Answered: The current shown in part (a) below is…

The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In each case, determine which end of the inductor is at the higher potential.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 36P: The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In...

See similar textbooks

Related questions

Q: A rectangular metallic loop of dimensions ℓ and ω and resistance R moves with constant speed υ to…

A: Given: Dimension of loop = l×w. Width of magnetic field = 3w. Velocity of loop = v. Resistance with…

Q: List whether the induced voltage from the inductor (L) is positive, negative, or zero from points A…

A: In the given question, We have to discuss about the induced voltage is positive, negative or zero,…

Q: Initially, the switch connects a resistor of resistance R and an inductor to a battery, and a…

A: Initial current in the circuit = I0 Formula of current through the circuit at time t: It=I0e-tτ

Q: To construct an oscillating LC system, you can choose from a 10 mH inductor, a 5.0 mF capacitor, and…

Q: Two identical long wires of radius a =1.53 mm are parallel and carry identical currents in opposite…

Q: a 10CM, b 12 CM, h=1CM, and N turns 700, and free space permeability, then the self-inductance of…

A: Given : a = 10 cm = 0.10 m b = 12 cm = 0.12 m h = 1 cm = 0.01 m N = 700

Q: When a certain inductor carries a current I, it stores 3mJ of energy in its magnetic field. How much…

A: Suppose inductance of conductor is L. Current flowing throught inductor is I. Energy = LI²/2.

Q: After reaching steady state, an RL circuit is disconnected from the battery such that the circuit…

A: We know,

Q: The wire of a tightly wound solenoid is unwound andused to make another tightly wound solenoid of…

A: The mathematical expression for the inductance is given as L=μ0N2Al Here, μ0 is the permittivity of…

Q: Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance…

Q: What is the value of the inductor?

Q: a L A current I is flowing through an inductor. At time t = 0, the current is zero and at time t 1s…

A: Answer option(c) point a

Q: A square loop of side length a is rotating with angular fre-quency ω in a constant, uniform magnetic…

Q: Determine the mutual inductance between a toroidal coil of N1 turns with square cross section (inner…

Q: How can we calculate the self inductance of a solenoid?

A: Solenoid is a device made by a coil of wire.

Q: The above inductor consists of two solenoids (radius b, n turns/meter, and radius a, 2n turns/meter)…

Q: A long solenoid has a square cross-section with sides of length l, n turns per length has the z-axis…

Q: In Figure (a), the inductor has 29 turns and the ideal battery has an emf of 42 V. Figure (b) gives…

A: Given Data, Total Number of turns (N)=29 Ideal battery emf (V)=42 V Magnetic flux in the vertical…

Q: How does the self-inductance per unit length near the center of a solenoid (away from the ends)…

A: The expression for the self inductance , L=μN2Al

Q: long piece of wire is bent into a rectangular loop and placed on a table top in the horizontal…

Q: The voltage across an inductor, when connected to a constant current source, is equal to infinity at…

A: Correct option is

Q: The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In…

Q: For a non-deformable loop of area A, immersed in a uniform magnetic field B. The induced fem is…

A: For a non -deformable loop of area A, immersed in a uniform magnetic field B. where B is the…

Q: Consider the circuit shown below. а 12V 10тН 10Ω b- 200 What is the rate of change of the current in…

Q: Observe the following images: അ000000 അ a b) അ അ c) d Assuming the solenoids are equal, which…

Q: When the current through a large inductor is interrupted with a switch, an arc appears across the…

A: In an inductor an induced emf is produced when current flows through it due to mutual inductance.

Q: On which factors does the magnetic field of a solenoid depends?

A: Standard expression for the magnetic field (B) of a solenoid is given as, B=μ0×N×iL…

Q: An ideal solenid of unknown length and cross-section has an inductance of 4.0mH. When current flows…

A: Given data *The given inductance of the inductor is L = 4.0 mH = 4.0 × 10-3 H *The given induced emf…

Q: An aluminum ring of radius 5.00 cm and resistance 3.00 × 10–4 O is placed on top of a long air-core…

A: Aluminium ring radius, r2 = 5 cm = 0.05 m Aluminium ring resistance, R = 3×10-4 ῼ solenoid coil…

Q: Consider two identical circular coils of wire, each having self-inductance L and radius r. The coils…

A: Mutual Inductance: The current in one coil induces emf in the other coil. Due to the arrangement of…

Q: Amp) 6 ((mili sec) The current through a 4.6 H inductor is shown in the following graph. The induced…

A: Given: inductance L=4.6HSo from the graph we can observe that the rate of decay of…

Q: An inductor is formed by winding N turns of a thin conducting wire into a circular loop of radius a.…

A: Given data: Magnetic field, B=B02y^+3z^sinωt Number of turns, N=10 B0=0.2 T; a=10 cm=0.10 m;…

Q: In Fig. 9, an increasing current is flowing from left to right throug the inductor and the connected…

A: Its a concept of inductor

Q: Please show how much current is on the battery and on each resistor and the inductor at T is equal…

Q: The current in a 62 mH inductor changes with time as I = bt2 - at. With a 6 A/s and b = 6 A/s, find…

Q: The switch S in the circuit has just been closed. Right after (at t 0) the current shown is measured…

Q: In the circuit shown in figure, switch S is closed. At some time t afterward, the current il is 10A…

Q: There is a uniform magnetic field of B frictionlessly on other wires in the horizontal direction, is…

Q: A capacitor in an LC oscillator has a maximum potential difference of 24.0 V and maximum energy of…

A: Given : Vmax = 24 V Umax = 184 uJ = 184 x 10-6 J V = 12 V

Q: An aluminum ring of radius r, = 5.00 cm and a resistance of 3.65 x 10-4 2 is placed around one end…

Q: A 50cm long solenoid, having 500 turns and radius 2cm ,is wound on an iron core of relative…

A: Length of solenoid: l = 50 cm = 0.50 m Number of turns : N = 500 Radius of solenoid; r = 2 cm =…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In each case, determine which end of the inductor is at the higher potential.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that for the circuit shown below, the initial energy stored in the inductor, LI2(0)/2 , is equal to the total energy eventually dissipated in the resistor 0I2(t)Rdt.
Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance per meter of in infinite, but otherwise identical, solenoid?
A solenoid of N1turns has length l1and radius R1, and a second smaller solenoid of N2turns has length l2and radius R2. The smaller solenoid is placed completely inside the larger solenoid so that their long axes coincide. What is the mutual inductance of the two solenoids?
For the circuit shown below, find the current through the inductor 2.0105 s after the switch is reopened.
Show that the expression for the magnetic field of a toroid reduces to tlrat for the field of an infinite solenoid in the limit that the cenmal radius goes to infinity.
A long solenoid of radius a with n turns per unit length is carrying a time-dependent current I(t)=I0sin(t) , where I0and are constants. The solenoid is surrounded by a wire of resistance R that has two circular- loops of radius b with b>a (see the following figure). Find the magnitude and direction of current induced in the outer
The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.
What is the magnitude of the emf induced in the secondary winding at the instant that the current in the solenoid is 3.2 A? Express your answer with the appropriate units. |ε|=
A rectangular metallic loop of dimensions ℓ and ω and resistance R moves with constant speed υ to the right as shown. The loop passes through a uniform magnetic field B→ directed into the page and extending a distance 3ω along the x axis. Define x as the position of the right side of the loop along the x axis. (A) Plot the magnetic flux through the area enclosed by the loop as a function of x. (B) Plot the induced motional emf in the loop as a function of x.(C) Plot the external applied force necessary to counter the magnetic force and keep υ constant as a function of x.
For the circuit above, R1 = 12 kΩ, R2 = 18 kΩ, L = 13.3 mH, and ξ = 9.5 V. How long after the switch, S, is closed does the current in the inductor reach 63.2% of its final value (that is, what is the characteristic time constant of this circuit)?
The AC current in the stator induces a voltage across an insulator(rubber) gap and into the rotor winding to produce rotor current and associated magnetic field. True or False?
To explain self-inductance, it is helpful to consider the specific example of a long solenoid, as shown in the figure. This solenoid has only one winding, and so the EMF induced by its changing current appears across the solenoid itself. This contrasts with mutual inductance, where this voltage appears across a second coil wound on the same cylinder as the first. Assume that the solenoid has radius R, length Z along the z axis, and is wound with nnn turns per unit length so that the total number of turns is equal to nZ. Assume that the solenoid is much longer than its radius. A. Suppose that the current varies with time, so that dI(t)/dt≠0. Find the electromotive force EMF induced across the entire solenoid due to the change in current through the entire solenoid. Express your answer in terms of dI(t)/dt, n, Z, and R. B. The self-inductance L is related to the self-induced EMF E(t)by the equation E(t)=−LdI(t)/dtt. Find L for a long solenoid. (Hint: The self-inductance L will…