Answered: Question 6 A 1.5-HP motor has in input…

Question 6 A 1.5-HP motor has in input current of 10 A at a voltage of 120 V. What is its efficiency? O 93.25% O 98% O 92.15% O 100% ▪ Previous 4 doto to save Last

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: Determine the average power supplied to the circuit in Fig. 17.26 if i(t) = 2 + 10 cos(t+10°) + 6…

A: We need to find out power supplied by source for given circuit , first we will find out the current…

Q: Determine the total resistance across the terminals from the figure below. RT ww 1 ohm www 25 ohms…

A: We know that in series connection net resistance is increases and while in parallel connection net…

Q: Sketch the following signals: (a) x₁(t) = t(u(t + 2) - u(t− 2)) (b) x₂(t) = x₁(t - 6k) Σ=-1 (c)…

Q: For the s-domain circuit in figure 1, (a) Compute the admittance Y(s) = I₁(s)/V₁(s). (b) Compute the…

Q: Qu. 2 A transfer function is known to have the form s²+as+b H(s) = ² + cs+d Use the following facts…

Q: Draw a block diagram for a negative-feedback system that might be used to control the level of light…

A: Negative-Feedback System:- A system with negative feedback feeds back a portion of its output to the…

Q: 2. Find the Laplace transform of 3. 4. Find the Laplace transform of Find f(t) for F(s) = f(t) = sin…

A: Let a time domain function is f(t) and its Laplace transform is F(s) then F(s) is expressed as…

Q: If Es = 10 ej4x ay, which of these is not a correct representation of E?(a) Re(Esejωt )(b)…

A: It is given that: Es=10 ej4x ay

Q: At time t = 0, a sinusoidal voltage 10 sin ωt is applied to an L−R series circuit. Determine an…

Q: For the trapezoidal current wave-form, determine the effective value. I (A) 1.22^2* peak current I B…

Q: A 3-phase 3-wire supply feeds a load consisting of three equal resistors connected in star. If one…

A: The given circuit is a 3 phase with 3 wire star connected load. If one of the resistor is removed…

Q: Given the discrete signal below, determine the value of x(1) x(n) = n-0.5, -3 <n≤ 4 0, otherwise…

A: In this question, We need to determine the value of x(n) at different different value. We are…

Q: 3. Determine and sketch Vout for one complete cycle. 15 V O -15 V Vi Vm E2 플 Vi 15 V Vm * 0 -15 V T…

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at w = 50…

Q: 10. A power supply provides 400 watts to a load and is 80% efficient. In 24 hours, does this supply…

A: Given: Power output, Pout=400 W. Efficiency, η=80%=0.8 . Time, t=24 hours.

Q: 2. Find Ix.

A: Given- Source current= IS1 = 2A IS2 = 4A Voltage source- V1 = 4 V To find- Current Ix =?

Q: 1. Find the value of the currents 11, 12 and 13 flowing clockwise in the first, second and third…

Q: AJFET-based common-source amplifier uses a VDD of 60V and an RD of 10kOhm. The JFET has a Vp of -8…

A: According to the question, For the CS JFET amplifier, we need to calculate (1) Voltage gain. (2)…

Q: 1. For all questions, assume T = 300K unless specified, VT = kT/q = 0.026V, q= 1.6x10-19, ni =…

Q: A telephone signal with a cutoff frequency of 5 kHz is sampled at a rate 60 percent higher than the…

A: Cutt-off frequency f = 5 kHz We have to determine the sampling rate.

Q: 4.26 A single-phase load is supplied through a 34.5-kV feeder and a 34.5/2.4-kV transformer. The…

A: To solve this question We draw a equivalent circuit diagram of the given power system .

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given data, Change in Zener current △I=10 mA=0.01 A. Change in Zener voltage △V=0.05 V.

Q: Based on the signals below, find the Fourier transform of x(t) for (a)-(e). -2 x(t) n 2 (a) -2 -1…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: In your own words, explain the common purpose of National Building Code and Philippine Electrical…

A: Here it is asked to discuss the common purpose of National Building Code and Philippine Electrical…

Q: a: e C D f

A: given are the two AND gates.

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given: For a certain zener diode, rated zener voltage, Vz=12 V. Change in zener current, ∆Iz=10 mA.…

Q: PLEASE ANSWER IT IMMEDIATELY A 10 pole, 400 kW, 250 V, dc generator has a lap wound armature with…

Q: r(t) 10 d(t) a. Damping ratio b. Natural frequency c. Final value of the output + a) Obtain the…

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Given: Daily maximum demand of the consumers are 150 kW, 70 kW, 120 kW, 60 kW and 200 kW. Maximum…

Q: Q- A digital-to-analog converter with a full-scale output voltage of 3.5V has a resolution close to…

A: Given data- Full scale output voltage- Vfo=3.5 V, Resolution=14 mV, To Find- The bit size (n).

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent? * 1=…

A: Given, VL=220 V cosϕ= 0.71 lag P= 21437 W I = ?

Q: 2. Find Ix. O Is 2 A R₁ 292 ww R3 1Ω R₂ 452 V₁ 4V Rs 292 www ww R₁ 30 R6 5Ω ww Is₂ 4 A O 2

A: The given circuit is shown below. Find current Ix.

Q: Describe each of the following expressions as SOP, POS, both or neither. Discuss the numb variables,…

Q: Find the percent modulation of an AM wave whose total power content is 2500 W and whose sidebands…

A: Total Power Pt = 2500 W Side band power PSB = 400 W We have to determine the modulation percentage μ…

Q: An 800 kV transmission line has a maximum power transfer capacity, P, it is operated at 400 kV with…

A: Given- 800 kV transmission line, Maximum power transfer capacity=P, 400 kV operation voltage, To…

Q: d. The peak voltage across the capacitor at resonance, fo e. The peak voltage across the capacitor…

Q: Chapter 3 1. Minimize the following Boolean functions into sum-of-products form using a K-map (a)…

Q: 3. Determine the current i, through the 20-12 resistor. 3A 1 1252 www 45 (22 2012 www 362

A: We need to find out the current through given resistor in given circuit , we will find out by using…

Q: Prior to the formation of the depletion region, electrons were injected to the P type silicon from…

Q: Example 2.9 The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the…

A: Solution !! a. The temperature rise is degrees Celsius and the resistance increases 0.393% forevery…

Q: Reduce the block diagram shown to a single transfer function.

A: given here a block diagram and asked to find the transfer function.

Q: Question 8 Compute the power absorbed by the 10 Q resistor in the circuit.

A: We need to find out power absorbed by given resistor , first we will find out the voltage across the…

Q: Draw the expression below ¹(¹-2¹)-¹(²—³²) d. 211 1.5 +211 (t-3)

Q: 3. Determine and sketch Vout for one complete cycle. 15 V 0 -15 V EN 15 V Vm 我 0 T -15 V HIN T (a)…

Q: A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50…

Q: If the following signals are added. Determine y(1). yl(n) = {-3, 2, 0.5, 1.3, -2.1, -0.9} y2(n) = {…

Q: VS 20 V 어머머머 IT N2 N1 R1 2k2 R4 3.3 ko 싸 R3 1k2 A.2) Repeat the calculations using node analysis. R2…

A: For the given circuit calculate: A. 1) Voltage and current at all resistors and nodes of the circuit…

Q: n a 4*4 Y bus matrix the number of non zero elements are 12. Find the sparsity of the system?

A: Given a 4×4 Y bus matrix. Total number of elements = 4×4=16. Total number of non zero elements = 12.…

Q: Two shunt generators and a battery are all connected to common bus-bars. The open circuit voltage…

Q: Q2] for the following circuit fill in the blanks (answer in phasor form): V = 5 sin 10t 452 www 0.2…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

16 - An electric motor with a resistance of 8ohm draws a current of 1A from a battery with an internal resistance of 3ohm and an emf of 15V. What is the zit emf of the motor in volts? A) 3 B) 1 C) 5 D) 2 E) 4
(1.11) In roder to run a specific electric vehicle using de mior dove in a proper way, one of the following chopper drive circuit can be used a) Class-D de motor drive b) Class-E de motor deve d) Class C de motor drive e) A + B B + D None of the above.
A Series motor a current of 25 A when the supply voltage is 230V. If the total resistance of the motor is 3 0 and the Iron, Friction, Windage losses are 250 W. Find the efficiency of the motor.
A special electric motor required 1.962 kW and 9.5 amperes from a given voltage source of 220 V with 50 Hz frequency. What is the power factor of the motor?
A 240 V dc motor on brake test took 52 Amp when running at 1500 rpm. The spring balance at the end of the 76 cm brake arm reads 93.5 N. What is the efficiency of the motor at this load. [Ans. 90 %] write solution neatly
According to NEC Table 220.55, what would the demand load be for two ranges - one 14 kW andone 16 kW?A. 12.5 kWB. 11 kWC. 16 kWD. 12.65 kW
The field winding of a d.c. motor is connected to a 110V supply. At a temperature of 18°C, the current drawn is 0.575 A. After running the machine for some time the current has fallen to 0.475 A, the voltage remaining unchanged. Calculate the temperature of the winding under the new conditions, assuming that the temperature coefficient of resistance of copper is 0.004 26/°C at 0°C.
A power supply has a voltage regulation of 1 %. If the no-load voltage is 30 V, what is the full-load voltage?
6.a. When the number of poles in a squirrel-cage motor is changed from 4 to 8, the speed isA. not changedB. doubledC. reduced by half.D. increased four times.6.b.If the speed of a centrifugal pump is reduced to one-half the original value, the power will be reduced toA. one-sixteenth.B. one-eighth.C. one-quarterD. one-half.
The shaft power of a shunt motor is 7.8hp. It draws 50A from 120 V. The field winding draws 1.2 Amp. What is the efficiency of the motor?
Determine the output power of an electric motor that draws 8A from a 220V source and is 85% efficient. How much power is lost?
What is the power factor of a 1/2 HP motor with 115V and 15A power supply. Draw a diagram to support the answer