capacity (Ɛ0=8,854x10-12 F/m, Ɛr=1) and insulator volume, e) By keeping the outer sphere radius constant, calculate the inner sphere radius value range that can be used in the system without discharge. ANSWERS: a) r1=4.16 cm, r2=8.32 cm b) Emax=48 kV/cm, Emin=12 kV/cm c) α=2.08 cm, η=0.5 d) C=9.257 pF, Vinsulator=2110 cm3 e)1.53<r1<6.8 cm
Design a 1500-meter-long electrical transmission line with a cross-section size of 0.00199 cm2 that can carry a 50-amp current with a power loss of no more than 5 x105 W. Table 1 shows the electrical conductivity of a variety of materials. What kind of material could be a good candidate?
Q4. A Transmission Line has a span of 250 meters between two level supports. The conductor has a cross-sectional area of 1.29 cm2, weighs 1170 kg/km and has a breaking stress of 4218 kg/cm2. Calculate the sag for a safety factor of (5), allowing a wind pressure of 122 kg per square meter of projected area. What is the vertical sag?
A solid cylindrical aluminum conductor 25 km long has an area of 336,400 circular mils. Obtain the conductor resistance at 20C and 50C. Find the AC resistance per Km of the cable at 50C. Assume a skin-effect correction factor of 1.02 at 50 Hz. The resistivity of aluminum at 20C is 2.8x10-8 Ωm
The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5 m and the outer diameter is 5mm and its inner diameter is 0.5mm, what is its resistance? Note that the inner diameter is present to leave a hallow place where conducting wire ( usually copper) is present. Follow the format: Given: Required: Equation: Solution: Answer:
The puncture resistance of the insulator used in an AA cable with a conductor cross section of 150 mm2 is 200 kV / cm for the most convenient layout. Which of the following is the maximum effective value of the voltage that can be applied to this cable with relative dielectric coefficient kapasitesi, = 4.4, and the capacity of the unit length of the cable? (Take the dielectric constant of the gap -12 8,86.10)
Compute for IN, RN and the current passing though the 25-ohm resistor using Norton’s Theorem.
A thin insulator rod of mass m and length L=40 cm, as shown. thresholdon the surface of the plane and in an outer bend from the rails placed on the edges. It slides frictionlessly with a constant velocity of V=0,8 m/s. Itrails at the lower edge of the inclined plane. to each other with a rail parallel to the bar connected so that the bars and rails are closed, a rectangular frame they form. Rail plane is Ɵ=50° angle with horizontal plane (xz plane) is doing. Before the rod begins to weld, it must be tilted above the inclined plane. It stood above the lower edge of the plane at a distance of S=4m. Inclined plane and the rod shows a magnetic field of uniform B=0,5i+0,8j+0,20k(T) is under the influence. When the bar starts to slide, at t=3s moments the bar, the edge magnetic passing through the frame surface formed by the rails and the rails at the bottom edgewhat is flux?
An electric wire having a mass of 0.5 kg/m along the horizontal is suspended between supports of the same elevation which is 50m apart. If the maximum tension in the wire is 800N, find a. the minimum tension b. the sag c. the length cable
Conductors A composite conductor 10 m long consists of an inner core of steel of radius 1.5 cm andan outer sheath of copper whose thickness is 0.5 cm. Take the resistivities of copper andsteel as 1.77 x10-8 and 11.8 x10-8Ω respectively. Determine the resistance of the conductor. If the total current in the conductor is 60 A, what current flows in each metal? Find the resistance of a solid copper conductor of the same length and cross-sectional areas as the sheath.