The capacitance per unit length and the characteristic impedance of a lossless Transmission line are C and Z0 respectively. Express the velocity of travelling wave on the transmission line in terms of the two given parameters above.

The capacitance per unit length and the characteristic impedance of a lossless Transmission line are C and Z0 respectively. Express the velocity of travelling wave on the transmission line in terms of the two given parameters above.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.42P: A three-phase power of 460 MW is transmitted to a substation located 500 km from the source of...

See similar textbooks

Related questions

Q: three-phase, 60 Hz transmission line has an inductance of 1.378 mH per Km per phase and a…

A: In this question , we will find phase constant , surge impedance and wavelength of lossless line...…

Q: three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance…

A: In this question we will find phase constant , surge impedance for lossless line...

Q: The 50 ohm half wavelength lossless transmission line is terminated with a 60 ohm load impedance. If…

Q: (a) A 3-phase, 50 Hz, 220 kV overhead transmission line is 300 km long. Per km inductance and…

A: We are authorized to answer only 1 question at a time, since you have not mentioned which question…

Q: (5) Transmission-line analysis: A lossless transmission line of characteristic impedance Zo = 100 2,…

A: Given:Z0=100ΩVp=2×108m/slength, l=34 cmZL=30-j40Ωf=1 GHzλ=Vpfλ=2×108109λ=20 cmlength,l=1.7λ

Q: A 50-N lossless line is terminated in Z, = 40 – j30 N. Determine the following: (a) the reflection…

A: A 50Ω lossless line is terminated in Z1=40-j30Ω. Now, to determine the reflection coefficient at the…

Q: A lossless transmission with characteristic impedance of ?0 = 100Ω and length = 52cm The line was…

A: Given:Characteristic impedance,Z0=100ΩLoad impedance, ZL=30 +j50Ω

Q: The parameters of a lossless transmission line operating at f=95.493MHz are L′=0.45 μH/m, C′=25…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: The magnitude of the [A] parameter of a short transmission line is smaller than that of medium line.…

A: first we will write the expression for A constant for short and medium transmission line to judge…

Q: A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line…

Q: The capacitance per unit length and the inductance per unit length for a lossless transmission line…

A: Characteristic impedance (Z0) of a transmission line is defined as the impedance of the transmission…

Q: is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric…

Q: A lossless 34-S transmission line is terminated in a load with ZL= (66+ j26) N. Use the Smith chart…

Q: lossless transmission line of length 1= = 502, is terminated in a load impedance gnal wavelength on…

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: Express the velocity of wave on a lossless line in terms of c and z0 with proper derivative. C is…

Q: Compute the following parameters inductance, Capacitance, resistance, and conductance, if you have…

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: We have given the following problem

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: Estimate the corona loss for a 3-phase, 110 kV, 50 Hz, 150-km-long transmission line consisting of…

Q: A 3-phase, 60 Hz, 600 kV, lossless transmission line is 600 km long. The line inductance is 2…

A: Given- VL-L=600 kVf = 60 HzL = 2 mH/km/phaseC = 20 nF/km/phase To Find- Phase constant Surge…

Q: lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of…

Q: A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: Q4) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Load impedance ZL=150+j30 Ωcharacterstic impedanceZ0=50 ΩFrequency f=500 MHz

Q: The transmission line has the following data weight of the conductor = 6.4 kg/m, Tension in the…

A: The correct answer is 63.04 m sag is given bys=wl28T In the above equation l=Distance between tower…

Q: A lossless transmission line has Z₁ = 100 £, terminated by an unknown impedance. The termination is…

A: Given, A lossless transmission line has Z0=100 ΩVSWR=5

Q: Problem #5) An 80cm long, lossy transmission line has the following characteristics: Z = 752, Y =…

A: An 80 cm long, lossy transmission line has the following characteristics: Zo=75 Ω, γ=0.10+j2.876 The…

Q: A 500kV,300km,60Hz500kV,300km,60Hz, three-phase overhead transmission line, assumed to be lossless,…

Q: A lossless transmission line has 100 ? characteristic impedance. The line is terminated in a load…

A: Load impedance given is ZL=R-jXC which means it comprises a resistor and a capacitor. The circuit…

Q: A 90 N lossless line is 0.6A long, If S = 1.9 and 6, = -68°, use the Smith chart to find the load…

Q: In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed…

A: Given : Generally depending on the type of the medium we classify them parameters. Distributed…

Q: A lossless transmission line with characteristic impedance of Z0 = 1000 and length I = 52cm was…

A: Given data:

Q: A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the…

A: For a transmission line, the following line parameters are present: Since the given transmission…

Q: 6. The standing-wave ratio on a lossless 300-2 transmission line terminated in an unknown ZL is S=…

Q: An 8000 V, 60 Hz, single-phase, transmission line consists of two hard-drawn aluminum conductors…

A: Given Data: Resistivity at given temperature = 2.83 x 10-8 r = 0.02 m L = 30 km

Q: "In medium transmission line modeling, which of parameter is considered to be lumped?" Resistance…

A: In this we will write about medium transmission line modelling...

Q: 10. The capacitance per unit length and the characteristic impedance of a lossless transmission line…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: An extra high voltage transmission line of length 300 km can be approximated by a lossless line…

A: Given, An extra high voltage transmission line of length, l = 300 km Propgation constant, β=…

Q: A 75 Q lossless transmission line is to be matched with a 100-j802 load using Single stub. Calculate…

A: Given :Z0=75 ΩZL=100-j80 ΩZL=128.06∠38.66° f=30 MHz

Q: Since the input power of a non-reflective and lossless transmission line terminated with a load…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A 75N lossless transmission line is terminated with a load impedance equals to 105-j1502. The length…

A: consider the question;

Q: Return loss for a transmission line in terms of its reflection co efficient is given by:

A: The return loss is a parameter that is used to measure the amount of energy that is reflected back…

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

The capacitance per unit length and the characteristic impedance of a lossless Transmission line are C and Z₀ respectively. Express the velocity of travelling wave on the transmission line in terms of the two given parameters above.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-phase power of 460 MW is transmitted to a substation located 500 km from the source of power. With VS=1. per unit, VR=0.9 per unit, =5000 km, Zc=500, and =36.87, determine a nominal voltage level for the lossless transmission line based on Eq. (5.4.29) of the text. Using this result, find the theoretical three-phase maximum power that can be transferred by the lossless transmission line.
The capacitance per unit length and the characteristic impedance of a lossless transmission line is C and Zo, respectively. Find the velocity of a travelling wave on the transmission line.
The capacitance per unit length and the inductance per unit length for a lossless transmission line are 0.1 F/m and 20 H/m respectively. What will be the characteristic impedance of the line?
A transmission line has an inductance of 4 mH/loop km and a capacitance of 0.004µF/km. Determine, for a frequency of operation of 1 kHz, the phase delay, the wavelength on the line, and the velocity of propagation (in metres per second) of the
A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the damping coefficient α=
For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.
Express the velocity of wave on a lossless line in terms of c and z0 with proper derivative. C is capacitance of transmission line
1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line if the shunt capacitance is 200 nF/m.
An extra high voltage transmission line of length 300 km can be approximated by a lossless line having propgation constant is 0.00127 rad/km. The percentage ratio of line length to wave length will nearly by ?
A lossless transmission line has a Zo of 50 ohms and a line velocity of 2.4 x 10^8 m/s. If the operating frequency is 1 MHz. Determine the capacitance in pf.
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.8 wavelengths, what is input admittance?