[References) Use the References to access important values if needed for this question. The freezing point of ethanol, CH3CH,OH, is -117.300 °C at 1 atmosphere. K(ethanol) =-1.99 °C/m In a laboratory experiment, students synthesized a new compound and found that when 13.72 grams of the compound were dissolved in 204.2 grams of ethanol, the solution began to freeze at -118.030 °C. The compound was also found to be nonvolatile and a non-electrolyte. What is the molecular weight they determined for this compound ? g/mol Submit Answer Retry Entire Group 9 more group attempts remaining

[References) Use the References to access important values if needed for this question. The freezing point of ethanol, CH3CH,OH, is -117.300 °C at 1 atmosphere. K(ethanol) =-1.99 °C/m In a laboratory experiment, students synthesized a new compound and found that when 13.72 grams of the compound were dissolved in 204.2 grams of ethanol, the solution began to freeze at -118.030 °C. The compound was also found to be nonvolatile and a non-electrolyte. What is the molecular weight they determined for this compound ? g/mol Submit Answer Retry Entire Group 9 more group attempts remaining

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 109AE: Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray...

See similar textbooks

Similar questions

Use the follow data below and answer the following questions: Component Concentration (mg/L) CO2 8 Ca2+ 45 Mg2+ 13 Sr2+ 12 Alkalinity 270 Determine the quantity (mass flow) of CaO and Soda Ash using practical solubility limit required to treat hard water taking volumetric flow as 145000 L/d and pH of 7.5 and purity of both reagents as 97%.
ANSWER THEM ALL FOR AN UPVOTE. ASAP PLEASE. The theoretical weight of 10 tablets is 9.35g. Each tablet contains 425mg of the active ingredient. Using this data, determine the amount of additive needed to prepare 160, 000 tablets. How many grams of drug are required to make 500ml of 25.0% solution?
1) How many milliliters of 70% ethanol and 20% ethanol must be mixed to prepare 500ml of 30% ethanol? 2) A gaseous blend of nitric oxide and nitrogen (NOmax) contains 0.09% v/v nitric oxide (NO) and 99.92% v/v nitrogen. Express the strength of nitric oxide in PPM (round to whole number) 3) The ratio strength of a 10mL vial of neostigmine methylsulfate injection USP is 1:1500.Calculate the amount of neostigmine methylsulfate in milligrams contained in the 10mL vial. (Round to the whole number).
physical chemistry Roughly, what is the error introduced by the solution of some of the CO2 in the water in the bomb? The solubility of CO2 is about 0.0015 g/mL at 25°C and 1 atm CO2 pressure. The heat of solution of CO2 in a dilute aqueous solution is roughly -19.4 kJ/mol. Assume that the final CO2 pressure is 2 atm and that Henry's Law applies.
Use the attached pictures to help fill in the rest of the data. Please note that I used 0.79g of KMnO4 to prepare 250ml of 0.02M solution to titrate the ferrous ammonium sulfate. The approximate 1g of ferrous ammonium sulfate contained 25ml of distilled water and 10ml of 1M H2SO4 : H3PO4 to help dissolve the mixture for part one. For part two, the same steps were used however, we are to determin the amount of Fe in the sample. Please show and explain your work for each trail. Thank you!
Gypsum (CaSO4) is a common percipitant in water desalination. CaSO4 <=> Ca2+ + SO42- where Ksp=10-4.6. Assuming that: [Ca2+]=2x10-2 M; [SO42-]=2x10-3M: a) Find Qsp or IAP for the given water b) Find the solubility index (SI) and determine whether CaSO4 is under, super, or at saturation in water. Feel free to make any assumptions you wish, as long as they're stated.
The Henry’s law constant for the solubility of radon inwater at 300C is 9.57 x 10-6 M/mm Hg. Radon is presentwith other gases in a sample taken from an aquifer at 300C.Radon has a mole fraction of 2.7 x 10-6 in the gaseous mixture. The gaseous mixture is shaken with water at a totalpressure of 28 atm. Calculate the concentration of radonin the water. Express your answers using the following concentration units.(a) molarity(b) ppm (Assume that the water sample has a density of1.00 g/mL.)
Calculate the solubility of CuCO3 in water at 25C. Ksp = 3.00x10-12. Round the answer to two significant figures.
Need solution to all parts urgently The solubility of 1,1,2-trichloroethane in water is 4500 mg/l; the vapor pressure is 30.0 mm Hg. Compute Henry’s constant in units of: a) atm b) dimensionless mole fraction c) atm∙m3/mol d) dimensionless concentration
Describe the solution's preparation: i). 500 mL 0.250 M ethylene glycol (MW = 62.07) from a concentrated 31 % (w/w)solution that has a density of 1.0350 g/mL ii) 2.00 L of 0.108 M BaCl2 from BaCl2.2H2O salt iii) 750 mL of 6.00 M H3PO4 from the commercial reagent that is 86% H3PO4 (w/w)and has specific gravity of 1.71.
In a solution containing 25ml (NH4)2S2O8 with a total volume = 100 ml =0.1 liters , the solution composition are shown below.Note; the solution require 25ml of 0.2M S2O8^-2.SOLUTION Kl KNO3 EDTA Na2S2O3 STARCH50ml 23ml 1 drop 1 ml 10 dropsExperiment; initial (S2O8-2) =0.05M ; INITIAL (l-)=0.10 Mml of S2O3^-2 added Time in minutes and seconds for color change Cumulative time in seconds Total moles of S2O8^-2 consumed1 1:43 2.0 x 10^-42 1:20 4.0 x 10^-43 1:13 6.0 x 10 ^-44 1.17 8.0 x 10 ^-45 1.24 10 x 10 ^-41a) Find the cumulative time in secondsb) for the runs ,plot mole of S2O8^2- REACTION vs. time in seconds2) Draw a straight line through ( origin ) the points and calculate the slope3) divide the value of the slope by the total volume of ( 0.1 L) to get the rate in units of M/s4) find the rate5 )calculate x and y and k
Determine the distance traveled by the solvent if the solute travels 3.1 cm. The weight of the analyte measures 0.984 mg with an Rf value of 0.647. Note: Express answers up to TWO decimal places. Distance traveled by the solvent = cm