Question
Asked Nov 26, 2019
1 views

I need help solving these 3 simple parts, if you can not answer all 3 parts then please leave it for another tutor, thank you.

There is one ASME standard for surface texture terms, definitions, and symbol
application on the print.
True
False
The term used to define the direction of the predominant surface pattern is lay.
True
False
The current ASME surface texture symbol most resembles a check mark, although
there are five basic forms the symbol can take.
True
False
help_outline

Image Transcriptionclose

There is one ASME standard for surface texture terms, definitions, and symbol application on the print. True False The term used to define the direction of the predominant surface pattern is lay. True False The current ASME surface texture symbol most resembles a check mark, although there are five basic forms the symbol can take. True False

fullscreen
check_circle

Expert Answer

Step 1

(1)

ASME standard is concerned with geometric irregularities of the surface.

 

ASME standard includes roughness, waviness and lay and define parameter for specify surface texture.

False, is the right answer of the above question. More than One type of standards are used in  drawing print and all surface texture, definitions and symbols .

Step 2

(2)

Lay on the surface is the direction of the predominant surface patt...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Other

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A
add
question_answer

Q: . A vehicle of mass m = 900 kg travels over a long terrain that is approximately sinusoidal: y = d s...

A: Given data,

question_answer

Q: solve (d) part of Q7 asap

A: Consider the simple gas refrigeration cycle,

question_answer

Q: 9. Show that the thermal efficiency of a combined gas-steam power plant nee can be expressed as nce ...

A: Click to see the answer

question_answer

Q: I need problems 1, 2, and 3 solved pertaining to the print provided below.

A: Answer to Question no. 1Datum A is a datum axis.Datum B is a datum center plane.Datum C is a datum c...

question_answer

Q: I need problems 10, 11, and 12 answered pertaining to the print attached below.

A: The print sheet shows the 3D perspective of the part BACK CAP generally used in TIG Welding. It is u...

question_answer

Q: M5.20 (Sl units) A GO/NO-GO plug gage will be designed to inspect a 50.00 0.20mm diameter hole. Awea...

A: Go gage will inspect the minimum shaft diameterAnd NO-GO gage will inspect maximum shaft diameter.

question_answer

Q: As shown in the figure below, two reversible cycles arranged in series each produce the same net wor...

A: Write the expression for the work done on each cycle:

question_answer

Q: An iron block of unknown mass at 185°F is dropped into an insulated tank that contains 0.8 ft of wat...

A: At first, determine the mass of water, mw, in which the iron block is dropped.

question_answer

Q: I need help answering questions 4, 5, and 6 pertaining to the print provided below.

A: For the surface texture symbols the values are in micro inches.