The AM band extends from approximately 500. kHz to1 600. kHz. If a 2.0 - µH inductor is used in a tuning circuit fora radio, what are the extremes that a capacitor must reach tocover the complete band of frequencies?

The AM band extends from approximately 500. kHz to1 600. kHz. If a 2.0 - µH inductor is used in a tuning circuit fora radio, what are the extremes that a capacitor must reach tocover the complete band of frequencies?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 14.10CYU: Check Your Understanding The angular frequency of the oscillations in an LC circuit is 2.0103rad/s ....

See similar textbooks

Related questions

Q: Which impedance best describes the high-frequency response of a capacitor O z = jwC + 1 %3D jwL+R…

A: The impedance of the capacitor is calculated as Z=12πfC=1ωC Here, ω is the angular frequency whose…

Q: The current depends on frequency (w). The circuit elements (inductor, resistor, capacitor) are…

Q: A 20.0 Hz, 16.0 V source produces a 2.00 mA current when connected to a capacitor. What is the…

A: We know capacitive reactance can be given as Also,

Q: The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a…

A: Given: AM band ranges between 500 Hz - 1600 Hz That is, fmin=500 kHz=500×10-3 Hz & fmax=1600…

Q: A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz).…

Q: An AM radio antenna picks up a 1000 kHz signal with a peak voltage of 5 0 nmV The tuning circuit…

A: Given: Peak Voltage = 5.0 mV=5×10-3V Inductance = 60μH = 60×10-6 H Coil resistance = 0.25 ohms

Q: When you connect two loudspeakers to the output of a stereoamplifier, should you be sure the lead-in…

A: The wire from two loudspeakers to the stereo's output amplifier's output transfers energy from the…

Q: An RLC series circuit has a 200 Ω resistor and a 25.0 mH inductor. At 8000 Hz, the phase angle is…

A: Resistance, R = 200 Ω Inductance, L = 25 mH frequency, f = 8000 Hz phase angle, A = 45º

Q: The FM radio band is broadcast between 88.0 MHz and 108 MHz. What is the maximum capacitance that…

A: Frequency for the LCR circuit is given by the formula: f =12πLCwhere f is the frequency of the…

Q: An FM radio station broadcasts at a frequency of 95.5 MHz. What inductance (in uH) should be paired…

Q: An 19.0-µF capacitor is connected across an AC source with Vmax = 80.0 V oscillating at 45.0 Hz.…

A: C = 19μF Vmax = 80 V f = 45 Hz

Q: The lowest frequency in the FM radio band is 88.0 MHz. What inductance is needed to produce this…

A: The frequency of the radio band is, The capacitance of the capacitor is,

Q: The LC circuit of a radar transmitter oscillates at 42.4 GHz. (a) What inductance is required for…

Q: At 2, 500 Hz, the reactance of a 7.0 mH inductor is equal to the reactance of a particular…

A: Given : Frequency (f) = 2500 Hz Inductance (L) = 7 mH = 7 x 10-3 H

Q: What is the capacitive reactance of a 0.100 mF capacitor at a 100 Hz audio frequency and at a 100…

A: Given, Capacitive reactance, C=0.100 mF Audio frequency, f1=100 Hz FM-radio frequency, f2=100…

Q: What is the average power dissipation in a series RLC circuit if R = 20.00 k[I, C= 10.00 µF, L=180…

Q: A star-connected, 3-phase load consists of three similar impedances. When the load is connected…

A: We know that the power in the three-phase system is given as P = 3×PF×VI -----------------…

Q: A 60microfarad capacitor is connected to a 110V 59Hz signal. What is its impedance in Ohms?

A: Given data: The capacitor of the circuit is C=60 µF. The voltage of the circuit is V=110 V. The…

Q: The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 10 cm and the…

A: potential and field (E) is a differential: electric field is the gradient of potential (V) in the x…

Q: What is the capacitance of an oscillating LC circuit if the maximum charge on the capacitor is 1.60…

Q: The LC circuit of a radar transmitter oscillates at 49.6 GHz. (a) What inductance is required for…

A: Given data as per question frequency = 49.6GHz capacitance = 3.20pF

Q: A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. If you…

A: Write the formula for the time constant.

Q: The inductor in the RLC tuning circuit of an AM radio has a value of 350 mH. What should be the…

Q: The LC circuit of a radar transmitter oscillates at 40.0 GHz. (a) What inductance is required for…

Q: A certain FM radio tuning circuit has a fixed capacitor C=810 pFTuning is done by a variable…

A: The tuning frequency can be given as, Here, L and C represent the inductor’s inductance and the…

Q: An RLC circuit has a capacitance of 0.29 mF. (a) What inductance will produce a resonance frequency…

A: a. Resonant frequency can be expressed as,

Q: Senies RLC circnit Amplitnde of he voltage Source is 12OV lesistur has a valve of 80s2 Reactance of…

A: Given: The amplitude of the source voltage is 120 V. The resistance of the circuit is 80 Ω. The…

Q: LC oscillators have been used in circuits connected to loudspeakers to create some of the sounds of…

Q: The current amplitude in a pure inductor in a radio receiver is to be 250 µA when the voltage…

Q: An RLC circuit has a resonance frequency of 1.9 kHz. If the inductance is 0.13 mH, what is the…

A: Resonance frequency, f=12πLCC=14π2f2L=14π2×19002×0.13×10-3=54.01 μF

Q: Figure 4 shows LC circuit with inductance, L = 19.8 mH and capacitance, C = 19.6 mF. At certain…

A: Part (i): Given data: The inductance is L=19.8 mH The capacitance is C=19.6 mF The energy in the…

Q: An RLC series circuit has a 240 Ω resistor and a 22.0 mH inductor. At 8800 Hz, the phase angle is…

A: Given: For RLC circuit: Resistance, R = 240 ohm Inductance, L = 22 mH Frequency, f = 8800 Hz Phase…

Q: At what frequency is the reactance of a 20-µFcapacitor equal to that of a 10-mH inductor?

Q: An RLC circuit is used in a radio to tune into an FM station broadcasting at f = 99.7 MHz. The…

Question

The AM band extends from approximately 500. kHz to
1 600. kHz. If a 2.0 - µH inductor is used in a tuning circuit for
a radio, what are the extremes that a capacitor must reach to
cover the complete band of frequencies?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
What is the self-inductance of an LC circuit that oscillates at 60 Hz 1ien the capacitance is 10 F ?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
At 1000 Hz, the reactance of a 5.0-mH inductor is equal to the reactance of a particular capacitor. What is the capacitance of the capacitor?
A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house or car without hearing other unwanted frequencies. How would someone design such a circuit?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Check Your Understanding If a European ac voltage source is considered, what is the time difference between the zero crossings on an ac voltage-versus-time graph?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
For the cucu3t shown below, what are (a) the total impedance and (b) the phase angle between the current and the emf? (C) Write, an expression for i(t).
The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to earth/ground. (a) What capacitance is needed to produce a reactance of 10-0 m for a 5.00 kHz signal? (b) What would its reactance be at 3.00 Hz? (c) Discuss the implications of your answers to (a) and (b).
Check Your Understanding Show that the tins voltages across a resistor, a capacitor, and an inductor in an ac circuit where the tins current is Irmsare given by IrmsR,IrmsXC , and IrmsXL, respectively. Determine these values for the components of the RLC circuit of Equation 15.12. Pave=12t0v0cos (15.12)
An ac source of voltage amplitude 10 V delivers electric energy at a rate of 0.80 W when its current output is 2.5 A. What is the phase angle between the emf and the current?