Question

The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals. [0·0094 μF/km]

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: A 230-kV, three-phase transmission line has a per phase series impedance of .... (please see attache...

A: We only answer the first three parts of a question on this platform, unless specified otherwise. Sin...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: Find the steady state response for i0(t) in the circuit in fig 9.29 if Vs=100sin50t mV

A: Steady state response for the current needs to be calculated using the below given data and figure:

Q: 1012 112 100 V Figure 4.20 System diagram for Problem 4.2a 1 2 10 2 100 V Figure 4.21 System diagram...

A: a) For calculating the pick up current here we have to calculate the line to line current for bus A ...

Q: please help with question 45. thank you

A: The values of Z0, Z1, Z2 and Z3 as a function of A, B, C and D should be obtained by the following s...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....

Q: SO dependent youpe sunce Tx o.S 22V 54

A: Consider the Two nodes V1 and V2 as shown;

Q: 8- In the following circuit find i() 2Ω 0

A: From the circuit, write the expression for io(t) as follows:

Q: How would I sketch the input-output relationship of op-amp comparators with hysteresis?

A: Consider an inverting Op-Amp comparator circuit as shown in Figure 1.

Q: i Gu Pevse use Modol or mesn 10 A 2 Thearen 2Ω 12 10

A: Let us apply supernode at nodes 1 and 2:

Q: Ql: a) A set of reading obtained in an experiment is 49.7. 50.1, 50.2, 49.6, 49.7 determined: 1- Ari...

A: As this question has many sub parts, so I will be answering the first five sub-parts of Q1. a.   In ...

Q: imu omplete SY%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: In the following circuit calculate 1, and Vo. Name the method you are using. 21

A: Applying KVL in Loop 1 we get:

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...

Q: Examiner lecturer: Hawraa Qasim Date: 16/4/2018 unleridtions&Measurements Division: Electrical Engin...

A: (a) Dynamometer:This is type of measurement device that is used to measure voltage, current, and pow...

Q: 6- In the following circuit find io (t) t-0 3 A i, (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A: STEP BY STEP METHOD:From the circuit, write the expression for io(t) as follows:

Q: uunection current 0.5mA is to be used. 02: a) Derive the equations of balance for Hay bridge to dete...

A: Hay bridge is a modified version of Maxwell\'s bridge and the circuit diagram is given below 

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: How to convert the following decimal number to numbers with metric prefixes in following below?29) 5...

A: We need to convert the given numbers to numbers with metric prefixes.

Q: 1. FIGURE 52 shows the one-line diagram of a simple three-bus power system with generation at bus I....

A: Convert the line impedances into admittances, using Y=1/Z 

Q: une nodal amolipis to Soue the euit omol vo bupe loop ondly sij ho sohe hme ardu and iud Vo S Vo Sl ...

A: This problem will be solved by the application of Kirchoff's Voltage Law and current law. According ...

Q: Q3. By using the method of images, prove that the capacitance between conductor and earth, taking in...

A: From the diagram shown below, we can say that:

Q: How was the value of the capacitor derived?

A: Click to see the answer

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.

Q: The one-line diagram of a three-phase power system is as shown in the figure attached. Impedances ar...

A: The load at bus is S2=15.93 MW-j33.4 MvarFirst converting all the values in per-unit systemThe load ...

Q: help me with ques 8A

A: Consider the four inputs namely A, B, C, and D and its respective outputs are mentioned as X1, X2, X...

Q: 7- In the following circuit find i,o) 7- . 16 6 V 12 0

A: We need to calculate i0(t), in the following circuit:

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

Q: Use source transformation to find ix in the circuit below. (circuit displayed in attachment)

A: We can transform the current source into equivalent voltage source. The value of voltage source is c...

Q: 9 Find v,1) in the following circuit. You may employ any method you wish. + Vo (t) 4

A: We need to calculate v0(t), in the following circuit: -

Q: The ABCD constants of a three-phase, 345-kV transmission line are:A = D = 0.98182 + j0.0012447.B = 4...

A: Since, the given ABCD parameters for the 345 kV transmission lines are:A = D = 0.98182 + j0.0012447B...

Q: e foll a Onny uruut hind 34%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: he follo miny Cu nd R omptete ミ? 2 2. /2 レ

A: Click to see the answer

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.25

A:  First, find out the canonical form from the given transfer function    and after that design a cont...

Q: Ii

A: Redraw the circuit in s domain as shown in Figure 1 to obtain the required values.

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A:  The current i0(t) is to be calculated in the following circuit: -

Q: 1 99% 7:50 PM l Verizon LTE Done 12- Find i(t) and v(t) in the following circuit. You may employ any...

A: Figure 1 shows the modified circuit when t < 0.

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: 3.31 Find the node voltages for the circuit in Fig. 3.80. C, ML 1S2 4lo 2v V1 V2 11o 4 92 4Ω 1S2 ÷) ...

A: Nodal analysis primarily depends on the application of Kirchoff\'s Current Law (KCL) to various esse...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: The initial voltage across a 7.5F capacitor is 4.5V after 0.5 seconds. If the current is described a...

A: Initial voltage Vo=4.5 VC=7.5FAt 0.5s current is given as:

Q: A 200 km, 3-phase transmission line has its conductors placed at the corners of an equilateral trian...

A: (i)  The line to neutral capacitanceGiven values: -The radius of each conductor is given as r = 1 cm...

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: Problem 2 question 2

A: In this problem, It is said that the value of R1, R2 and C should be physically realistic value such...

Q: Find i(t) and v(t) for t >0 in the circuit in the figure attached.

A: Write the general expression for unit step function,