Answered: The cable shown in Fig. weighs 35 N/m.…

The cable shown in Fig. weighs 35 N/m. Determine the maximum tension in the cable and the sag ha in the cable if The length of the cable is 60 m. B 30 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.72P: The cable AOB weighs 24 N/m. Determine the sag H and the maximum tension in the cable.

See similar textbooks

Related questions

Q: What would be the maximum weight W of the block shown in the following figure, so that the tension…

Q: The cable shown in Fig. If the sag ha in the cable is 200 m, determine weighs 30 N/m. The tension in…

A: Write the expression for tension in the cable.

Q: An object is being held off the ground by a crane on the right and 4 constructions with a rope on…

Q: Q2: As seen in Fig., two plant pots are supported by wires. Determine the tension in each of the…

Q: An elastic string of natural length 4l and modulus of elasticity 4mg is stretched between two points…

Q: A flexible cable with supports at the same elevation has a span of 900ft. The cable weighs 0.75 lb /…

A: To determine the maximum tension in the cable T

Q: 6. Find the tension in each cord in Fig. 2.6 if the weight W ofthe suspended body is 150 N. 35

A: We can use Lami's theorem to solve both parts, Lami's theorem is stated as, "When three forces…

Q: Q1: Determine the magnitude of the force on the pin at A for the boom shown in Fig. 1. Neglect the…

Q: What would be the maximum weight w of the block, shown in the following figure. so that the tension…

Q: 1. The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: The flexible cable shown in Fig. 5 lb/ft. The cable is horizontal at the left support. weighs…

Q: Determine the tension in cable BC and BA necessary to Support the 60 kg cylinder shown in the…

A: When a given system is in equilibrium, then the net external force acting on the system is equal to…

Q: Q2: Find the acceleration of the three weights shown in fig. Assume pulleys are frictionless. Also…

A: Problem 2. Free body diagram of the above system-

Q: A body of mass 10 kg is suspendend through a fan with the help of a rope. Determine the tension in…

A: Data given- m = 10 kg

Q: A bucket, weighing 375 N, is hung from strings CAD, BA and EA, as shown in the image. Determine the…

A: Given data, Weight of the bucket, W = 375 N Since, CAD is a single string. So, tension in CA and AD…

Q: Q1: To accommodate the rise and fall of t tide, a walkway from a pier to a float is supported by…

Q: Q3/ A 100 kg mass is supported by cables as shown in fig. below. Determine tension in each cables.…

A: Given, m = 100 kg

Q: Three pairs of flexible cables, spaced at 120° inter- vals, are used to stabilize a 1000-ft…

A: Draw free body diagram of cable AC

Q: Given the image below, what is the magnitude of the tension at J?

A: Given: Intensity of the uniformly varying force at 0.6 m distance from the z axis: →w=100 N/m Length…

Q: For the figure shown if P= 750 N required for the system to be in equillibruim determine the force Q…

Q: A cylindrical liquid storage tank weighing is to be pushed over a change of elevation of 0.25m by a…

Q: A uniform plank 8 ft long is balanced on a corner If using a horizontal force of 75 lb as shown in…

A: Let's draw free body diagram of 'AB' as shown in figure. Here, W=45 lb

Q: A cable with supports at the same elevation has a span of 550 ft. The cable weighs 4 lb / ft and the…

A: Consider the diagram shown below for the cable.

Q: A uniform bar with mass M = 3.25 kilograms is shown in the diagram. hlo required to keep the

Q: Refer to the system of cylinders arranged as depicted in Fig. 1000 N each and the weight of cylinder…

A: Data given- WA =WB = 1000 N WC = 2000 N rA = rB = 0.6 /2 = 0.3 m rC = 1.2 /2 = 0.6 m

Q: The box shown in fig weighs 400 N, in equilibrium Determine the tension in the cords AB and BC

A: Given data Weight of box = 400N

Q: Q2: The cylinder A weighs 660 N and it is supported by the vertical smooth wall and the cable system…

Q: Cords are looped around a small spacer separating two cylinder each weighing 400kn and pass over a…

Q: What would be the maximum weight W of the block, shown n the following figure, so that the tension…

A: Correct ans is 22.32N

Q: A cable with supports at the same elevation has a span of 550 ft. The cable weighs 4 lb / ft and the…

A: The given data: Write the expression for the sag of the cable.

Q: A rope extends between two poles. A 90 N boy hangs from it as shown in Fig. 1. Find the tensions in…

Q: A hot air balloon is tethered as shown below. Assuming that the balloon is pulling upward with a…

Q: 1. In the figure below, if a=5 feet, L=14 feet, and the respective weights of the diver and the…

Q: 1. In a room with a ceiling height of 2.6 meter, a 2.5 meter plank is supported by a cable attached…

Q: (2) An artist designs an oval mobile that is supposed to hang horizontal as shown. If the weights at…

A: Data given - Weight of block A = weight of block B = 8kN To determine - Tension at C Counterweight…

Q: g) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on…

A: Given: m=75 Kg L=5m d=1 mm

Q: A 12.0 kg weight hangs from a 7.50 m pole as illustrated in the diagram. The pole has a mass of 8.0…

A: Write the given value using suitable variables. Here W signifies given weight, L signifies pole…

Q: . As seen in Fig., two plant pots are supported by wires. Determine the tension in each of the…

Q: The mass of the board suspended below is 70 kg. What is the tension in the rope, and what is the…

A: Consider the free body diagram shown below for the given board.

Q: Two horizontal beams are used to balance the masses A, B, and C, as shown in the figure. Each beam…

A: Given data: Mass of block C, mC = 30 kg. Draw the diagram of the lower rod. Apply equilibrium…

Q: 04) Determine the force (P) needed to hold the 4-m wide gate in the position shown in Fig. (4)

Q: In the attached photo, the 3-wheeled cart weighs 120 lbs. If it is loaded as shown with a crate…

A: Total force:

Q: A cable with supports at the same elevation has a span of 300m. The cable weighs 75 N/m and the sag…

A: Give data: The length of span, a = 300 m. The weight of the cable, w = 75 N/m. The sag at mid of…

Q: Q2: For the system shown in figure, all chains are of negligible weight, if the tensile force in…

Q: 0.4 m 1,5 m L0,4 m 0.8 m 1.5 m 1,5 m Three vertical wires are used to support a rectangular plate…

Q: Calculate the tension T in the cable which supports the 1000-lb load with the pulley arrangement…

Q: Plot the tension in each cable as a function of d , if d varies from 0 to 8 m. The weight of the…

Q: Q/ Compute the pull force (F) on the rope exerted by the man to hold the crate in the position…

Q: The boom is used to support the 50 Ib flowerpot shown in Figure below. Determine the tension…

Question

The cable shown in Fig.
weighs 35 N/m.
Determine the maximum tension in the cable and the sag
ha in the cable if
The length of the cable is 60 m.
B
30 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Determine the force F required to pull up the 3.54m stopper from the drain of a sink if the depth of water is 10 in. Use =0.036lb/in.3 for water and neglect the weight of the chain.
The 15-m-long cable supports the loads W1 and W2 as shown. Find the ratio W1/W2 for which the segment BC will be horizontal; that is, 2=0.
The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.
The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.
The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
The tongs shown are designed for lifting blocks of ice. If the weight of the ice block is W, find the horizontal force between the tongs and the ice block at C and D. Neglect the weights of the tongs.
Find the tension T in the cable when the 180-N force is applied to the pedal at E. Neglect friction and the weights of the parts.
The horizontal boom carries the weight W=108lb at A. The boom is supported by the cables AB and AC. The tensions in the cables are TAB=120lb and TAC=160lb. Determine the single force R that is equivalent to three forces acting on the boom at A.
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to the horizontal. Determine the length s of the hose that is lifted off the ground and the corresponding horizontal distance L.
Two concrete blocks weighing 320 lb each form part of the retaining wall of a swimming pool. Will the blocks be in equilibrium when the pool is filled and the water exerts the line loading shown?
The cable AOB weighs 24 N/m. Determine the sag H and the maximum tension in the cable.