Question 1: Flip Flop Consider the following flip flop CLK D C Figl Q Q CLK Vcc J DC K Fig2 1. Give the name of each flip flops used in the figl and fig2 2. Give the timing diagram for each circuit considering the signal CLK

Q: A- A 10 kHz signal wanted to be sent and encrypted using FHSS with a factor of 10, if Af-5KHz…

A: FHSS stands for Frequency Hopping spread spectrum. It is a wireless communication technique where…

Q: A composite TV signal has a bandwidth of 40 MHz and is transmitted with a power of 0.1 W through a…

A: Bandwidth=40 MHz,Transmitted power=0.1 Watts,White noise has two sided PSD of 10-15 Watts/Hz.

Q: An infinite filament on the z axis carries 20 mA in the a, direction. Three uniform cylindrical…

A: Solution:Given data:(1)uniform cylindrical current =400mA/m , ρ=1(2)-250mA/m , ρ=2(3)-300mA/m ,…

Q: A 220 kV, three-phase, and 100 km long transmission line delivers 180 MVA at 0.85 power factor…

A: Voltage RatingReceiving end-phase voltage Load MVA ratingCalculation of load current

Q: Example 2: a 3-phase SM its armature resistance is 0.50 and syn. Reactance is 0.86692/phase. The…

A:

Q: Find the Thévenin equivalent circuit for the portions of the networks in Fig. 18.119 external to the…

A: To find out the Thevenin equivalent voltage will remove the Xc2 then XCandR2"…

Q: (a) The NMOS transistor in the source-follower circuit of Fig. P7.122(a) has gm = 10 mA/V and a…

A: Given Data:An NMOS source-follower circuit with,Transconductance  andLarger small-signal output…

Q: 2 In a unit negative feedback system, the system transfer function is given as G(S) = 5(+1) It is…

A: given system transfer function is                                                aimed closed loop…

Q: Find the equivalent resistance in the following circuit. 12V A B D 4Ω 15Ω 7.4Ω Μ 10.4Ω 5Ω ΕΩ 40.

A:

Q: In the circuit shown below R1=220, R2-440 and R3=660 The voltage across R1 will most nearly be 12v+…

A: Circuit diagram is given as,

Q: 1. A coil is wound uniformly with 300 turns over a steel ring of relative permeability 900, having a…

A: Number of turns in coil N = 300.Relative permeability of ring Cross sectional area of ring Mean…

Q: Consider the signal x(n) = [1, 2, 3, 2, −1] ↑ with Fourier transform X(w). Compute the following…

A:

Q: Draw the Qoutput waveform if the inputs shown in the following figure are applied to a gated D…

A:

Q: For the motor in Fig. Q3, the rated motor torque is 14 Nm, the motor torque constant is 1.2 Nm/A,…

A: Here, we need to solve question (iii)Rated motor torque , Torque constant, Motor inductance,…

Q: Construct the Bode plot for the phase of the following transfer function. 100(je + 1) (jo) (jo+10)…

A:

Q: X> H W- N Determine the output M of the following logic circuits according to the inputs X, Y, Z and…

A: Logic circuit,Determine the output M.

Q: Nodal Analysis Determine all Node Voltages and Voltages across each resistor. What is the current…

A: Circuit is given by:

Q: Given the circuit below: Iin (w) († jwL ooo Tout (w) R₁ www R₂ 1 - jwC (a) Solve for the frequency…

A: Given Data:An AC three parallel branch circuit with,Input current Output current To Find:Transfer…

Q: 4. In the circuit in figure, write the system of the mesh method and find i2. 10 2 40 V 10 WWW + Vo…

A:

Q: A single-phase to single-phase cycloconverter "bridge type" with input voltage and frequency 150V…

A: To draw the waveforms and perform the calculations for a single-phase to single-phase cycloconverter…

Q: A differential amplifier has a differential voltage amplification Ad = 200 and a CMRR = 1000. Its…

A: In an ideal differential amplifier,Differential voltage amplification, ..Inputs .

Q: Problem 1 The unbalanced A-load of Fig. 1 is supplied by balanced line-to-line voltages of 240 V in…

A:

Q: 1) The load on a 460 V, 60 Hz, Y-connected, balanced three-phase source consists of three equal…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: The output of a linear system is c(t): = tcos2t when the input is r(t) = sin2t. Find the transfer…

A: Given:To find:The transfer function of the system.

Q: Question 6: a) Find the closed loop transfer function:.. b) Determine the range of k... c) what is…

A:

Q: Calculate the voltage gain of the sta picted in Fig. 7.75. Assume λ = 0 a capacitors are very large.…

A:

Q: 2.An open circuit test was performed on a 150 kVA, 1200V/600V single phase transformer. Applying 600…

A:

Q: The h parameters of the first two-port circuit in figure 3 are h₁=10002;h₂=5×10 *;h₂=40;h₂2-25 µS…

A:

Q: Given the circuit below: Iin (w) jwI m Tout (w) R₁ www R₂ 1 jwC (a) Solve for the frequency response…

A:

Q: - sketch the root locus for a unity feedback system that have G(s) = k(s²-9) (s²+4)

A:

Q: Simplify the circuit above.

A: The given circuit needs to be reduced to get the required simplified circuit and the simplified…

Q: (a) Determine the heat energy required to convert 20 kg of water at 30°C completely to steam at…

A:

Q: The following figures give the O.C.C OF A DC shunt generator at 300 r.p.m 0 2 3 5 Field ampere…

A: The current speed of generator is 300rpmThe expected speed it at 375rpm.In case speed increases,…

Q: + . 4Η 10 Ω 40 Ω Μ 2Ω 1100 V Figure 5 t=0 2Η

A:

Q: Q4- Find the Norton equivalent circuit for the network external to the elements between a and b for…

A: The circuit diagram,

Q: 3.11 Find V, and the power dissipated in all the resistors in the circuit of Fig. 3.60. AS 60 V + 12…

A: Circuit diagram is given as,

Q: Example 8: For the system x -+- of the following statement about the system is true? (A)…

A:

Q: Ques: Find current in 1.12. resienter using Norton's theorem 184(1) 5-42 Tsh UF www Birz www DE

A: It is given that:

Q: ELEN 1000: Tutorial 7 (Binary Systems) 1. Express the Boolean expression and the Truth table for the…

A:

Q: = 7- Find the impulse response of ideal high pass filter with we 2TT 3

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: b) Draw a fully labelled block diagram of a demodulator suitable for DSB-AM, DSB-SC, and SSB…

A: Draw a fully labelled block diagram of a demodulator suitable for DSB-AM, DSB-SC, and SSB signals.

Q: R(s) + Vi(2) G₁(s) V₁(s) Vo(s) H₁(s) V3(s) V₂(s)+ V7(s) G₂(s) H₂(s) V4(s) + + Vs(s) Vg(s) G3(s)…

A: given here a block diagram and asked to find the transfer function

Q: Q/3/A three phase controlled bridge rectifier is operated from a three phase Y- connected to a 250V,…

A: In this question we need to find the followingThe required firing angle if average output voltage is…

Q: Solve for the current and voltages across the loads in the circuit below: (show detailed junctions &…

A:

Q: For battery operated high voltage insect killer (i.e. bug zapper) used at home: (a) Summarize types…

A: A battery-operated high-voltage insect killer, also known as a bug zapper, is a portable device used…

Q: 5. Find the close-loop transfer function, T(s) = C(s)/R(s) for the system shown using block diagram…

A: given that a block diagram of the system is

Q: The Point Charge Q = 18 nc has a velocity of 5x10 m/s in the direction ar = 0.609x +0.75ay +0.30ax…

A:

Q: 10. In the circuit shown below, the opamp is ideal. V a. Find (s). E b. What conditions must exist…

A: According to the circuit diagram you provided, it seems to be an active bandstop filter employing an…

Q: Tow Conducting SPherical Shells have radial a=3, b = 6 cm The int cior is a perfect dircted for…

A: Given data, ,To find outWe have to determine the capacitance value for and when for  and  for .

Q: Construct the asymptotic Bode plot of the magnitude response of the circuit below for V₂(s)/V₁(s). O…

A:

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.