Answered: The sulfur dioxide (SO 2 ) stack gas…

The sulfur dioxide (SO 2 ) stack gas concentration from fossil fuel combustion is 2 ppmv. Determine the stack gas SO2 concentration in units of ug/m 3 . Assume 0°C and 1 atm pressure.

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter7: Thermal Processes

Section: Chapter Questions

Problem 7.1P

See similar textbooks

Related questions

Q: 3. A viscous fluid having an absolute viscosity µ = 0.20 Pa*s flows in a 200 mm diameter pipeline at…

Q: Water is pumped from a large reservoir to a storage tank 30m above via a constant diameter pipe. The…

A: To Determine a) The overall efficiency of the pump-motor unit if all frictional losses in the pipes…

Q: 2-10. The soaking bin contains ethyl alcohol used for cleaning automobile parts. Suction pump C is…

A: Given, Density of Ethyl alcohol = 789kg/m³ Pressure at B = -5. 50×10³ Pa Note : Negative sign…

Q: Convert a pressure head of 10 m water column to kerosene of specific gravity equal to 0.8 and to…

Q: A fluid with a kinematic viscosity 1500 ft2/sec flows with an average velocity, v = 200 ft/sec…

A: Given: The kinematic viscosity is ν=1500 ft2/s. The average velocity is v=200 ft/sec The inside…

Q: Calculate the evaporation rate from an open water source, if the net radiation is 300 W/m and the…

Q: ellowing data are given for a biogas digester suitable for the output of six cows. The volume of…

A: Standard dia to height ration 1.5 to 4

Q: Calculate the power required to pump oil of specific gravity 0.85 and viscosity 3 x 10-3 N.s/m² at…

Q: Subject:( Environmental Engineering 2) Question: Compute the required volume of the aeration tank,…

A: Given data- Side water depth (D) Tank length (L) Tank width (B) The flow of the aeration tank (Q)…

Q: 1. Steam at 2.0 kPa is saturated at 17.5C. In what state will the steam be at 40C if the pressure is…

A: Given data- 1. Case-(a) Steam at 2.0 kPa is saturated at 17.5C Case-(b) Temperature=40C , pressure…

Q: in of a light oil are to be heated from 20C to 100C (with zero vaporization) in an exchanger using…

A: Given:- heated temperature=20 degree Celsius to 100 degree Celsius quantity of light oil =2m3/min…

Q: Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a…

A: The given data is shown below: Efficiency=99.4 %Discharge=30,000 m3/minResistivity=7.1×1010 ohm-cm

Q: roblem 3- 104 Vater in a tank is pressurized to 80 cmHg. Determine the total force per meter ridth…

A: Calculate the pressure at B and A using hydrostatics then force can be calculated as area of…

Q: Example :- Calculate the power in W/m required for mixing an oil of relative density 0.93 and…

A: The given data is as follows: Relative density of oil=0.93Viscosity of oil=18 N.s/m2Diameter of…

Q: A water treatment plant is being designed to process 50000m3/day of water. Jar testing indicate that…

A: The given data is: Q= 50000 m3/day =50 MLD Alum dose=40 mg/l The velocity gradient is not given,…

Q: In Fig. P216 the 20°C water and gasoline surfaces are open to the atmosphere and at the same…

A: Consider the figure,

Q: Determine the mean effective pressure in kPa of a certain air -standard Diesel cycle which has a…

Q: *1-8. The bottle tank has a volume of 1.12 m³ and contains oxygen at an absolute pressure of 12 MPa…

Q: homogeneous mixture of oil globules in water, find the average velocity and density of the mixture…

Q: ertical jet. If there is no energy loss, (Z, - Z,) = h. What is V2 ? Demonstrate that V3 = 0 if Z, –…

Q: Use the laboratory data to determine the specific gravity and water Oven Dry weight - 4.97 kg Weight…

A: Given oven dry weight (A)=4.97 kgsaturated surface dry (SSD) weight (B)=5.04 kgsubmerged weight…

Q: Nitrogen gas at 50°C is under a pressure of 630 kPa. Assume a gas constant of 296.8 J/kg-K.…

Q: A gas at 45 degrees Celsius is under pressure of 398.675 kPa. Assume gas constant of 287N-m/kg-K. a.…

Q: Determine theoretical oxygen demand (mg/L) for 250 mg/L of methanol (CH3OH). CH,0H + 02→ C0, + H,0…

Q: 19. A pump delivers a discharge to head of 30 m. Given, suction lift = 5.58 m, atmospheric head =…

Q: The inlet and exit temperatures of the air expanded at an adiabatic turbine are 50 Cand -30 C,…

Q: The elevation at point A in the tank below is 32m. Calculate the pressure (in Pa) at the surface of…

Q: Q2. An unvented kerosin heater is operated for 1 hr in an apartment (V=150 m'). The heater emits SO,…

Q: A 10-kg mass of superheated refrigerant-134a at 1.2 MPa and 70°C is cooled at constant pressure…

A: The given data is shown below:

Q: Oil of specific gravity 0.85 flows freely from a tank through a 60 mm diameter pipe. The oil surface…

Q: nturi wine aerator is filled continuously from a bottle so that the le height, h = 4 cm, above the…

A: According to given data A Vinturi wine aerator is filled continuously from a bottle so that the…

Q: Let P and T be the pressure and temperature of the super-heated vapor and Psat be the saturation…

Q: Determine theoretical oxygen demand (mg/L) for 250 mg/L of methanol (CH3OH). CH30H + 02 → C0, + H,0…

Q: A vapor compression refrigeration cycle uses steam as the working fluid. Steamflows steadily with a…

Q: The following information is given for n-pentane at 1 atm:boiling point = 36.20°C ΔHvap (36.20°C) =…

A: A type of elastic collision in which two objects of equal mass initially move in the same direction…

Q: Determine theoretical oxygen demand (mg/L) for 250 mg/L of methanol (CH3OH). CH,0H + 02 → C0, + H,0…

Q: In the tank of 100 liters of brine containing 50kg totally dissolved salt. Pure water is allowed to…

A: Let Q be the amount of salt in the mixture. Therefore volume of mixture: Vmix=100+3-2tVmix=100+t…

Q: Air enters an adiabatic nozzle steadily at 300 kPa, 200°C, and 30 m/s and leaves at 100 kPa and 180…

Q: your solutions neatly and properly. 3 kg of steam with quality of 30% has a pressure of 12.056 bar.…

A: Vg=14.1889cm3/sec Vf=1.5289cm3/s

Q: a cylinder of 0.9 m cube in volume contains air at 0°c and 39.24n/cm^2 absolute pressure. the air is…

A: Given: The initial volume is 0.9 m3. The absolute pressure P1 is 39.24 N/cm2. The temperature T1 is…

Q: 02. Gasoline at 20°C is pumped through a smooth 12-cm diameter pipe 10km long, at a flow rate of 75m…

Q: A closed cylinder having a volume of 3 m² contains 0.03 m³ of saturated liquid water and 2.97 m of…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: hat temperature will the steam be just dry and saturated?

A: Given data m=0.05kg P=1.5MPa=15bar volume of 0.0076 m3

Concept explainers

Reactions with Materials

Limestone

Question

The sulfur dioxide (SO

) stack gas concentration from fossil fuel

combustion is 2 ppmv.

Determine the stack gas SO2 concentration in

units of ug/m

. Assume 0°C and 1 atm pressure.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the minimum fluidization velocity for an anthracite bed having following characteristics; d90 = 2.9 mm, ?anthracite = 1600 kg/m3, ?water = 998 kg/m3 at 20°C; µ = 1.002x 10-3 kg/m.sec
and temperature. Calculate the density of the gas.Q.4: If the gas oil ratio = 560 Scf/STB at initial pressure of 4300 psia, calculate the GOR at bubble point pressure of 3500 psia and at pressure of 1900 psia.
The pipe is 25mm with friction factor of 0.022. The second tank is vented. H1=1.4m H2=4.5m H3=1.0m X1=14.9m X2=2.7m Calculate the pressure(kPa) above the gasoline in the first tank that will result in a flowrate of 400 liters/min.
Calculate the pressure difference between points A and B. The specific gravity of the oil is 0.85
24000-ton coal/day having 4.2% Sulphur and emits gases at velocity of 18.3 m/s and temperature 140 °C from a hole of diameter 8m in ground. The physical height stack is 200m. Find the down-wind ground level concentration at the distance of 1.5 km. Data given: Air temperature: 8 °C, Wind speed: 4.5 m/s Dispersion coefficient horizontal: 600 m Dispersion coefficient vertical: 295.1
Medium fuel oil having an absolute viscosity of 6.55 x 10⁻⁵ ft²/s flows in a steel pipe 4100 ft long at a maximum rate of 0.201 cfs. Which of the following most nearly gives the minimum diameter of the pipe in ft required to keep the flow in a laminar condition?
Air enters an adiabatic nozzle steadily at 300 kPa, 200°C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm2. Determine (a) the mass flow rate through the nozzle, (b) the exit temperature of the air, and (c) the exit area of the nozzle. R = 0.287 kJ/kg. K, CP 1.005KJ/kg. K.
The velocity of oil flowing thru a 30mm diameter pipe is equal to 2m/s. Oil has a kinematic viscosity of 5x10^-5 m2/s. If the pipe has a length of 120m. Compute for the Reynolds number. Compute for the friction factor. Compute the head loss of the pipe.
Solve the heat equation ut=cuxx on the domaion 0≤x≤2, t>0 subject to u(x,0)=x(x−2), u(0,t)=0,u(2,t)=0
The saturated liquid of water at T=300C has total volume (v) of 0.05m3,quality(x) of 75%,vf=1.4036×10-3m3/kg,vg=0.02167m3/kg A.find the specific volume v in m/kg of two phase mixture B.find the mass (m) of water in kg C.find the mass(mg) of the satured vapor in kg D.find the mass(mf) of the satured liquid in kg
the value of oil is - 0.8 asap 15 mins
A closed tank contains liquified butane gas whose specific gravity is 0.60. The tank pressure is 1.7 Mpa gage which is also the equilibrium vapor pressure of butane at the pumping temperature. Suction lines losses is 1.5m of gas and the static elevation gain is 4m. What is the NET POSITIVE SUCTION HEAD AVAILABLE?(NPSHa)