Question(s): The physics of a bike generator. A generator is mounted on a bicycle to power a headlight. A small wheel on the shaft of the generator is pressed against the bike tire and turns the armature 44 times for each revolution of the tire. The tire has a radius of 0.33 m. The armature has 75 turns. Each turn has an area of 2.6 x 10-3 m² and rotates in a 0.10 T magnetic field. The peak emf generated is 6.0 V. What is the linear speed of the bike?

Question(s): The physics of a bike generator. A generator is mounted on a bicycle to power a headlight. A small wheel on the shaft of the generator is pressed against the bike tire and turns the armature 44 times for each revolution of the tire. The tire has a radius of 0.33 m. The armature has 75 turns. Each turn has an area of 2.6 x 10-3 m² and rotates in a 0.10 T magnetic field. The peak emf generated is 6.0 V. What is the linear speed of the bike?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter22: Magnetic Forces And Magnetic Fields

Section: Chapter Questions

Problem 16OQ: Solenoid A has length L and N turns, solenoid B has length 2L and N turns, and solenoid C has length...

See similar textbooks

Similar questions

A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.00 V when the wheels rotate at = 20.0 rad/s. (a) If the generator's magnetic field has magnitude B = 0.600 T with N = 100 turns, find the loop area A. (b) Find the time interval between the maximum emf of +6.00 V and the minimum emf of 6.00 V.
A single-turn square loop of wire, 2.00 cm on each edge, carries a clockwise current of 0.200 A. The loop is inside a solenoid, with the plane of the loop perpendicular to the magnetic field of the solenoid. The solenoid has 30.0 turns/cm and carries a clockwise current of 15.0 A. Find (a) the force on each side of the loop and (b) the torque acting on the loop.
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ23.9. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative.
A proton moving horizontally enters a region where a uniform magnetic field is directed perpendicular to the proton’s velocity as shown in Figure OQ22.4. After the proton enters the field, does it (a) deflect downward, with its speed remaining constant; (b) deflect upward, moving in a semicircular path with constant speed, and exit the field moving to the left; (c) continue to move in the horizontal direction with constant velocity; (d) move in a circular orbit and become trapped by the field; or (e) deflect out of the plane of the paper? Figure OQ22.4
In Figure P20.65 the rolling axle of length 1.50 m is pushed along horizontal rails at a constant speed v = 3.00 m/s. A resist or R = 0.400 is connected to the rails at points a and b, directly opposite each other. (The wheels make good electrical contact with the rails, so the axle, rails, and R form a closed-loop circuit. The only significant resistance in the circuit is R.) A uniform magnetic field B = 0.800 T is directed vertically downward. (a) Find the induced current I in the resistor. (b) What horizontal force F is required to keep the axle rolling at constant speed? (c) Which end of the resistor, a or b. is at the higher electric potential? (d) Alter the axle rolls past the resistor, does the current in R reverse direction? Explain your answer. Figure P20.65
Two long, parallel wires carry currents of 20.0 A and 10.0 A in opposite directions (Fig. OQ22.13). Which of the following statements is true? More than one statement may be correct. (a) In region I, the magnetic field is into the page and is never zero. (b) In region II, the field is into the page and can be zero. (c) In region III, it is possible for the field to be zero. (d) In region I, the magnetic field is out of the page and is never zero. (e) There are no points where the field is zero. Figure OQ22.13 Objective Questions 13 and 14.
A long, straight wire carries a current I (Fig. OQ30.8). Which of the following statements is tine regarding the magnetic field due to the wire? More than one statement may be correct, (a) The magnitude is proportional to I/r, and the direction is out of the page at P. (b) The magnitude is proportional to I/r2, and the direction is out of the page at P. (c) The magnitude is proportional to I/r, and the direction is into the page at P. (d) The magnitude is proportional to I/r2, and the direction is into the page at P. (e) The magnitude is proportional to I, but does not depend on r.
Two long, straight wires cross each other at a right angle, and each carries the same current I (Fig. OQ22.6). Which of the following statements is true regarding the total magnetic field due to the two wires at the various points in the figure? More than one statement may be correct. (a) The field is strongest at points B and D. (b) The field is strongest at points A and C. (c) The field is out of the page at point B and into the page at point D. (d) The field is out of the page at point C and out of the page at point D. (e) The field has the same magnitude at all four points. Figure OQ22.6
An election moves through a uniform electric field E = (2.50i + 5.00j) V/m and a uniform magnetic field B = 0.400k T. Determine the acceleration of the electron when it has a velocity v = 10.0i m/s.
A circular coil of five turns and a diameter of 30.0 cm is oriented in a vertical plane with its axis perpendicular to the horizontal component of the Earths magnetic field. A horizontal compass placed at the coils center is made to deflect 45.0 from magnetic north by a current of 0.600 A in the coil. (a) What is the horizontal component of the Earths magnetic field? (b) The current in the coil is switched off. A dip needle is a magnetic compass mounted so that it can rotate in a vertical north-south plane. At this location, a dip needle makes an angle of 13.0s from the vertical. What is the total magnitude of the Earths magnetic field at this location?
Review. A rod of mass 0.720 kg and radius 6.00 cm rests on two parallel rails (Fig. P28.23) that are d = 12.0 cm apart and L = 45.0 cm long. The rod carries a current of I = 48.0 A in the direction shown and rolls along the rails without slipping. A uniform magnetic field of magnitude 0.240 T is directed perpendicular to the rod and the rails. If it starts from rest, what is the speed of the rod as it leaves the rails? Figure P28.23 Problems 23 and 24.