Question

The offset link has a width of w=200mm and a thickness of 40mm. The allowable normal stress is 80 MPa. Determine the maximum load, P, that can be applied to the cables.

Step 1

Find the area of the offset link for the link width of 200 mm and thickness of 40 mm.

Step 2

Find the moment of inertia of the offset link for the link width of 200 mm and thickness of 40 mm.

Step 3

Find the maximum load *P* applied to the cables using the relation as follows:

The allowable stress is 80 MPa.

Consider a section at the mid along x-x axis.

The distance from the load acting point to the ...

Tagged in

Q: A member is made of the following materials: steel, brass and copper, the constants are listed below...

A: We are given the data of three materials namely steel, brass and copper.For steel,

Q: subject : Geotechnical Design Book : PRINCIPLE OF FOUNDATION ENGINEERING

A: q =γ H = 17 x 10 = 170 kN/m², Z= 5 mThe embankment is divided into blocks as shown in figure for mak...

Q: Determine the equations for the elastic curve for the beam using the x-coordinate. Specify the slope...

A: Determine the support reaction at A by taking moment about B.

Q: Just an answer check. My answer: M=58.2kN-m

A: Determine the modular ratio.

Q: subject : Geotechnical Design Book : PRINCIPLE OF FOUNDATION ENGINEERING

A: We are given the following data

Q: A strain gage located at C on the surface of bone AB indicates that the average normal stress in the...

A: First of all we will write the equation of the stress as shown below:Here, F represents force A repr...

Q: 3.15 In a site consisting of normally consolidated clean sands, the water table is at 10 ft depth. T...

A: Given :

Q: 3.25 In a site consisting entirely of clays, an electric friction cone penetrometer measures the con...

A: We have been given the following information,Cone resistance qc = 0.75MN/m2 at a depth of 8m.Water t...

Q: subject : Geotechnical DesignBook : PRINCIPLE OF FOUNDATION ENGINEERING

A: Part A:-we have the following loading condition andIn triangle XYZ, we have

Sorry about that. What wasn’t helpful?