Answered: small appliances circuits used in…

Engineering

Electrical Engineering

small appliances circuits used in dwellings must be calculated on the basis of not less than ____ watts each

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter3: Determining The Required Number Of Branch Circuits, Lighting Outlets, And Receptacle Outlets

Section: Chapter Questions

Problem 11R: What is the minimum number of 15-ampere lighting branch circuits required if the dwelling has an...

See similar textbooks

Related questions

Q: Which of the following sub-station have lesser clearance between equipments. a. Underground…

A: The clearance between the substations depends on the dielectric/insulation between the equipment. In…

Q: The service size of a main service panel can be found by reading the rating printed on the main…

A: Main electrical service delievering to the houses from the company of electrical utility, it have…

Q: The installation of luminaires, lighting outlets, and supports is covered in Article 410 of the…

A: In electrical work, a rough-in means that all electrical cables have been pulled through studs and…

Q: 1. A single receptacle installed on an individual branch circuit must be rated at least _ pecenrt of…

A: NOTE – As your query contains multiple questions and it is not mentioned which question has to be…

Q: What spaces are not included in floor area when calculating the load in volt amperes per square…

A: For calculating the load, first evaluated the total floor area. And according to the NEC , the total…

Q: When applying the general provisions for receptacle spacing to the rooms of a dwelling unit, which…

A: Article NEC 210.52(A)(1) states that the receptacles shall be installed such that no point measured…

Q: What wattage was used for each vanity Luminaire to calculate the estimated load on circuit a 14?

A: Circuit A-14 uses the 15-ampere branch current for the circuit. This circuit provides the…

Q: 3. What wattage was used for each vanity luminaire to calculate the estimated load on Circuit A14?…

A: From the given question,since it has multiple parts we will answer the first three subparts , if you…

Q: Which of the following statement is correct for the indoor substations?

A: A substation in which the contraption is prepared inside the substation building is called indoor…

Q: Ali is located in portion number-2 in a long warehouse in company A. ASsuming that the wiring type…

A: Consider the given connection.The live connection and the neutral connection for the arrangement is…

Q: Label the parts of Lattice Steel Towers.

A: Lattice Steel Tower Lattice steel tower means an independent standing perpendicular steel tower.…

Q: Grounding Lighting Fixtures. There are specific requirements for grounding lighting fixtures. How…

A: The electrical lighting fixtures need to be grounded to limit the voltage to ground on these…

Q: What is the maximum number of 15 ampere lighting circuits required if the dwelling has an occupied…

A: Refer the table 220.12 from the NEC, the minimum load requirements for the dwelling load unit is,

Q: A stand-alone pedestrian crossing sign is located in Miami, FL. The sign is lit 24/7 with tiny LED…

A: According to the question, Determine if the designers provided the right type of equipment for…

Q: 9/ The Underground Cable operating at a Nominal Voltage of 36 KV is classified as Super Tension…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: hat is the receptacle demand load for a 9600 square foot office building with 52 receptacles

A: As per the regulation of national electrical code, a minimum requirement of 180VA must be used for…

Q: At most cellular sites there is three legged tower. To maintain proper grounding, only one leg needs…

A: At most cellular sites there is three legged tower. To maintain proper grounding, only one leg needs…

Q: Which of the following type of insulation can be installed underground?

Q: Nec article 210 q.#1 the rating of a branch circuit shall bedetermined by the rating of the?

Q: ___ refers to the portion of electric conductors that extends form the service entrance to an outlet…

A: Premises wiring: It is a wiring system covers interior and exterior wiring that extends from the…

Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two…

Q: 11. Time switches shall be of the enclosed type or mounted in suitable enclosures. 12. The minimum…

Q: Circuit Breakers are placed in several places in a Power System as part of its Protection System.…

A: Given Circuit breaker is used several part of the power system True or false

Q: If an equipment bonding jumper is run external to a raceway, it must be less than _______ feet.

A: If an equipment bonding jumper is run external to a raceway , it must be less than 6 feet.

Q: 63. The lowest point of attachment for a service drop to a building is 12

A: Since you have asked multiple question ,we will slove the first question for you .If you want any…

Q: Kitchen B7 AA R

Q: 8. a. The NEC in Section protected. requires that all receptacles in bathrooms be

A: National Electrical Code providing the guidelines regarding the installation of the receptacles in…

Q: 5. What wattage for the clothes closet luminaires was used for calculating their contribu- tion to…

A: The wattage of closet luminous for,

Q: Determine the correct sequence of electricity.1 :flow to the consumer installation (answer can be…

A: There are certain sequence of connection when an electricity connection is provided to the…

Q: TUBULAR OR COMPACT FLOURESCENT LIGHT PINLIGHT WITH COMPACT FLOURESCENT BULB THE ELECTRICAL…

A: Every electrical equipment and devices are represented by the symbols for easy to understandable and…

Q: draw single line diagram of 33kv substation with explanation and not copied from anywhere

A: Single-Line Diagram or SLD A single-line diagram (SLD) is the simplest of the diagrams used to…

Q: When a service is supplies by a grounded system, the ________ is required to be routed from the…

A: System is said to be grounded if it is connected to the earth by any conductive path inorder to…

Q: Question 8.a Which article of the NEC describes the proper placement of outlets in this type of…

A: The Given is article of the NEC describes the proper placement of outlets in this type of room.

Q: True or False: Electrical Fire is often caused by the reasonable care in the maintenance and use of…

A: Electrical fire is often caused by the reasonable care in the maintenance and use of electrical…

Q: What is the demand load for the service for two 3.5-kW wall-mounted ovens and one 5-kW…

A: Here, we have given a problem related to the load demand required for the equipments used by a…

Q: 310.12 re: Single-phase dwelling services-feeders YOUR TURN # 21-A: What size service conductors are…

A: Here we need to determine the size of service conductors, which are required if the calculated load…

Q: What is the minimum height of electrical service entrance

A: The Minimum Height for an Electric Service Meter is actually specified by the local electric utility…

Q: The house department of Government plants to undertake four housing projects and lists material…

A: Given parameters are: 6800 gallons of paint. 1420000 cubic feet of wood. 64 million bricks. 448000…

Q: small appliance receptacles included in the 3 volt-ampere per square foot load calculation

A: Small appliances receptacles are those circuits devoted for the utilization of interfacing little…

Q: what is the computed load for a cooktop unit with a nameplate rating of 6kW

A: Table 220.19 shown below applies to household cooking appliances (rated over 1,750W). Given name…

Q: A single Phase, 86 ampere loaf is located 2800 ft (853m) from the 480-volt electrical power source.…

A: In the given question, a load is 86 ampere that is carried by the aluminum conductor. Hence, the…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

small appliances circuits used in dwellings must be calculated on the basis of not less than ____ watts each

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the minimum number of 15-ampere lighting branch circuits required if the dwelling has an occupied area of 4000 ft2 (368 m2)? Show all calculations.
What is the calculated load when fixed electric heating is used in a residence? (220.51)
The branch circuit supplying a fixed electric space heater must be sized to at least ___________ percent of the heaters rating according to NEC ________________.
A sound level meter is placed in front of a loudspeaker of a 60W audio system reads 70dB. All else being equal, when placed in front of a 120W system, the meter will read ________?
What spaces are not included in the floor area when calculating the load in volt-amperes per square foot? See NEC 220.12. __________
For this residence, what are the estimated wattages used in determining the loading of branch circuit A16? Receptacles ___________________ watts (volt-amperes) Clothes closet fixture ___________________ watts (volt-amperes)
A ladder is used to reach the top of a building 16 feet tall. What distance should the bottom of the ladder be placed from the side of the building?
If a residence has two bathrooms, the Code states: a. The receptacles in each bathroom must be connected to a separate 20-ampere branch circuit. For two bathrooms, this would mean two circuits. (True) (False) (Circle the correct answer.) b. The receptacles in both bathrooms are permitted to be served by the same 20-ampere branch circuit. (True) (False) (Circle the correct answer.)
Duplex receptacles connected to the 20-ampere small-appliance branch circuits in kitchens and dining rooms (Circle the correct answer): a. may be rated 15 amperes.(True)(False) b. must be rated 15 amperes.(True)(False) c. may be rated 20 amperes.(True)(False) d. must be rated 20 amperes.(True)(False)
A single Phase, 86 ampere loaf is located 2800 ft (853m) from the 480-volt electrical power source. What size aluminum conductors should be installed if the voltage drop can not exceed 3%
Question 7 This question related to power system analysis. Please make sure that the solution is clear and detailed.
We want to install the 2000-meter wire in the college building, which one testing is the most important before installing the wire in the building and how?