Sari stood at a point measured 20 meters away from the base of building A. Tuming 40° to building B, she determined that the base of that building was 25 meters away. How far apart were the buildings? Use a calculator if needed. building 8 000 18 25 m 40° Sari X building A 20 m 16 meters 45 meters 20 meters 40 meters 5 meters O O O O

Sari stood at a point measured 20 meters away from the base of building A. Tuming 40° to building B, she determined that the base of that building was 25 meters away. How far apart were the buildings? Use a calculator if needed. building 8 000 18 25 m 40° Sari X building A 20 m 16 meters 45 meters 20 meters 40 meters 5 meters O O O O

Elementary Geometry For College Students, 7e

7th Edition

ISBN:9781337614085

Author:Alexander, Daniel C.; Koeberlein, Geralyn M.

Publisher:Alexander, Daniel C.; Koeberlein, Geralyn M.

Chapter2: Parallel Lines

Section2.6: Symmetry And Transformations

Problem 26E: Considering that the consecutive dials on the natural gas meter rotate in opposite directions, what...

See similar textbooks

Similar questions

The length, L, of the point on any standard 118° included angle drill, as shown in Figure 12-5, can be calculated using the formula L=0.3 O where represents the diameter of the drill. Determine the lengths of the following drill points with the given diameters. Round to 3 decimal places for inches and 1 decimal place for millimeters. a. 12 b. 14 c. 38 d. 10 mm e. 25 mm f. 45 mm
Find the metal area of the washer in Figure 29-6. Round the answer to the nearest tenth.
Find the size of A to the nearest second?
Considering that the consecutive dials on the natural gas meter rotate in opposite directions, what is the current reading in cubic feet of usage? The initial direction is clockwise.
Refer to the drill jig shown. Determine 1.
The length, L, of the point on any standard 82° included angle drill can be calculated using the formula L = 0.575 , where represents the diameter of the drill. Determine the lengths of the following drill points with the given diameters. Round to 3 decimal places for inches and 1 decimal place for millimeters. a. 12 b. 14 c. 38 d. 10 mm e. 25 mm f. 45 mm
All sections of the block in Figure 13-9 are equal in length. Determine the length A to the nearest thousandth millimeter.
Measure the lengths of g-k in Figure 30-26 to the nearer whole millimeter.