The capacity of a Shallow foundation directly depends on (choose all that apply): -Depth of the foundation -Internal friction angle of the soil -Density of the soil -Origin of the osil -Cohesion of the soil

The capacity of a Shallow foundation directly depends on (choose all that apply): -Depth of the foundation -Internal friction angle of the soil -Density of the soil -Origin of the osil -Cohesion of the soil

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Shallow Foundations: Ultimate Bearing Capacity

Section: Chapter Questions

Problem 6.1P: For the following cases, determine the allowable gross vertical load-bearing capacity of the...

See similar textbooks

Related questions

Q: The total load on a shallow foundation is 400 kN and the safe bear soil is 200 kN/m2. The area of…

Q: The square footing shown below must be designed to carry a 2400 KN load. Use Terzaghi's bearing…

A: For ϕ=32°, Nc=45.44Nq=30.06Nγ=28.78 1. Water table is at 1m below the base of the footing…

Q: A square foundation has to be constructed on soil with OCR-1. The unit weight of soil is 16.5 kN/m²…

Q: For the square foundation shown below, compute the allowable bearing capacity (FS = 3). Use the…

A: Given: The factor of safety is 3. The depth of the footing is 4 m. The angle of internal friction is…

Q: The applied load on a shallow square foundation makes an angle of 20 degrees with the vertical.…

A: Given data- Shallow square foundation with 20 degrees with vertical. B = 5 ft, Df = 3 ft, y = 115…

Q: A continuous foundation is to be constructed near a slope made of granular soil (see Figure 7.19).…

A: Write the formula for the ultimate bearing capacity as following below: qu=c'Ncq+12γBNγq Here the…

Q: Decide which type of foundation should be used if the working load is 4000 kN and the load bearing…

A: Given data, Working load = 4000 kN Bearing capacity of soil = 120 kN/m^2

Q: A square foundation is 3m x 3m and is 1.5m below the ground surface. The soil supporting the…

Q: A foundation carries uniform loads as shown. Determine the value of w (in kN/m). 70 kNm 70kNm…

Q: A strip foundation is to be built on a clay slope. The setback of the foundation from the edge of…

A: Given data - Setback of the foundation from the edge of the slope is = 0.8m The height of the slope…

Q: A 2m x 3m spread foundation placed at a depth of 2m carries a vertical load of 3000 kN and a moment…

A: Question is based on spread foundation over a soil .Dimensions of foundation,vertical load and…

Q: QUESTION 2 Determine the maximum column load that can be applied on a 1.2 m * 1.2 m square…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other question as…

Q: For the following cases, determine the allowable gross vertical load-bearing capacity of the…

Q: 2m x 6m singular sitting on a sandy ground If the total foundation pressure of a foundation is 150…

A: solved

Q: Compute the vertical stress on the centerline of the footing due to the imposed load at a depth

Q: Circular rigid foundation having a diameter of 20m is resisting a load of 110kPa. The foundation…

A: Given: Foundation diameter, B = 20 m Resistance load, q = 110 kPa Elastic modulus of soil, Es = 30…

Q: Problem # 2 A square footing (8 ft x 8 ft) supports a square column 14 in x 14 in. The column and…

Q: Q2 (a) Foundation is part of the structure that transfers the load from the structure constructed on…

A: Foundation is the structural component of a building that transfers load from the structure to the…

Q: SITUATION: A flexible foundation is subjected to a uniformly distributed load of q 500 kPa Determine…

Q: SITUATION: A flexible foundation is subjected to a uniformly distributed load of q = 500 kPa…

Q: For the following cases, determine the allowable gross vertical load-bearing capacity of the…

Q: The 6m x 9m rectangular foundation shown carries a uniform load of 325 kPa. Using NEWMARK'S…

A: Given data in question Dimensions Influence factor value Newmarks influnce chart Depth Stress…

Q: The plan of a mat foundation is shown in Figure 1. Calculate the soil pressure at points A, B, C, D,…

Q: foundation 3 m x 3 m has its bottom section 3.5 m below the ground surface. If the water table is on…

Q: Q- A raft foundation 1Om wide and 12 m long is to be constructed in a clayey soil having shear…

A: given- width B=10 mLength L=12 mshear strength C=12 kN/m2unit weight γ=16 kN/m3overburden…

Q: A foundation carries uniform loads as shown. Determine the value of w (in kN/m). 70 kNm 円円 W (kN/m)…

A: Given data in question Foundation Dimensions Loading ( UDL ) To find out Reaction beneath the…

Q: Consider a combined rectangular footing with the following information: P1 = 1500 kN a1 = 1 m, az =…

Q: Q2: A ring foundation having load equal to 400kPa is resting on a saturated clay soil layer, the…

Q: A rectangular foundation has a dimensions B=1 m, and L=4 m, the depth of foundation Df=2.2 m, the…

A: Given data: B=1 mL=4 mDf=2.2 mγ=16.1 KN/m3 c=15 KN/m2Nc=10.16Nq=2.98Nγ=0.69 Fs=3

Q: A foundation of 2m*3m on soil, the depth of foundation is 3 m, the unit weight of soil is 16.7 kN/m,…

A: Given data Size of foundation=2m ×3 mDepth of fouundation=1.5 mYsoil=16.7 kN/m2Ysat=17.5 kN/m3

Q: (b) The bearing capacity of shallow foundation depends on several factors, list any five of them

A: Foundation is the substructure elements that are in direct contact with the ground and transmit,…

Q: a. A layer of sand, of saturated unit weight overlies a layer of clay, of saturated unit weight. A…

A: It is asked to draw the soil profile in detail mentioning soil and foundation details.

Q: For the following cases, determine the allowable gross vertical load-bearing capacity of the…

Q: For a square foundation that is B x B in plan, Df. = 2 m; vertical gross allowable load, Qall…

Q: SITUATION: A square foundation is 2m x 2m in plan. The soil supporting the foundation has a friction…

A: We will divide bearing capacity by factor of safety. Use terzaghi equation

Q: Calculate the ultimate bearing capacity of a 2 m wide strip foundation embedded 2 m below the ground…

A: Figure is as shown

Q: 2. A machine foundation has a base dimension of 6m x 2m with a span of 5 m, has a weight equal to 5…

A: The given data is shown below: Base dimension=6m×2mSpan=5mBearing pressure=150 kPa

Q: The material used in the unreinforced expanded foundation has poor tensile and flexural properties.…

A: All the above mentioned measures are correct but most suitable is (C) improve the bearing capacity…

Q: A machine foundation has a base dimension of 4m x 8m and has weight of equal to 4.6 times weight of…

Q: The total load on a shallow foundation is 400 kN and the safe bearing capacity of the soilis 200…

Q: .5.) For the continuous foundation show below, determine the amount of ultimate load for each meter…

Q: load on the foundation with a factor of safety of 3.

Q: For the following cases, determine the allowable gross vertical load bearing capacity of the…

A: Hi there! since you have asked multiple questions, we will solve the first question for you. If you…

Q: A square shallow foundation has to carry a gross allowable total mass of 15,290 kg. The depth of the…

A: Total Mass to bear from soil (M) = 15,290 kg Depth of the foundation (Df) = 0.7 m Inclination of…

Concept explainers

Types of Foundation

Question

100%

The capacity of a Shallow foundation directly depends on (choose all that apply):

-Depth of the foundation

-Internal friction angle of the soil

-Density of the soil

-Origin of the osil

-Cohesion of the soil

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A spread-footed foundation has top area dimensions of 3 m by 1.5 m. The vertical depth (h) of the foundation is 0.70 m. Only the width at the bottom is longer than the top, i.e. the 3-m length is constant. The angle of spread of footing (θ) is 25°. Calculate the volume of this foundation in cubic meters.
For the following cases, determine the allowable gross vertical load-bearing capacity of the foundation. Use the general bearing capacity equation. FS = 4. B = 3 m Df = 2 m Φ' = 30° c' = 0 specific weight of the soil = 16.5 kN/m^3 Foundation Type = Square
A strip footing foundation 1 m wide is constructed in the slope of a hill whose surface inclination is 20°. The soil in the hill is a dense sand, with a unit weight of 19 kN/m3 and an angle of internal friction of 40°. Assume that the D/B ratio is about 1. Applying a factor of safety of 3, determine the wall loading the foundation can carry, per meter of footing length.
A square foundation is 1.5 m by 1.5 m in plan. The soil properties supporting the foundation have a friction angle of 28° and c = 15.2 kPa, unit weight = 19.8kN/m3• The depth of the footing is 2.0 m. Factor of safety is 3. Using Terzaghi's Bearing capacity equation, determine the design load on the foundation.
A square column foundation must carry a total permanent load of 1505kN , variable load of 1100KN and a variable moment of 300KN.select the depth of foundation and determine safe size of foundation for short term as well as long term stability according to United Kingdom EN1997
In Problem 7.1, if there was no bedrock present for at least 12.0 ft below the foundation, what would the ultimate bearing capacity be? 7.1 A 7.5 ft wide rough continuous foundation is placed in the ground at 3.0 ft depth. There is bedrock present at 3 ft depth below the bottom of the foundation. The soil properties are c′ = 210 lb/ft2, ϕ′ = 25°, and γ = 115.0 lb/ft3. Determine the ultimate bearing capacity of the foundation.
A square column foundation has to carry a gross allowable load of 1805 kN (FS = 3). Given: Df = 1.5 m, =15.9 kN/m3, = 34, and c = 0. Use Terzaghis equation to determine the size of the foundation (B). Assume general shear failure.
For the following cases, determine the allowable gross vertical load-bearing capacity of the foundation. Use Terzaghi’s equation and assume general shear failure in soil. Use FS = 4. Parameters for Problem 6.1
The applied load on a shallow square foundation makes an angle of 20° with the vertical. Given: B = 5 ft, Df = 3 ft, γ = 115 lb/ft3, ф′ = 25°, and c′ = 600 lb/ft2. Use FS = 3 and determine the gross inclined allowable load. Use Eq. (6.28).
A square column foundation has to carry a gross allowable load of 1805 kN ( FS = 3). Given: D f = 1.4 m, γ = 15.4 kN/m 3 , ϕ ′ = 34 ° , and c ′ = 0. Use Terzaghi's equation to determine the size of the foundation ( B ). Assume general shear failure.
For the following cases, determine the allowable gross vertical load-bearing capacity of the foundation. Use Terzaghi’s equation and assume general shear failure in soil. Use FS=4. B = 3 m Df = 2 m Φ' = 30° c' = 0 specific weight of the soil = 16.5 kN/m^3 Foundation Type = Square
A rectangular foundation has a dimensions B=1 m, and L=4 m, the depth of foundation Df=2.2 m, the soil unit density is 16.1 KN/m^3, the cohesion 15 KN/m^2, Nc=10.16, Nq=2.98, Ngamma=0.69 find the force in KN that the foundation can support for a factor of safety 3