The end point in a titration of a 42 ml sample of aqueous (CH,COOH) was reached by addition of 14 ml of 0.2 M titrant. The titration reaction is CH3COOH + NaOH CH3COONA + H2O What is the molar concentration of (CH,COOH)? • Round the answer to three significant figures. Provide your answer below:

Q: In a titration, it took 20.18 mL of 0.40 M NAOH to neutralize 10.00 mL of the HCI. What is the…

A:

Q: What volume in mL of 0.025 M HBr solution is to be required to titrations 125mL of a 0.049 M NaOH…

A: As per the reaction,  NaOH(aq) + HBr(aq) -> NaBr(aq)+H2O(I) we can see that 1 mole of HBr is…

Q: What is going on in the hexane layer at the end of a Group I Anion experiment? On a qualitative…

A: The given experiment is to identify the  and anions.

Q: 7.7 g of citric acid (MM = 192.1 g/mol) can be titrated with NaOH according to the following…

A: By stoichiometry of reaction : At equivalent point : Moles of H3C6H5O7 = Moles of NaOH  given mass…

Q: What is the pH ofa solution prepared by dissolving 1.4 g of Ca(OH)2 in water to make 975 ml. of…

A: Given: Mass of Ca(OH)2 = 1.4 g. And volume of solution = 975 mL = 0.975 L…

Q: ou are given a sulfuric acid solution of unknown concentration.  You dispense 10.00 mL of the…

A: Titration is one of the most common method of qualitative analysis of substances given. It is done…

Q: 2. What volume (mL) of 0.70 M Sodium hydroxide (NaOH) is needed to neutralize 270 ml of 0.40 M…

A: The required reaction, M1V1=M2V2 where, M is the molarity and V is the volume.

Q: a 50.0mL sample of phosphoric acid, H3PO4, is titrated with 42.50 mL of .250 M NaOH. What is the…

A:

Q: A 50.0 mL sample of phosphoric acid, H3PO4 is titrated with 42.50 mL of 0.250 M NaOH. What is the…

A: The balanced reaction required in this question is: H3PO4  +  3NaOH →  Na3PO4 +  3H2O   1 mole of…

Q: Given the reaction below for the titration of sulfuric acid with sodium hydroxide, if 20.00 ml of…

A:

Q: Given the mole ratio of HCl to NaOH is 1:1 in the balanced acid base reaction A 15.52mL sample of…

A:

Q: Assume you titrated to the endpoint 0.10 moles of HA (weak, monoprotic acid) with a solution of…

A:

Q: [Tutorial: Titration stoichiometry] This question will walk you through the steps of calculating the…

A:

Q: A hydrochloric acid solution is standardized by titrating 0.5008 g of primary standard tris…

A: Given that : The mass of  primary standard tris (hydroxymethyl) aminomethane, C4H11NO3 = 0.5008 g…

Q: 2. Suppose a titration needed 27.15 mL of 0.2497M HCI solution to completely react 25.00mL Ba(OH)2…

A: The number of moles of a substance is determined as the mass of a substance upon its molar mass. The…

Q: A titrant of 1.0 M K2Cr2O7 was used for titration of 30 mL aqueous ethanol C2H6O solution and…

A:

Q: If 38.70 mL of 0.290 M NaOH is used to titrate 25.0 mL of phosphoric acid, what is the molarity of…

A:

Q: Suppose a group of students put 2.92 grams of an unknown solid acid into a 250-mL volumetric flask…

A:

Q: Acetic acid reacts with sodium hydroxide in the following fashion.HC2H3O2(aq) + NaOH(aq) → H2O(l) +…

A: Given  Volume of acetic acid ( V1 )  =  2.50 mL                                               =…

Q: A titration of 38.0 mL of a sulfuric acid (H₂SO₄) solution of unknown concentration with a…

A: Given: Volume of H2SO4 (V1) = 38.0 mL Concentration of Ba(OH)2 (M2) = 1.55 M Volume of Ba(OH)2 (V2)…

Q: In the experiment conducted to determine the amount of acetic acid in vinegar, 8.2 mL of a 0.098 M…

A: Molarity of a solution is equal to the number of moles of solute present in one liter of solution.…

Q: A 18.0 mL sample of vinegar, which is an aqueous solution of acetic acid, CH3COOH, requires 15.5 mL…

A:

Q: A student analyzed an antacid tablet from a bottle of 50 tables purchased at a discount store for…

A:

Q: Calculate the molar concentration for H2 SO4 when 41 mL of it was completely titrated by 10.9 mL of…

A:

Q: A chemistry student weighs out 0.197 g of lactic acid (HC3H503) into a 250 mL. volumetric flask and…

A: When lactic acid is titrated with sodium hydroxide solution, then following balanced Chemical…

Q: During the standardization of NaOH , a drop of titrant was present on the tip of the buret when…

A: A titration is a procedure that uses a known concentration of a solution to calculate the…

Q: Consider a titration where 0.215 M potassium hydroxide is added from a burette to 10.00 mL of…

A: The titration between a strong base, KOH, and a strong acid, HCl results in the formation of a…

Q: A solution of 250.0 mL of a 0.200 M NaHCO3 solution is to be prepared. The solution is diluted by…

A: In the given problem, the molarity of the serially diluted solution can be calculated by using the…

Q: A 10.00 mL sample of vinegar is titrated with 0.187M NaOH and requires 16.33mL of NaOH to reach the…

A:

Q: By titration it is found that 28.7 milliliters of 0.155 M NaOH(aq) are required to neutralize 25.0…

A:

Q: An unknown vitamin C tablet was titrated with a 0.2030 M KOH solution. Calculate the milligram mass…

A: As vitamin C is the mono protic acid, 1 mole of vitamin C reacts with 1 mole of KOH. At equivalence…

Q: In the titration of acetic acid, CH3COOH, a 0.20 M solution of NaOH is used. A volume of 15.00 mL of…

A:

Q: An impure sample of the monoprotic acid benzoic acid (C6H5COOH, 122.12 g/mol) is titrated with…

A: Since 1 mole of benzoic acid has 1 mole of acidic H. because 1 molecule has only 1 acidic H. And 1…

Q: A 23.74-mL volume of 0.0981 M NaOH was used to titrate 25.0 mL of a weak monoprotic acid solution to…

A: Since , the acid is monoprotic then we can use this formula                          M1V1 = M2V2  to…

Q: final burette reading (mL) initial burette reading (mL) volume of NaOH(aq) added (mL) Use the data…

A: Given: 25.0 mL samples of perchloric acid solution are titrated with a 0.225 mol/L sodium hydroxide…

Q: Consider an analyte solution of 50.0 mL of 0.050 M hydrochloric acid, HCl, titrated against 0.10 M…

A:

Q: One of the main acidic components of acid rain is sulfuric acid, H2 SO4. Assuming sulfuric acid is…

A:

Q: A 27.56 mL portion of a 0.337 M solution of hydrochloric acid, a monoprotic acid, is to be titrated…

A: The chemical reaction between KOH and hydrochloric acid(HCl):                   KOH + HCl → KCl +…

Q: A 500-ml volumetric flask contains 150 ml of 0.200 N H2SO4. By adding a more concentrated H2SO,the…

A: 1.A. Given: C1= 0.200 N V1= 150 mL Details for initial sulphuric acid in volumetric flask C2= ? N…

Q: A solution of citric acid (F3C6H507) with a known concentration of 0.200 M H3C6H507 is titrated with…

A:

Q: Your objective is to determine the concentration of a solution of acid HA

A:

Q: A 10.00 mL vinegar sample is pipetted into an Erlenmeyer flask and titrated with 24.77 mL of 0.575 M…

A:

Q: A student places 20.00 mL of 0.1005 M HCl in a flask and adds a few drops of phenolphthalein. She…

A:

Q: During a lab experiment performed at STP conditions, you prepare HCl by reacting 100. ml of Cl2 gas…

A: H2(g) + Cl2(g)----> 2HCl

Q: PART I Phosphorous acid, H3PO3(aq), is a diprotic oxyacid that is an important compound in industry…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: What volume of 0.2045 M NaOH is necessary to titrate 50.00 mL of 0.1177 M acetic acid, CH3COOH ?

A: Acid-base titration: Titration is a method to determine the concentration of unknown acid by using…

Q: What is the concentration of a solution of a diprotic acid (i.e., H2A) which required 19.25 mL of…

A: Reaction- H2A + KOH →KAH + H2O KAH + KOH → K2A + H2O   Overall reaction- H2A + 2 KOH→  K2A  + 2 H2O

Q: Calculate the molar concentration for H, SO in the following situation. When 54 ml of it was…

A: The balanced chemical reaction involved in neutralization between strong acid , H2SO4 and strong…

Q: An analytical chemist weighs out 0.063 g of an unknown monoprotic acid into a 250 mL volumetric…

A:

Q: A sample of soda ash (impure NazCO3) is titrated with 0.5000N H2SO4. If the sample weighs 1.100 g…

A:

Q: 2. * A sodium hydroxide solution is standardized by titrating 0.8592 g of ordinary standard…

A: Given that:                              Weight of Potassium Hydrogen pthalate (KHP) = 0.8592gMolar…

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.