The head lamp reflector of a motor car has a maximum rim diameter of 130 mm and maximum depth of 100 mm. Draw the profile of the reflector and name it.

Q: Explain Cathode Ray Oscilloscope with neat sketch.

A:

Q: Quiz (1) A projectile is fired with an initial velocity of va = 150 m/s off the roof of the…

A:

Q: Identify the cable that consists of an inner cop core and a second conducting outer sheath. a.…

A:

Q: The microwaves in a certain microwave oven have a wavelength of 12.2 cm. Part A How wide must this…

A: Given : a Wavelength : 12.2 cmLength of oven : L = 6×λ2L = 6×12.22L = 36.6 cm

Q: The characteristics of the Smith chart are summarized as follows

A: Characteristics of the Smith chart are summarized as follows:  The Smith Chart is used to display…

Q: Figure 13 illustrates liquid level monitoring using radar type level transmitter. Describe how the…

A: The liquid level monitoring using the radar type level transmitter -> This is a non-contact type…

Q: Calculate the length of a twisted pair cable, the dielectric constant is 2.6 and the measured time…

A:

Q: The radius of a circle is 18cm. What is the arc length subtended by a central angle of 105°?

A: In this question we need to find arc length of circle.

Q: 6. The most effect that atmosphere can have on solar radiation is by B and C C) Transmission anr…

A: Choose the correct option The most effect that atmosphere can have on solar radiation is by...

Q: Vertical deflecting plates are placed vertically on the tube, It will move the beam up and down on…

A: In CRO there are two plates horizontal and vertical plates which are used for focusing the electron…

Q: Explain the Beam radiation and diffusive radiation with necessary diagram.

A: Radiation is defined as the waveforms of energy obtained by the transmission and emission from the…

Q: The array spacing is 4D by 8D, for 3 MW wind turbines, 90 m diameter. How many turbines can be…

A: According to the question we have to calculate the value of number of turbine.

Q: Draw equivalent ASM chart Representation for the above State diagram. B.

A:

Q: Q₁: Answer the following sentences with (True) or (False) then correct the false sentences: 1- The…

A:

Q: : In a practical SAT, the transponder bandwidth is about ______  . a) 500 MHz b) 600 MHz c)700 MHz…

A: Given  Multiple choice questions based on satellite communication. Please find the below attachment…

Q: c) Core diameter increases. The coupling efficiency between the optical Radiation pattern of the…

A: 1. Choice A As the refractive index of the cladding decreases, the field view of step index fibre…

Q: Explain the Beam radiation and diffusive radiation with necessary diagram.

A: Beam radiation: Direct radiation is another name for beam radiation. The rays in this radiation fly…

Q: Fill in the blanks: Q. Other name of TDR is _______________ Reflectometer.

A: TDR: It stands for Time Domain Reflectometer. It measures reflections along a conductor. It…

Q: Can you use a single oscilloscope probe to measure a differential voltage on a system in which…

A: The oscilloscope is used for electrical measurement and testing. The device comes embedded with an…

Q: directivity

A:

Q: An exact and more accurate formula for skin depth is & =2/Howa. In order to communicate with a…

A:

Q: And a typical phone service installation, a drywall is constructed beneath the_. A. Weep hole b.…

A: In this question we need to find a a correct option

Q: Determine the diameter of the mouth and HPBW of a parabolic reflector with a power gain of 300 and…

A: Given, Parabolic reflector has Power gain(P) = 300 Operating frequency (f) = 2 GHz

Q: Estimate the diameter of a paraboloidal reflector required to produce a beam of 15o width at a…

A: Since the frequency is given as 1.5 GHz, the value of the corresponding frequency will be

Q: Question # 1 In an air filed coaxial line operating with TEM mode, adjacent maximum and minimum are…

A: Given data, An air filled coaxial line operating with TEM mode has Vmax at x1=12.5 cmVmin at x2=37.5…

Q: Question 41 What is the typical single-mode fiber core size for 1310 nm and 1550 nm connections? Og…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 3. Suggest an electronic circuit to get the input and output characteristics on the screen of the…

A: The electric circuit which may be a Clipper circut  For the range of refference voltage will…

Q: When is supernode used in a circuit analysis? Provide an explanation.

A: If we have a voltage source in between two nodes then the two nodes are considered as SUPER NODE

Q: a. What is meant by transmittive cell type in LCD construction

A: According to guidelines we need to solve only the first question. According to the question, we need…

Q: When light goes from donser to rarer medium, on incidant angie less than the critiool angle, which…

A: In this question , we will write when light goes from densor to rarer medium as incident angle less…

Q: Design a single PRF for speed detection radar to detect the both the speeds that is below 40, and…

A: According to the question we have Design a single PRF for speed detection radar to detect both the…

Q: Q5: A. A ray of light in a core of fiber optic of refractive index 1.68 is approaching to cladding…

A:

Q: Explain the Beam radiation with necessary diagram.

A:

Q: The light spot in CRO moves across the face of the tube at uniform rate.

A: The light spot in CRO Moves beam across the face of the tube at a distance with time axis. Lighy…

Q: Que: How can we measure phase difference between two signals using Direct Oscilloscope Method? Hence…

A:

Q: Discuss in detail whether the incident energy can be sampled or not with pick up probe at port ‘4

A: The directional construction is shown in the figure below:

Q: What is the difference between the original Smith chart and the immittance chart? What are the…

A: The difference between the original smith chart and the immittance chart is explained in the table…

Q: Draw the circuit diagram for a multirange ammeter using an Ayrton shunt, Explain the circuit…

A:

Q: Discuss in detail the construction of a Directional Coupler.

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Determine the minimum electron densities corresponding to critical frequencies of 2.5 MHz and 8.5…

A:

Q: the basic advantage of Microwaves over Co-axial cables and the Fiber optics.

A: Microwaves: In the process the microwave beam can carry audio and video information.Microwaves were…

Q: What is the working explanartion for full-smd 16-led board?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 22) What is the ratio of the maximum radiation intensity to the average * ?radiation intensity…

A: Maximum directivity or directive gain is the ratio of maximum radiation intensity to average…

Q: Many rows of mirrors, which turn to face the sun and focus its rays onto the tower boiler, is…

A: sun based force tower framework utilizes a huge field of level, sun-following mirrors called…

Q: Which of the following is not used for communications? Select the correct response: A. X-rays B.…

A: In this we will write which way is not used for communication...

Q: 16. A microwave transmission line used to minimize noise and crosstalks. a. Stripline b. Hard line…

A: According to the question, we need to provide the correct option for the following  16. A microwave…

Q: B) Calculate the reflection coefficient of the cavity reflectors for semiconductor laser with 500µm…

A: For the given values of threshold gain and attenuation gain we need to calculate reflection…

Q: Report for Oscilloscope

A: Oscilloscope: Waveforms are visual representations of voltage changes over time. Oscilloscopes…

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.