Suppose that after delivery several drops of water cling to the inner wall of the pipet (because the pipet wall is dirty). Will this technique error increase, decrease, or have no effect on the reported density of the water? Explain.

Suppose that after delivery several drops of water cling to the inner wall of the pipet (because the pipet wall is dirty). Will this technique error increase, decrease, or have no effect on the reported density of the water? Explain.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter91: Gas Chromatography

Section: Chapter Questions

Problem 5P

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: A sample of coarse grained soil 50 mm in diameter and 150 mm long was tested in a constant-head…

Q: For samples with broad boiling points components in GC separations, it is important to establish…

A: The solution is given below -

Q: What are diffusion controlled method?

A: Diffusion-controlled method: Diffusion-controlled Method involves the reactions in which the rate of…

Q: The Gouy balance is working by making use of the interaction between the magnetic fiel and

A: A Gouy balance is used to determine the magnetic susceptibility of a substance. A strong magnet is…

Q: .A. Name 2 parameters must be controlled in a sampled current polarographic experiment to ensure…

A: The solutions in which the amount of the solute present in a solvent volume is pressed by the term…

Q: What other method besides conductivity can be used to determine CMC (critical micelle…

A: Critical micelle concentration (CMC) can be determined by conductometric titration.

Q: The original solution was diluted by a factor of three, and then the absorbance of the diluted…

A: According to Lambert Beer law, the absorbance of a solution is directly proportional to its…

Q: Centripetal and centrifugal force which involve in manetic field mass analyzer.

A: The mass spectrometer is an instrument that is used to measure the masses and relative…

Q: Use the data below to determine your Unknown material. Data for all wet chemical tests and…

A: We can determine unknown material step by step which is given below.

Q: ve, if the 1 mm sample was heated at 10

A: In this question we have to tell that what we expect for an approximate melting point according to…

Q: An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of 0.95 min-1 .…

Q: (Drag and drop into the appropriate area) Most 0.060 M H2SO3 (diprotic) 0.075 M HNO2 (monoprotic)…

A: In this determine the concentration of H+ ions from each acid. More is the concentration of H+ more…

Q: A colored band shows an excessive amount of tailing as it passes through the column. What can you do…

A: Given problem, A colored band shows an excessive amount of tailing as it passes through the column.

Q: This experiment consists of three parts (A, B, and C). Copy Tables I, II and III down in your…

A: Summarizing means we have to be very concise , crisp, to the point and accurate while converting the…

Q: The osmosis rate in these set-ups will slow down over time. Why?

A: Osmosis is the process of diffusion (movement of particles or molecules) of water across a…

Q: The cool plasma tail needs to be removed in regular ICP-OES analysis using the axial view. Provide…

A: A question about spectroscopy, which is to be accomplished.

Q: What Is Mass and Volumetric Flow Rate?

A: Mass flow measures the number of molecules in a flowing gas.

Q: Match the given parts with the correct function integrator A. holds as the mobile phase detector B.…

A: In the given question, functions of several units of a standard hplc system are clearly discussed.

Q: Which of the following is the correct flow of the mobile phase in HPLC? Solvent degasser>Guard…

A: The mobile phase in HPLC is used to transport the sample via seperation column and there by detector…

Q: Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.

A: Weighted Adjacency Matrix: It is 2-D array which represents a data structure which can say that…

Q: If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction…

Q: The solvent in a collodial system is also known as the [?] phase. dispersion dispersed particle…

A: Colloidal system is heterogeneous and contains two phases : dispersed phase and dispersion medium.

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: Name the disadvantages of cloud point extraction technique.

A: A question based on analytical process that is to be accomplished.

Q: When the distribution coefficient increases, the extraction efficiency increases or decreases

A: Distribution coefficient is the ration of concentration of solute in organic phase over…

Q: What are the benefits of decreasing the column internal diameter? O Increased sample capacity O…

A: Answer - The correct option is (c) Increased resolution Explanation - As we lower the internal…

Q: 1- The mass flux for dilute naphthalene from the surface 2- Then find the partial pressure of…

A: Radius of the naphthalene sphere r=1.5 mm =(1.5×10-3) m=0.0015 m Temperature T = 320 K Pressure P =…

Q: Determine the Kovats retention index for all six analytes.

A: In gas chromatography, Kovats retention index is used to convert retention times into…

Q: In using ATR-FTIR, liquid samples need no additional pressure because it is always in optimal…

A: True

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: What is the plate height if the length of the column is 10cm?

A: The plate height is calculated as: H=LN where, L is the length of column and N is the number of…

Q: A researcher wants to calculate the flux of palm oil (PO) in a simulated body fluid (SBF). To…

A: Here this problem is the diffusion of Palm oil (PO) from the stock solution (10 g PO/ lit SBF) to…

Q: Air displacement pipettes is ALWAYS MORE accurate than Mohr and serological pipettes because…

A: To determine whether the given statement is true or false and if false, determine the word that…

Q: You try to measure volume off of a pipette as best as you can. You make sure that you keep the…

A: Minor angle changes every time to read volume.

Q: Give clear handwritten Solution: Pressure of 50.0 psi is used to drive hexane through a 4.00 m…

A: Length of capillary = 4.00m Diameter of capillary = 7.50 um

Q: What will happen to MP (effect and range) if one uses a melting point tube with too large a…

Q: e absolute flash-point temperature in K and R?

Q: time can be used to ider aphy. Choose a parameter w omatography column. centration of the compound

A: Question 1: We know that, change in the temperature often causes a retention time shift of all the…

Q: A student is performing stichiometric experiment. However, the percentage yeild is calculated to be…

A: Percentage yield can be calculated as:

Q: 3.Write in detail about working of any one hydraulic system application in construction area with…

A: Hydraulic lifts are very important equipment used at the construction site, Especially construction…

Q: f the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mi what is the % B…

A: Solution- Given data- Dwell time is 3.5 min. Solvent gradient of 5% B to 60% B in 20 min. To find-…

Q: Should you increase the diameter or length of the chromatography colum for increasing throughput?

Q: Show the arrow push mechanism or the electron flow mechanism

A: We have given the organic reaction and we have to Show the arrow push mechanism or the electron flow…

Q: What would happen if the spots on a plate were below the solvent level when the plate was placed in…

Q: What is the control variable, independent variable, dependent variable for the filtration process.

A: The measurable quantity is called variable in the lab experiments. This includes the reactions which…

Q: A strip of elastomer was stretched in tension and elongation was held constant. After 10 min the…

A: Solution -

Q: In flotation, what would happen to the attachment and detachment between the bubble and the particle…

A: It was found that the flotation rate was very strongly affected by the bubble size. The mechanisms…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Why is it important to align the fractionating column as nearly vertical as possible?
Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve look like if the multiple path term were 0? If longitudinal diffusion were 0? If the finite equilibration time were 0?
1. What is drying to a constant weight? 2. Aside from sieving, what other methods are used to determine particle size. Give and describe briefly at least two methods.
List FOUR kinetic variables that affect column efficiency and explain how each variable affects
Name the disadvantages of cloud point extraction technique.
Should you increase the diameter or length of the chromatography colum for increasing throughput?
What is the flow rate?
During Buchner filtrati on a portion of the filtrate isused for swirling the resi due into the funnel and the pump is reconnected. Why do you use the filtrate here instead of water?
A student is performing stichiometric experiment. However, the percentage yeild is calculated to be lower than 100%. Assuming there was no loss during the transfer of solid product in the vacuum filtration process, identify an experimental eroor which could lead to a low percentage yeild
Volumetric pipettes are designed to deliver a precise amount of liquid, but only if you a. submerge the end of the pipette into a solution you are delivering. b. allow the pipette to drain freely, and leave any residual solution in the pipette. c. hold the pipette at a 45 degree angle and ensure that all the liquid is delivered.
I need help with finding the distance component moved and distance solvent moved
1. Which of the following types of filter are made to operate continuously? a. rotary drum b. gravity c. filter press d. leaf filter 2. The filter medium resistance is controlled by I. pressure drop II. flowrate a. only a is correct b. only b is correct c. none are correct 3. In filtration, which of the following conditions will yield to a higher resistance? a. none of these b. fluid with low viscosity c. slurry with high solid concentration d. large are of filter e. low cake compressibility