QUESTION 7 Suppose we have a ship in the ocean (water sp.gr - 1.034). The ship has freeboard (height of decks above water of 20 m. The draft is also 20 m... (distrance from bottom of keel to surface of water. Ship is rammed by som projectile at 10 m below waterline. The hole is 5 m². At what rate does water flood the ship? (m³/sec)

QUESTION 7 Suppose we have a ship in the ocean (water sp.gr - 1.034). The ship has freeboard (height of decks above water of 20 m. The draft is also 20 m... (distrance from bottom of keel to surface of water. Ship is rammed by som projectile at 10 m below waterline. The hole is 5 m². At what rate does water flood the ship? (m³/sec)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A cylindrical buoy 100mm in diameter and120mm high is placed vertically inside thetank. The tank is 150mm in diameter andcontains water 200mm deep and oil 30mmdeep. If the buoy weighs 5N, determine thedepth of the buoy submerged.
an open rectangular tank mounted on atruck is 8 m long and 1 m. wide. it is filled with water to a depth of 3.69 meters. if it is accelerated at 10.16 m/s^2 along its length, determine the required height (in meters) of the tank to prevent any water from spiling.
An open tank has a 3 m square horizontal section and weighs 3.5 kN. It contains water to a depth of 1.0 m. An unbalanced force of 15 kN is applied to the tank parallel to one of the pair of sides. Determine the minmimum height in meters of the tank in order to prevent any spillage. a.1.24 b.1.60 c.1.76 d.1.50
An open rectangular tank is 4m long, 2m wide and 2m high kounted on a truck full of waterm Calculate the volume of water spilled out when the truck from the rest accelerated 2.45 m/s^2
A pump draws water from a 20 cm diam suction pipe and discharges through a15 cm diam pipe in which the velocity is 3.60 m/s. The pressure is – 34. 465 kPaat A in the suction pipe. The 15 cm diam pipe discharges horizontally into air atC. To what height h above B can the water be raised if B is 1.8 m. above A and20 hp is delivered to the pump? Assume that the pump operates at 80 %efficiency and that the frictional loss in the pipe between A and C is 3 m. Determine the inclination angle at point C for the water stream to reach a range of 50 m. Also, calculate the maximum height that the water can go from the selected datum plane.
A square tank 1.20m on each side,3m deep is filled to a depth of 2.70m with water. A WOODEN CUBE having a specifix gravity of 0.5 measuring 60 cm on an edge is placed in the water so that it will float. A.) Determine the weight of the water displaced by the cube Choices: 2.12 kN,1.06kN,1.15kN,2.30kN B.)Determine the rise of water above the original liquid surface Choices: 0.15m,0.088m,0.075m,0.30m C.) Determine the change in pressure force on one side of the tank Choices: 2.84kN,2.55kN,2.42kN,2.75Kn
An orifice in the side of a tank discharges water under a head of 10ft. If the diameter of the orifice is 2m, the coefficient of contraction is 0.63 and the head lost is 0.80ft, determine the discharge.
A pool has a diameter of 393", and a water height of 3.67 m above ground. This is to be emptied by removing a plug that has a diameter of 2.46 cm, and 91' long horizontal pipe attached to the bottom of the pool. Solve for the maximum discharge, in L/s, of water through the pipe. Round your answer to 3 decimal places. Neglect frictional effects
A 50 mm diameter circular sharp-edged orifice at the side of a tank discharges water under a head of 3 m. If the coefficient of contraction Cc=0.63 and the headlost is 240 mm, compute the discharge and the coefficients of velocity Cv and discharge C.
an open circular vessel is 1m in diameter and 2m height. it contains water filled to a depth of 1.5m. if the cylinder rotates about its vertical axis, what is the pressure intensity at the corner of the bottom if w= 6 radians/second Unit of the correct answer: kPa
Find the belt thickness in meters 60 meters below the surface of the concrete arch dam to be constructed in a trapezoidal section valley with a maximum water level of 120 meters above the floor, 50 meters wide at the base and 160 meters wide at the maximum water level. (The belt center angle will be taken as 2.33 radians, Obeton=400 t/m2 and water=1 t/m3]a. Noneb. 4-7c. 7-10d. 1-4
Hydraulics (Metacentric Height) 1. A ship with a total displacement of 1,800 tonners rolls to one side thru an angle of 1 degree when a deck load of 5 tonners is moved laterally thru a distance of 4.5m. Compute the metacentric height for this particular position of the vessel. Note: Use 4 decimal places show FBD and full solution