Q4) Given R-2R ladder shown in fig. 3, find Vout if the digital inputs are 10011. Assuming R=RRef and V= 5v P. A. -3 B. -3.28 C. -4.28 D. -5.28 E. None is correct Fig. 3

Q: i need the answer quickly

A: The solution is given

Q: Q3/(b) At Fig. below, if RD=5KO, RS-7Κ , rd-20KΩ, find ZO HE To 4KO O 3.5K2 O 5ΚΩ (

A: We need to find out output impedance for given circuit.

Q: er the shown system, Use the Routh criterion to determine the range of stability relative to the…

A:

Q: نقطتان )2- Q3/(b) At Fig. below, if RD=5KQ, RS=7KQ, rd3D20KO, * find ZO Rp HE 4ΚΩ () 3.5KN O

A: It is common source with bypass capacitor amplifier Given rd = 20k, Rd = 5k

Q: Determine IDQ, VGSQ, and VDS for the network of Fig below.When VDD=40V, RD=3K, RS=1K, R1-24M,…

A: The required parameters can be calculated by using the DC analysis of the MOSFET amplifier.

Q: Q2 Find the modeling for the following systems shown in Fig. below 1. R ww R2 2. ki k

A: 1. The given network is: Taking the Laplace transform and applying Kirchhoff's Voltage Law (KVL) in…

Q: In Fig., solve for RT, IT, VT, V1, V2, V4, I2, and I3

A: All the branch currents and voltage are calculated in the solution attached.

Q: Determine the following for the network of Fig. (a) VGSe (b) Ipe (c) V DS- 20 V 3.3 ka (a)

A: We are authorized to answer First three parts only. As you have not mentioned which part to answer.…

Q: Q:- For the Circuit Shown in fig. Final the loop Current (Is) using mesh ana ly sis. 3V

A: The solution can be achiieved as follows.

Q: Find the ( Reg ) Equivelant in the Fig. below

A: so we need to find the equivalent resistance.

Q: Q2 Find the modeling for the following systems shown in Fig. below 1. R1 R2 ww ei iz

A: Write KVL in both loops; ei-i1R1-ji1-i2ωC1=0ei=i1R1+j1ωC1-ji2ωC1…

Q: Ex( H.w) Use thevenin's theorem to analyze the Cr auit shown in fig to Find the Load Current Ans:…

A:

Q: EX: For the Circuit as shown in fig below, if Vo = 6 voit find Is. (using Kirchhoff's Law) Is (1 Vo…

A: In this question we need to find a current Is by using KVL and KCL

Q: W R1 > R₂ -Vcc my Rc RE

A: Given Vcc= -6V and R1=68Kilo ohm R2= 47Kilo ohm Rc=1.8Kilo ohms Re=2.2Kilo ohms B(beta)dc=75…

Q: What are the initial values of Ron and τ = RonCC in the circuit in Fig. ?

A: The bitline voltage will be pulled down to be zero at initial stage. Calculating Ron

Q: %3D Q2: The n-channel JFET of Fig.1 is characterized by Ipss = 5 mA and %3D Vp = 3V. Let Rp = 3 kN,…

A:

Q: an For the pewok in Fig3 Fial rurene , , and , A Fnd volage , d V . Find the power delivernd the 3i…

A:

Q: b. VGs, and Ipg Q-1) For the network of Fig. , determine: a. VG. b. VGs, and Ipg c. Ig.

A: Note :- As per guidelines we are supposed to answer only first 3_sub-parts. So I request you to post…

Q: Q4: for Fig. below determine: i. IE ? ii. VC ? -8 V iii. VCE ? 2.2 k2 VCE + Vc 1.8 kQ 10 V

A:

Q: Q2 Find the modeling for the following systems shown in Fig. below 1. R R2 2.

A:

Q: (a) The variable yesistoe in the CirCuit of FiG. below ie adjnsted for Max.ower transfer to Ro. Find…

A: The solution can be achieved as follows.

Q: (A) :For the circuit shown in Fig.(a),find Rab -

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If…

Q: Determine Ibo, VGsa, and V Ds for the network of Fig. F. 40 V 3 kQ 22 M2 DO 2N4351 Vas m = 5 V (T) G…

A: Brief description: Field effect transistors are known high input impedance devices. Because of…

Q: Given the network of Fig. 4.43 and the BJT characteristics of Fig. 4.44. a. Draw the load line for…

A: In this circuit, we assume for DC analysis for this capacitor is open circuited and the Rf1 and Rf2…

Q: Q4. For the network of Fig. (Q4) Determine: c) VCE a) Ie b) Vc -8 V 22 k2 Ver + 1.8 k2 610 V Fig.…

A: Since betta is infinite  IC = IE and IB = 0 A.

Q: Ex. Q 4. Determine the following for the network of Fig.D a. Ipo and VGsq- b. Vp- 20 V Rp 26.2 kN D…

A: We need to find out the drain current, drain, source voltage for given circuit

Q: Use the node-voltage method to find i, in the cir- cuit in Fig. P4.24.

A:

Q: (23) For the circuit shown in Fig-C16). Find the Values of voltage and current indicated assuming…

A: D)

Q: B- An RC ladder network is shown in Fig.l. Find the transfer function V.(sMS). R R Buffer amplifier…

A: The above network represents a cascading network. Here 3 RC networks are cascaded to produce the…

Q: State and explain Kirchoff’s Laws, and determine the current IL in the network (shown in Fig.4)…

A: Kirchhoff's Laws: There  are two laws which states the Kirchhoff's law Kirchhoff's current law:  It…

Q: Q2 Find the modeling for the following systems shown in Fig. below R1 R2 ww iz

A: As there are two  energy storage element we have two state variables Vc1=x1 Vc2=x2 Let e0=y;ei=vIi…

Q: Find Power delivered by 28V, Vab and Vcd R1 = 1 kN R2 = 1 kN R3 = 3 kN a R5 6 kN R6 6 k 28 V R4 I5 5…

A: Given circuit shown

Q: Q1: connect the circuit as shown connect the circuit shown in Fig. , then measure the voltage and…

A: The solution can be achieved as follows.

Q: Q1: For the amplifier circuit of fig., determine VGso, Ipo. Zi, Zo „Aj and A, 16 V 2.4 k Ohm 20 uF…

A:

Q: Find the Norton equivalent circuit  for the resistor (RL=1k) as shown in the fig. below.

A:

Q: 2. Write the nodal equations for the network in Fig. having a dependent current source V2 Z3 kľ

A:

Q: 1. Determine the following for the network shown below: *Use Mathematical Approach a. ID b. VGS C.…

A: We need to find out the current and voltage for given circuit

Q: %3D Q2: The n-channel JFET of Fig.1 is characterized by Ipss = 5 mA and %3D Vp = 3V. Let Rp = 3 kN,…

A:

Q: 1. Determine the following for the network shown below: *Use Mathematical Approach a. ID b. VGS C.…

A: Brief description : In the above given question we need to calculate DC parameters such as ID, VGS…

Q: b. VGs, and Ipe Q-1) For the network of Fig. , determine: a. VG. c. IE.

A: Note :- As per guidelines we are supposed to answer only first 3_sub-parts. So I request you to post…

Q: Q3. Find the value of B, Vec and Raof the carenit shown in (fig. 4), Draw the le and tick on the…

A: Given

Q: Solve for VcE -22 V 2.2 k2 82 k2 Vc IB B = 220 16 k2 0.75 k2 +12 V

A:

Q: Q2 Find the modeling for the following systems shown in Fig. below 1. R1 ww R2 ww eo

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3- Simplify the circuit shown in fig. (a) to that in fig. (b). 180 ? 100? 100 ? 680 ? R 180 ? 680?…

A: Given circuit,

Q: Find the z-parameters for the circuit in Fig. Q2(c). 402 20 802 V2 Fig. Q2(c)

A: In the given circuit,  Find the Z parameters i.e impedance parameters.  We are solving this problem…

Q: Find the values of voltage drop across each resistor in fig (a). a. VAB b. VBC c. VCD

A: Given circuit,

Q: What is Mesh Analysis and when is it effective to use? What is Nodal Analysis and when is it…

A: What is Mesh Analysis and when is it effective to use?  Mesh is a loop which doesn't contain any…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.