Question
Asked May 16, 2019
251 views
Refrigerant R-134a enters an adiabatic compressor as saturated vapor at 100kPa at a rate of
0.5kg/s and exits at 1 MPa pressure. If the isentropic efficiency is 85%, what is the temperature
of the refrigerant at the exit of the compressor?

Image Transcription

Refrigerant R-134a enters an adiabatic compressor as saturated vapor at 100kPa at a rate of 0.5kg/s and exits at 1 MPa pressure. If the isentropic efficiency is 85%, what is the temperature of the refrigerant at the exit of the compressor?

Expert Answer

1 Rating

Want to see the step-by-step answer?

See Answer

Check out a sample Q&A here.

Want to see this answer and more?

Step-by-step answers are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Answer
*Response times may vary by subject and question.
Tagged in

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A

Q: What number would you divide by to calculate the mean of 3, 4, 5, and 6?

A: We can find the mean of “N” numbers by using the following relation:

Q: Two humid airstreams are adiabatically mixed at 1 atm pressure to form a third stream. The first str...

A: Refer “psychometric chart at 1 atm total pressure”, for a dry bulb temperature of 100 degree Fahrenh...

Q: Steam enters a turbine operating at a steady state at a pressure of 4 MPa, at temperature of 400 deg...

A: Write the energy balance equation for the steady flow turbine as given as follows:

Q: What formula do I use? A cylinder of diameter 122 mm and length of 200mm is placed inside a concentr...

A: Write the expression for the specific gravity:

Q: 2.56 In Fig. P2.56 pipe A contains gasoline (SG = 0.7), pipe B contains oil (SG = 0.9), and the mano...

A: Write the expression of pressure at the interface between gasoline and mercury on the left column. 

Q: Pearson's MyLab & MasteringMasteringEngineering Mastering x+ C https://session.masteringengineering....

A: The velocity of the airplane is constant at point A, the speed is vp = 80 ft/sThe weight of the pilo...

Q: QUESTION 9 In a jet engine rotor the high pressure axial compressor rotates at a speed of 15000 rpm....

A:  Write the expression to calculate the polytropic efficiency of compressor.

Q: Consider a simple Brayton cycle that uses air as the working fluid to operate a gas-turbine power pl...

A: Given information:

Q: Steam enters the first-stage turbine shown in the figure at 40 bar and 4500C with a mass flow rate o...

A: Draw the temperature versus entropy curve for the expansion process of steam through two turbines vi...