Road test Report is Overhaul all four-wheel brakes and the Universal joints After the maintenance operation is completed, the road test inspector or the machine creates the road test report In case of diesel engines overhaul injectors, besides the above items of wash, all the items mentioned in the monthly maintenance schedule should be carried out during quarterly maintenance also. During service, remove and clean shackle pin if necessary O Skip

Road test Report is Overhaul all four-wheel brakes and the Universal joints After the maintenance operation is completed, the road test inspector or the machine creates the road test report In case of diesel engines overhaul injectors, besides the above items of wash, all the items mentioned in the monthly maintenance schedule should be carried out during quarterly maintenance also. During service, remove and clean shackle pin if necessary O Skip

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter10: Engine Disassembly And Cleaning

Section: Chapter Questions

Problem 5RQ

See similar textbooks

Similar questions

If one wanted to calculate braking friction on the braking pad, one would need to know Question 1 options: crank arm length coefficient of static friction wheel diameter coefficient of kinetic friction
While conducting a bounce test: Technician A says that the bumper should be pushed two or three times downward with considerable weight applied on each corner of the vehicle. The bumper should be released after each push and the vehicle should oscillate about 1½ cycles and then settle. Technician B says that one free upward bounce should stop the vertical chassis movement if the shock absorber or strut provides proper spring control. If the vehicle’s bumper does more than 1½ free upward bounces, the shock absorber or strut is defective. Who is correct?
Give two (2) examples of light vehicle automatic transmission and driveline system faults chosen from electronically controlled automatic transmissions continuously variable transmissions (CVTs) constant velocity joints Hookes-type joints rear wheel drive shafts rear wheel drive final drives front wheel drive final drives for each of the following: (5 - 10 words each) Intermittent faults Multi-system faults Introduced as a result of a system repair Indirect, caused by the influence of external systems
Besides indicating ABS faults for some systems, the red brake warning lamp on the instrument panel can indicate failure of the brake system, application of the brake, or low fluid level in the.
When servicing transfer cases, all of the following are correct, except_____. a. it must be supported on a transmission jack or safety stands b. the chain drive and a planetary gearset must be adjusted to specifications c. visual inspections for leaks and damage are necessary d. follow the manufacturers recommendations for lubricants
Technician A says that each ABS has its own diagnostic procedure involving use of the brake and antilock warning lamps, special testers, breakout boxes, scan tools, troubleshooting charts, and wiring diagrams. Technician B says that ABSs vary in the number of codes they can store and whether they will retain the code in memory when the ignition is turned off. Who is correct? Technician A only Technician B only Both A and B Neither A nor B
While discussing pull during braking: Technician A says that this can be caused by one tire being underinflated. Technician B says that a frozen wheel cylinder on one side of the car can cause this. Who is correct? Technician A only Technician B only Both A and B Neither A nor B
Technician A says that on FWD vehicles, the front wheels toe-out while the rear wheels on an independent suspension try to toe-in as the vehicle moves ahead. Technician B says that on RWD vehicles, the front wheels tend to toe-in while the rear wheels toe-out in response to rolling resistance as suspension compliance. Who is correct?
What is benefit of bifilar suspension technique?
Define Braking loads
Braking torque applied?
What is the disadvantage of dynamic brakes when compared to mechanical brakes?