Question
Asked Oct 3, 2019
50 views

True or False: Objects must actually touch each other for the TRIM command to work.

 

check_circle

Expert Answer

Step 1

The TRIM command is a tool in AutoCAD software which is used to eliminate or cut off any selected part of an object or system of objects.

Step 2

The TRIM command just needs the selection of a point on every object on that side of the trim line which requ...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in

Engineering

Mechanical Engineering

Other

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you

Show more Q&A add
question_answer

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be u...

A: Refrigerant is R-134aEvaporator pressure P1 = P4 = 180 kPaCondenser pressure P2 = P3 = 1400 kPaMass ...

question_answer

Q: The circuit breaker at a power seat motor continuously trips: Technician A says that this could be c...

A: The reasons for which a circuit breaker trips are as follows:Excess current flow due to overloaded c...

question_answer

Q: 4.53. Heat-Transfer Area and Use of Log Mean Temperature Difference. A reaction mix- ture having a c...

A: Specific heat of reaction mixture cpm = 2.85 kJ/kg.KMass flow rate of reaction mixture mh = 7260 kg/...

question_answer

Q: The front row in a movie theatre has 23 seats. If you were asked to sit in the seat that occupied th...

A: Median: Median stands for ‘middle’.The median is most commonly defined as a value that is in the mid...

question_answer

Q: 3-20 Water is boiling in a 25-cm-diameter aluminum pan (k 237 W/m K) at 95°C. Heat is transferred st...

A: Assumption:Consider system as Steady state and one dimensional since the thickness of the pan is ver...

question_answer

Q: The alloy’s melting temperature will dictate the _____. a)pattern material b)size of injector pump ...

A: The die casting process requires a pattern or a mold to produce the metal casting. But the requireme...

question_answer

Q: The spring is fixed to block A and block B is pressed against the spring. If the spring is compresse...

A: Apply the conservation of momentum principle to the given system.

question_answer

Q: 7.80 Figure Pz.80 shows an insulated counterflow heat exchanger with carbon dioxide (CO2) and air fl...

A: Convert ambient temperature from Fahrenheit to Rankine.

question_answer

Q: Figure PZ55 and the accompanying table provide the schematic and steady-state operating data for a f...

A: Given: