To retrieve a sample from a culture tube with an inoculating loop, the cap of the tube is a. removed and held in one’s teeth. b. removed and held with the fingers of the loop hand. c. removed with the fingers of the loop hand and placed in the fingers of the tube hand. d. removed with the fingers of the loop hand and placed on the laboratory bench. e. Any of these methods can be used.

To retrieve a sample from a culture tube with an inoculating loop, the cap of the tube is a. removed and held in one’s teeth. b. removed and held with the fingers of the loop hand. c. removed with the fingers of the loop hand and placed in the fingers of the tube hand. d. removed with the fingers of the loop hand and placed on the laboratory bench. e. Any of these methods can be used.

Comprehensive Medical Assisting: Administrative and Clinical Competencies (MindTap Course List)

6th Edition

ISBN:9781305964792

Author:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Publisher:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Chapter30: Assisting With Minor Surgery

Section: Chapter Questions

Problem 2CR

See similar textbooks

Similar questions

Which of the following is the proper technique for inoculating an agar slant with a broth culture? A. Stab the butt of the media with the wire loop. B. Stab the surface of the agar media with the wire loop beginning at the base of the tube moving toward the mouth as you withdraw the loop. C. Gently move the wire loop back and forth across the surface of the agar beginning at the mouth of the tube moving down toward the base of the slant. D. Gently move the wire loop back and forth across the surface of the agar beginning at the base of the slant as you withdraw it from the tube.
Explain why the following steps are essential during subculturing:a. Flaming the inoculating instrument prior to and after each inoculation.b. Holding the test tube caps in the hand as illustrated in Figure 1.1 on page 24.c. Cooling the inoculating instrument prior to obtaining the inoculum.d. Flaming the neck of the tubes immediately after uncapping and beforerecapping
An inoculating loop must be flamed to uniform orange-hot from base to tip A. after culture is transferred to the wire loop but before transfer to new media B. before culture is transferred to the wire loop and after culture is transferred from the wire loop to new media C. after culture is transferred to the wire loop and before culture is transferred from the wire loop to new media D. before culture is transferred to the wire loop
The following are errors that people commonly make when they perform serial dilutions. Indicate whether you think that the number of cfu/ ml calculated would be too high or too low if you make this mistake. You intend to add 0.9 ml of diluent to each tube and 0.1 ml of culture. Instead, you add 0.5 ml of diluent to each tube and 0.1 ml of culture to the first tube. Then, you make a serial dilution of 0.1 ml into and from each tube as described. You prepare 0.9 ml of diluents in each tube. You add 0.1 ml of culture (from the overnight culture provided) to every tube. You add 0.9 ml of diluent to each tube. You add 0.1 ml of culture to the first tube and mix. You get distracted, and transfer 0.1 ml to the third tube instead of the second. You perform the rest of the series as described.
In this experiment, a culture was serially diluted to the concentrations below. Each plate was plated with 0.25mL of the dilution. Using the most diluted plate, what is the correct concentration of the original culture? A) 2.0 X 10^-3 cells/mL B) 2.0 X 10^5 cells/mL C) 4.0 X 10^5 cells/mL D) 5.0 X 10^4 cells/mL
You gather the following result from the Bile Esculin Test :a. Please interpret & analyze this result. b. To confirm this result what type of identification test would you perform & why.
A nurse who created a sterile field for a patient is adding asterile solution to the field. What is an appropriate actionwhen performing this task?a. Place the bottle cap on the table with the edges down.b. Hold the bottle inside the edge of the sterile field.c. Hold the bottle with the label side opposite the palm ofthe hand.d. Pour the solution from a height of 4 to 6 inches (10 to15 cm).
Which of the following is an important measure that may prevent bacterial contamination in tube feeding formulas? Question 71 options: a) Discarding opened containers of formula not used within 24 hours b) Adding formula to the feeding container before it empties completely c) Using the same feeding bag and tubing each day d) Adding the full days worth of formula to the bag at the start of each day
Increasing the tube voltage on a clinical x-ray unit: a. Improves the resolution of an x-ray image. b. Increases the intensity of the Characteristic x-rays. c. Increases the intensity of the Bremsstrahlung x-rays. d. Increases the energy of the Bremsstrahlung x-rays. e. Increases the energy of the Characteristic x-rays. and why??
What is the purpose of the following in a Bradford assay? a. PBS b. the Bradford reagent c. changing the pipette tip between standards
E-strip testing can be used to determine a drug MIC against an organism. Which ONE of the following is correct? Select one: A. The zone of inhibition is inversely proportional to the activity of the drug B. The E-strip result guides to the maximum drug concentration that can be used to clear an infection C. The E-strip is impregnated with a fixed concentration of drug D. The E-strip is used broadly clinically to determine if an organism is resistant to a drug E. The MIC is read where bacterial growth touches the E-strip
To prepare a vaginal irrigation, a nurse uses 3 tsp of vinegar and 1.5 L of water. a. How many ml of vinegar should she use? b. If she prepares a solution using only 500 ml of water, how many ml of vinegar should she use?