Answered: recrystallization, a pure substance

Science

Chemistry

recrystallization, a pure substance

Chemistry for Today: General, Organic, and Biochemistry

9th Edition

ISBN:9781305960060

Author:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Publisher:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Chapter7: Sollutions And Colloids

Section: Chapter Questions

Problem 7.89E

See similar textbooks

Related questions

Q: The vapore pressure values for methanol/water mixture at 20oC are as follows: 97.66 torr (vapor…

A: 1. Solution - According to the question - Given - According to Raoult's law, p=p0×x p = partial…

Q: A solution is saturated at 25oC . It is then slowly cooled to 20oC with no change to the appearance…

Q: Sucrose, a product of sugarcane manufacturing process, is highly soluble in water like many sugars,…

A: Colligative properties of a solution depends on the amount of solute present in the solution, not on…

Q: Theoretically, the inherent viscosity for solutions (not pure solvents) should always be a.…

A: Inherent Viscosity ηi = ln ηr/c ln ηr is zero for puresolvent and increases with increasing…

Q: Distillation is best done at what speed? a) Very fast to avoid loss of material b) The rate of…

A: Distillation is a technique in which the mixture of non-reacting liquids can be separated. In…

Q: Describe the ideal condition/set-up for recrystallization of substances. What are the factors to…

A: A question about re-crystallization, which is to be accomplished.

Q: For a mixture comprised of 0.80 mol% of tokens and 0.20 mol % of cyclohexane. Boiling point of…

A: A boiling point of a substance or a mixture can be defined as the temperature at which the vapor…

Q: A mixture of ethane,propane and n-butane exists at -10°C at a total pressure of 3000 mmHg. Determine…

A: Assuming the mole fraction of propane is x in liquid phase. Hence mole fraction of n-butane is also…

Q: Discuss how relative humidity in a cold storage room can influence the vapor pressure deficit.

A: Interpretation - To discuss how relative humidity in a cold storage room can influence the vapor…

Q: Although both sugar and salt are soluble in water, how they dissolve is not shown the same in the…

Q: A pharmacist was called for the assay of a newly delivered sodium chloride. Prior to the assay, he…

A: The solution of the given question is

Q: Based on the calculated Δ?vap values, arrange the liquid samples in order from most ordered to least…

A: The degree of randomness in a system is measured in terms of entropy. The higher the entropy greater…

Q: If a non-polar mobile phase is used in a non-polar stationary phase, the polar components in a…

A: In the given question, the nature of chromatograpy is discussed based on the polarity concept of…

Q: The table below lists factors that may affect the rate at which solids and gases dissolve. Fill in…

Q: name: Binary liquid - vapor phase diagram (Binary liquid vapor system)

A: Answer is given as per order of question, it is given two images. Types answer is also provided…

Q: How can solid solution occur between materials?

A: Solid solutions occur between materials as follows.

Q: Why is it important to maintain the rock salt/ice mixture at a temperature of -10oC? A. Because it…

A: It is important to maintain the rock salt / ice mixture at a temperature of -10°C. This is because…

Q: Predict what will happen when a mixture of leaf pigments is placed on a piece of paper and solvent…

Q: Select all that apply. Select all processes below that are part of the dissolution process. Break…

A: From the dissolution process we get answer

Q: You've just synthesized a new molecule and need to purify it by recrystallization. You find that it…

A: Recrystallization is one of the purification method . Mostly used for purify solid organic…

Q: for liquid ethanol, list all of the intemolecular forces that have to be broken in order for it to…

A: all of the intemolecular forces in ethanol and biphenyl

Q: Activity Concept: THE EFFECT OF BOILING POINT AND FREEZING POINT ON THE DISSOLUTION OF SOLIDS IN…

Q: Explain and answer properly in recrystallization, after the crystals have formed (with cooling on…

A: Recrystallization This method is important for the purification of the non volatile organic…

Q: What are azeotropes, and how do they affect a distillation process? Azeotropic distillation is a…

A: In order to separate mixtures in a boiling liquid mixture, an approach called azeotropic…

Q: Compare and explain any trends for the change in temperature on evaporation for these liquids.…

A: The evaporation depends on the intermolecular forces (IMF) present among the molecules. The stronger…

Q: Describe the process inside the test tube during boiling point determination

A: Boiling Point is the temperature at which the vapour pressure of the liquid is equal to the…

Q: Can you interpret this graph. Normally on a temperature-composition phase diagram, there is a bubble…

A: Liquids that are miscible to each other to a limited extent are termed partially miscible liquids…

Q: following cooling curve between which two points is the pure solvent becoming frozen? Temperature…

A: Freezing point is the temperature at which the transition of phase takes place from liquid to solid…

Q: Using a methanol-water mixture as a solvent, a supersaturated solution of sodium chloride and…

A: supersaturated solution are in metastable state, when maximum solute which can be dissolved in…

Q: Why are refrigerants used within the vapour-compression system instead of water? They are easier to…

A: The solution is given below -

Q: …………………………………………...: Inflame skin tissue on contact. ……………………………………….……..: ignite spontaneously in…

A: (1)____________: Inflame skin tissue on contact.(2)____________: ignite spontaneously in…

Q: An ideal recrystallization solvent should have a large gradient of solubility along with…

A: A question based on analytical separation that is to be accomplished.

Q: After a recrystallization, a pure substance will ideally appear as a network of Choose. Choose... .…

A: A network of crystals having similar structure and size appeared during the recrystallization.

Q: atch the following: Freezing point depression The effect of supercooling Freezing point of pure…

A: Let us discuss the phase diagram first and then find out the respective points.

Q: which is an active ingredient of a fumigant insecticide that turns directly from solid to toxic…

A: Given : Fumigant insecticide To find: Active ingredients of Fumigant that turns directly from solid…

Q: I need this question about hydrogen peroxide answered about solid state and liquid state and other…

A: Hydrogen peroxide is commonly denoted as H2O2, used as a mild antiseptic on the skin to prevent…

Q: Suppose Student A prepares a fractionating column by filling a condenser with glass beads. His…

A: Fractional distillation :- It is the method used for the separation of liquids which have very less…

Q: a) An alcohol solution was prepared by adding enough water to 35. 0 mL of the alcohol to make a…

Q: An important lab safety rule is "never heat a closed system." This is because the pressure in a…

A: Given , lab safety rule is, never heat a closed system. A closed system is a physical system that…

Q: A 78 g container of containing a liquid solution is heated to 98⁰C. Another 3g of the same solution…

Q: The deviation of Raoult's law is associated with the unequal adhesive and cohesive forces-Justify…

A: Raoult’s law states that a solvent’s partial vapour pressure in a solution (or mixture) is equal or…

Q: (a) Powder metallurgy (PM) is a net-shape forming process by which fine powdered materials are…

A: 1. Because Powder metallurgy is like casting with powder so we can make any complex shapes which are…

Q: Determine the internal pressure in atmospheres (atm) needed for each of the 20 kernels to pop. Show…

A: Use ideal gas equation to solve for the internal pressure in each kernel,PV = nRT P = nRTV Given…

Q: We use to make yogurt in home many years ago. Sometimes the yogurt produced has a firm structure and…

A: Answer

Q: Describe why adding a solvent would either lower the vaper pressure of raise the boiling point.

A: For the solvent, the presence of the solute decreases its vapor pressure by dilution.This means in…

Q: Explain why one would recrystallize a solid from a solvent pair instead of a single solvent.…

A: Explain why one would recrystallize a solid from a solvent pair instead of a single solvent.…

Q: how do we find the average of the molar mass of these unkown liquid? how to express the water bath…

A: Given equation, MM = d × R × TP

Q: An ideal property of a solvent to be suitable for recrystallization of a solid sample is: Group of…

A: In recrystallization process an impure solid compound is dissolved (the impurities must also be…

Q: Cooling Curve/ Freezing Point Determination The solution must be continuously stirred while heating…

A: The solution must be continuously stirred while heating and cooling it. What will happen if it's not…

Question

After a recrystallization, a pure substance will ideally appear as a network of

Choose...smalllargeround

Choose...clumpspowderscrystals

. If this is not the case, it may be worthwhile to reheat the flask and allow the contents to cool more

Choose...completelyquicklyslowly

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

For the liquid acetone, list all IMFs that have to be broken in order for it to mix with water
Distillation is best done at what speed? a) Very fast to avoid loss of material b) The rate of distillation isn't all that important c) Very slow to get the best separation d) At a moderate speed, but no faster than a degree of equilibrium can be maintained
- What is the ideal solvent behavior for crystallization? - You will probably hear me say frequently: “minimum amount of hot solvent” during this lab. Why isthat?
Glacial acetic acid has a melting point of 16.0C and enthalpy of fusion of 11.7kJ/mol. a Calculate the cryoscopic constant of glacial acetic acid. b What is the freezing point of a solution of 27.6g of I2 dissolved in 73.3g of HC2H3O2?
7.19. At , the vapor pressure of pure ethanol, , is and the vapor pressure of pure n-propanol, is . What is the vapor pressure of a solution containing of each alcohol?
7.21. At , the vapor pressure of pure ethanol, , is and the vapor pressure of pure n-propanol, , is . A solution of the two alcohols has a vapor pressure of . What is the composition of the solution?
a Convert the calculated mole fraction of naphthalene dissolved in toluene from Example 7.10 into molarity, assuming that the volumes are strictly additive. The density of toluene is 0.866g/mL and density of naphthalene is 1.025g/mL. b Estimate the solubility, in g/100mL and molarity, of naphthalene in n-decane, C10H22, which has a density of 0.730g/mL.
7.16. Many police departments use breath tests to check for drunk drivers. What would be the approximate partial pressure of ethanol in expired breath if the blood alcohol content is approximately (that is, )? The equilibrium vapor pressure of at is . Use your answer to comment on the necessary sensitivity of the test.
DATA Note: Use the videos as references except when data is provided here. Table 1. Selection of Recrystallizing Solvent. Solvents Dissolution at room temperature? (+ or −) Dissolution at elevated temperature? (+ or −) Distilled water - - Acetone + n/a 95% ethanol - + Toluene + n/a Solid sample: Naphthalene Table 2. Mass Measurements. Mass, g Sample solid 0.5021 Empty watch glass 35.7602 Watch glass with recrystallized sample 36.2485 Table 3. Melting Point Determination. Temperature, oC Appearance of Sample in Capillary Tube … Solid 78.4 Solid 79.3 Solid with signs of liquid 79.9 Solid, liquid 80.6 Liquid, solid 81.3 Liquid with signs of solid … Liquid Theoretical Melting Point, oC: 80.2°C (176.4°F) QUESTIONS Which solvent should be used as the recrystallizing solvent? Check if your chosen solvent satisfies all characteristics of a good…
A pharmacist was called for the assay of a newly delivered sodium chloride. Prior to the assay, he must prepare and standardize a solution of silver nitrate in the usual way. The weight of dried precipitate was determined as 0.581 grams. Calculate for the concentration of the solution in normality. 1. What is the molecular weight of the standard solution? 2. What is the molecular weight of the precipitate? 3. What is the computed normality of silver nitrate?
An ideal recrystallization solvent should have a large gradient of solubility along with temperature, has the ability to dissolves the impurities very well and must not chemically react with the product. For each of the three reasons given, give an explanation for why they are a reason that make an ideal recrystallization solvent?
Determine the internal pressure in atmospheres (atm) needed for each of the 20 kernels to pop. Show complete solution.