Answered: Some devices often used in bathrooms,…

Some devices often used in bathrooms, such as hairdryers, often have safety messages saying “Do not use when the bathtub or basin is full of water.” Why is this so?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 10.1CYU: Check Your Understanding If you place a wire directly across the two terminal of a battery,...

See similar textbooks

Related questions

Q: What happens when a lightbulb burns out?

A: Introduction: The flow rate of electric charge through a conductor is known as electric current.

Q: 1.Four 10-Ω resistors are connected in parallel and the combination is connected to a 20-V emf…

A: The circuit diagram for the given question can be drawn as, The current (i) flowing in the circuit…

Q: Two bulbs are fitted in a room in the domestic electric installation. One of them glows brighter…

A: In a domestic electric installation, all the appliances will be connected parallelly, therefore,…

Q: A student used the following circuit to "Verify the Ohm's Law". He drew a graph between Voltage and…

A: Ohm's law states that the current through the conductor between two points is directly proportional…

Q: When a battery is connected to a lightbulb properly, current flows through the lightbulb and makes…

A: Current flows

Q: 1.Four 20-2 resistors are connected in parallel and the combination is connected to a 20-V emf…

A: Given: Resistance R=20 Ω emf given ε=20 V

Q: 10-floor apartment has an average of 12 electrical circuits per apartment, and there are 11…

A: Given number of floor =10 Number of apartment per floor =11

Q: Consider the circuit in the figure. 8.0 N ww 3.3 N 8.0 N 5.0 N ww 1.0 N ww 15.0 N ww 12.0 V 3.3 N…

A: Please see the answer below.

Q: If the potential difference across a resistor is doubled * a)current and resistance are doubled…

A: it is mentioned to explain what happens when a potential difference is doubled across the resistor.…

Q: Mel Lin, an engineering professor sets up the circ snown in the figure. The reading of the voltmeter…

A: According to ohms law - V=IR Reading of Voltmeter and Ammeter are - Vr=6.50 vIr=2.50 mA1 A = 1000…

Q: When current flows through a resistor,(a) some of the charge is used up by the resistor.(b) some of…

A: current flows through a resistor

Q: "Ir the voltage is increased, then the electrical energy will be (keeping Resistance and time…

A: As we know that, P = V^2 / R and P = E/T E = (V^2 * T)/ R By the above relation. The correct answer…

Q: Conductors are materials that obey Ohm's law. Which parameter is not part of this law? current…

A: Ohm's law V = IR Current, voltage and resistance are part of these formula So, power is not part…

Q: Why does the bulb explode? a. The battery provide a very small resistance b. the battery provided…

A: Bulb will explode when it received more wattage than it's limit. So the higher voltage provided too…

Q: The figure shows three identical light bulbs hooked up to a battery with no internal resistance. If…

Q: Ritche The potential difference across a 100 ohm resistor is 4.0 volts . What is the power…

A: All three resistance connect in parallel

Q: es of 2.0 Ω, 4.0 Ω, and 6.0 Ω and a 24-V emf device are all in p

A: GivenResistances of 2.0 Ω, 4.0 Ω, and 6.0 Ω emfV=24 V

Q: Which resistor in the following figure consumes the largest power? 30 100 10 V O 30 O 50 O All…

A: We know the expression for power is P=V2RP∝ V2P∝1R From the above expression we can seen that power…

Q: In the circuit given below, the batteries have negligible resistance. Determine the following: (a)…

A: We will solve this question using krinchoff's law .

Q: . In the circuit shown in Fig. 19–79, the 33-N resistor dissi- pates 0.80 W. What is the battery…

A: Write the expression for the power dissipated by 33 Ω resistor, and determine the current flowing…

Q: One electrical appliance operates with a voltage of 120 V, while another operates with 240 V. Based…

A: The power is defined as P = V2/R This shows that power dwpends on voltage as well as resistance of…

Q: Gloria, a lab technician for an electronics company sets up the circuit shown in the figure. The…

Q: An aluminum wire has a diameter of 2.59 mm. How many meters of this wire is needed to give a…

Q: You have likely been warned to avoid contact with electrical appliances or even electrical outlets…

A: Wet hands have less resistance compared to dry hands. When the resistance is decreased, the…

Q: In the circuit shown below, R1 = 3 ohms, R2 = 2 ohms, R3 = 5 ohms, 1 = 4 V, 2 = 10 V, and 3 = 6 V.…

Q: In this circuit, the current through the 5-W resistor is approximately 100 V 5 0 10 0 10 0 4 A 20 A…

Q: ammeter is always connected

Q: Rank according to magnitude of đifference in potential between points N and M from largest to…

A: In 'n' identical resistors connected in series, Rnet = nR Vi = Vn In 'n' identical resistors…

Q: In general, classification of sensors could be given as active and passive sensors, but not as…

A: False True

Q: T or F A resistor’s voltage is inversely proportional to the current through it.

A: Ohm's law gives us a relation between the voltage, current, and resistance. With this law, we will…

Q: 2. Rank in order, from largest to smallest, the resistances Ri to R4 of the four resistors. 2 V 2 V…

Q: A 120-Ohm resistor is in series with unknown resistor. The voltage drop across the unknown resistor…

A: Given data: The resistance of the resistor, R1=120 Ω. The voltage drop across the unknown resistor,…

Q: Which of these statements correctly describes the relation between the resistance of the light bulb…

A: Resistance of the light bulb increases as the temperature of its filament increases. The current in…

Q: TC) P (atm) 1.00 20 1.07 100 1.37 -33 0.88 -196 0.28

A: Given variation of, Pressure - temperature T oC P(atm) 0 1.00 20 1.07 100 1.37 -33 0.88…

Q: 3.0 S2 3.0 23 E 3.0 2 3.0 02

A: The three 3 ohm resistors are connected in series. So, R1 equivalent = 3+3+3 = 9 ohm

Q: The potential difference across the ends of a wire is doubled in magnitude. If Ohm's law is obeyed,…

A: The potential difference across the end of the wire is doubled in magnitude.

Q: One should not connect a number of electrical appliances to the same power socket because: A. this…

Q: Which of the following statements is not true regarding the arrangement of resistors shown in the…

A: We need to tell which of the following statement is not true 1. Resistors R2 and R3 are connected…

Q: The equivalent resistance of the resistors below is about: w 3Ω 5Ω M_M_ m O 13.7 2 O The answer is…

A: solution s given as

Q: The current I flowing in resistor R in the circuit shown in Figure is: A r2 E, E2 12 D A) ta) 12 -…

Q: Are household circuits normally wired in series or in parallel? Why?

Q: If the metal case of an appliance comes in contact with a live wire and it does not have a ground…

A: Electric current is only passed only if a circuit is closed! If a human comes in contact with the…

Q: The metal case of an appliance with ground wire comes in contact with a live wire. The circuit…

A: The metal case of an appliance with ground wire comes in contact with a live wire. The circuit…

Q: The power consumed by a device drawing a 0.8 A when connected to 120 V is A) 12 W B) 15 W C) 60 W D)…

Q: The current supplied to a lamp with a 100-W light bulb is 0.87 amps. The lamp is wired using a…

A: Power = 100 W current (I) = 0.87 A diameter of the wire = 2.588 mm

Q: A thermometer made of Platinum has a resistance of 50 2 at 20 C, what is the measured temperature…

Question

Some devices often used in bathrooms, such as hairdryers, often have safety messages saying “Do not use when the bathtub or basin is full of water.” Why is this so?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Trending now

This is a popular solution!

Step by step

Solved in 7 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Why is it possible for a bird to sit on a high-voltage wire without being electrocuted?
The immediate cause of many deaths is ventricular fibrillation, an uncoordinated quivering of the heart, as opposed to proper beating. An electric shock to the chest can cause momentary paralysis of the heart muscle, after which the heart will sometimes start organized beating again. A defibrillator is a device that applies a strong electric shock to the chest over a time of a few milliseconds. The device contains a capacitor of a few microfarads, charged to several thousand volts. Electrodes called paddles, about 8 cm across and coated with conducting paste, are held against the chest on both sides of the heart. Their handles are insulated to prevent injury to the operator, who calls Clear! and pushes a button on one paddle to discharge the capacitor through the patient's chest Assume an energy of 3.00 102 W s is to be delivered from a 30.0-F capacitor. To what potential difference must it be charged?
The batteries of a submerged non-nuclear submarine supply 1000 A at full speed ahead. How long does it take to move Avogadro’s number (6.02 1023) of electrons at this rate?
Check Your Understanding Verify that /V and e0/d have the same physical units.
When working with high-power electric circuits, it is advised that whenever possible, you work "one-handed” or “keep one hand in your pocket." Why is this a sensible suggestion?
Check Your Understanding Digital meters are able to detect smaller currents than analog meters employing galvanometers. How does this explain their ability to measure voltage and current more accurately than analog meters?
The immediate cause of many deaths is ventricular fibrillation, an uncoordinated quivering of the heart, as opposed to proper beating. An electric shock to the chest can cause momentary paralysis of the heart muscle, after which the heart will sometimes start organized beating again. A defibrillator is a device that applies a strong electric shock to the chest over a time of a few milliseconds. The device contains a capacitor of a few microfarads, charged to several thousand volts. Electrodes called paddles, about 8 cm across and coated with conducting paste, are held against the chest on both sides of the heart. Their handles are insulated to prevent injury to the operator, who calls Clear! and pushes a button on one paddle to discharge the capacitor through the patient's chest Assume an energy of 3.00 102 W s is to be delivered from a 30.0-F capacitor. To what potential difference must it be charged?
When does an incandescent lightbulb carry more current? (a) immediately after it is turned on and the glow of the metal filament is increasing or (b) after it has been on for a few milliseconds and the glow is steady?
Check Your Understanding If you place a wire directly across the two terminal of a battery, effectively shorting out the terminals, the battery will begin to get hot. Wiry do you suppose this happens?
Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
Three identical 60.0-W, 120-V lightbulbs are connected across a 120-V power source as shown in Figure P28.72. Assuming the resistance of each lightbulb is constant (even though in reality the resistance might increase markedly with current), find (a) the total power supplied by the power source and (b) the potential difference across each lightbulb.
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.