Answered: The current drawn by a 250-watts…

Engineering

Electrical Engineering

The current drawn by a 250-watts incandescent lamp operating at 120 volts is

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter16: Installation Of Heating, Cooling, And Refrigeration Systems

Section: Chapter Questions

Problem 2RQ

See similar textbooks

Related questions

Q: A tungsten lamp filament has a temperature of 20500C and a resistance of 500 Ω when taking normal…

A: tungsten filament have resistance of 500 ohm at 20500 C. To find the resistance at 25 oC we will use…

Q: The hot resistance of an incandescent lamp is 100and the rated voltage is 50V.Find the series…

A: Given V=50 VR=10 Ω The circuit is

Q: The number of electrons flowing in an electric lamp every 3.5 seconds is 3.125x10^19 e-. What is the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Determine the voltage at resistor R1. (assume LED forward voltage is 2.0 volts)

A: The voltage across the resistor R1 is same as LED forward voltage but the voltage across it should…

Q: Assume that all of the light emitted by a 100W

A: GIVEN all of the light emitted by a 100W incandescent lamp (1750 lumen s)…

Q: A tungsten wire has 25 ohms of resistance at 20 degrees Celsius. Calculate its resistance at 100…

Q: who invented a light bulb

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: The relation between electric intensity E, voltage applied V and the distance d between the plates…

A: Electric field intensity E is defined as ratio of Voltage applied V and distance d between the…

Q: Q.2 How many types of filament in tungsten filament lamp? & What are they?

A: Tungsten filament lamp : The lamp which have tungsten filament which give light after heating .…

Q: 14 - What is the material system used by the first LEDs? (İlk LEDlerin kullandığı malzeme sistemi…

A: Part (A): Material used in GaAlAs is Gallium Aluminum Arsenide. Part (b) Material used in InGaALP is…

Q: If 31.25 x 1018 electrons are removed from a neutral dielectric, how much charge is stored in…

A: We need to calculate charge stored for given Material .

Q: A tungsten filament has a temperature of 20.50 degrees Celsius and a resistance of 500 ohms when…

Q: 1. What is the reading value of the voltmeter when the excitation circuit is оpen

A: The reading value of the voltmeter will be residual voltage.

Q: 180 C of charge flow through a section of wire in 3 min. How much electric current flows through the…

Q: The light of fluorescent tube appears cooler than that from an incandescent lamp. This is due to the…

A: The incandescent lamp is not much cooler compared to the fluorescent lamp. Also, the efficiency of…

Q: What is the resistance of a No. 14 iron wire, 600 feet long at 248 degrees Fahrenheit.

A: The length of No. 14 iron wire is 600 feet, which is equal to 182.88 in meters. We know that the…

Q: A wastewater treatment plant's ac distribution operates at 600 volts ac. What is the peak value of…

A: Given, A wastewater treatment plant ac distribution operates at voltage Vrms=600 V

Q: What is the value of current if a 50C charge flows in a conductor over a period of 5 seconds? a) 5A…

A: Given, Charge, q = 50 C Time, t = 5 sec

Q: Differentiate between Solar Irradiance, Solar Irradiation and Peak Sun Hour. State the explaination

A: Solar Irradiance is as follows: - The sun based irradiance is the yield of light energy from the…

Q: Determine the ac resistance at 25 mA.

Q: How many lumens are there in natural daylight b. Amount of light given per second from a particular…

A: In this question we will write about how many lumens in light hitting the sun and amount of light…

Q: D2 D1 D3 R1 1K

Q: The amount of current the battery can produce for a period of 20 hours at 80 degrees Fahrenheit is…

A: An ampere-hour (abbreviated Ah, or sometimes amp hour) is the amount of energy charge in a battery…

Q: Please i need solution (electric circuit)

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: Compare Wind & Solar Energy

A: This is basic problem from power system. The solution is given below.

Q: 1. Did your experimentala results verify the equivalence between the delta and star connections?…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Electromechanical energy conversion 2 question.

A: According to question: The synchronous speed and the rotor speed of induction motor is calculated as…

Q: Q.3: A GM Counter reads 472 counts per minutes when 500 charged particles are incident per minute on…

A: The number of counts ‘n’ is given as 472 per minute. The number of charged particles ‘N’ incident on…

Q: The relation between electric intensity E, voltage applied V and the distance d between the plates…

A: Given: E = Electric Field ; V = Voltage applied ; d = Distance between Plates

Q: During a lighting discharge, 30 C of charge move through a potential difference of 1.0 x 108 v in…

A: The question is from electromagnetic fields.

Q: If 31.25 × 1018 electrons are removed from a neutral dielectric, how much charge is stored in…

A: Number of electrons removed from the dielectric is given as:

Q: Explain how the following background correction techniques work: (i) beam chopping; (ii) deuterium…

A: Introduction - Background Correction (BGC) is a critical component of any spectrometric study. The…

Q: Explain why photovoltaic cells would be connected in series, parallel, or a parallel combination.

A: Need to explain why photovoltaics cells connected in series, parallel or parallel combination

Q: The process of converting Solar energy into Electrical energy is called a. Solar-Voltage Effect b.…

A: In this answer let us discuss the process of converting the solar energy into electrical energy and…

Q: 1. Compare the power in watts with the apparent power in volt-amperes for the following apparatus in…

A: Given: Power comparison

Q: Deterne the conductance of a lightbulb when operating at 250 V, 100W. (In decimal number)

Q: To get the maximum electric current output from the PV module the most appropriate distance between…

A: The power generated by the solar cell depends on the light intensity As the source is moving away…

Q: Which of the following is cause of flow of current in solar cell. a. Sun Heat b. None c. Photons d.…

A: solar cell works by using sun light. they absorb the photons from the sun light

Q: What will be the total charge of 5000 electrons?

A: Given, Number of electrons n=5000

Q: If a 100 v, 60 lamp is connected to a 200 volt 50 Hz supply, calculate the net inductance required…

Q: The efficiency for incandescent light bulbs is typically about 14 lumens per watt (lm/W) and that…

Q: The relation between electric intensity E, voltage applied V and the distance d between the plates…

Q: Select the correct answer A wire of radius 1 mm and conductivity 5x [10) ^7 S/m if an electric field…

A: As per the guidelines of Bartleby we have to solve 1st question since both question are not…

Q: Which curve represents life of the lamp? DE C B % NORMAL VOLTS O curve B O curve D O curve C curve A…

A: There are various curves given inthe question. It is to decide that which curve represents the…

Q: A cloud of 2.5x10^19 electrons move past a given point every 2 seconds. How much is the intensity of…

A: Given data are: Number of electrons, n=2.5×1019electrons Time at which each electron move past a…

Q: Which one of the following uses difference in temperature between the surface ocean water and the…

A: Difference in temperature between the surface ocean water and the deep sea water to produce…

Q: 2. The resistance of a wire is 126.48 ohms at 100 degrees Celsius and 100 ohms at 30 degrees…

Q: Figure 1 shows 4 different equivalent circuits. Which of these circuits accurately represents the…

A: There different types of solar cell model based on diodes used like single diode model, two diode…

Q: What potential difference is required across an 8-0 resistor to cause 27.78 A to flow through it?

A: Given, The potential difference, V =? Resistance, R=8 Ω Current, I=27.78 A

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

The current drawn by a 250-watts incandescent lamp operating at 120 volts is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The tungsten filament in an incandescent lamp has a resistance of 9.8 ohms at aroom temperature of 200C and resistance of 132 ohms at normal operatingtemperature. Calculate the temperature of the heated filament. (α20 0C = 0.0045).
An incandescednt lamo, rated at 100W , gives a certain amount of light when placed across the 12p V Ac power line. Would the amount oc the light increase, decrease or remain the same when, placed across a 120 V dc power line?
How much power is consumed by a 12-V incandescent lamp if it draws 150 mA of current when lit?
The relation between electric intensity E, voltage applied V and the distance d between the plates of a parallel plate condenser is
What have you observed in the behavior of the elements? Did the lamps light up? Explain.
What have you observed in the behavior of the elements? Did the lamp light up? Explain.
Determine the current flowing through the LED if its forward voltage is 2.0 volts.
What is the luminous intensity of a 100 watt tungsten lamp whose efficiency is 24 Im/w?
Except from point A to point D, where should a student hook up a voltmeter to measure the electric potential difference across the battery?
To get the maximum electric current output from the PV module the most appropriate distance between the source of light and PV module must be a. 10m b. From zero to 10m • c. 25cm Od. Zero
P.1. Approximately what percentage of visible light is given off by a 100 W incandescent lamp?A. 30 percentB. 10 percentC. 80 percentD. 50 percentP.2. The ordering code for a large incandescent lamp provides information on theA. lamp power requirement, bulb type and size, and sometimes lamp color.B. lamp power requirement, bulb size and special features, and sometimes filament type.C. lamp voltage, bulb type and size, and sometimes lamp color.D. lamp voltage, bulb size and special features, and sometimes filament type.P.3. Which of the following units is used to measure the chromaticity of a lamp?A. Degrees KelvinB. WattsC. Degrees FahrenheitD. Amperes
The deflection angle of the pointer of an ideal moving iron meter is 20° for 1 ampere dc current. If a current of 3 sin(314t) is passed through the ammeter, then the deflection angle is ?