two suggestions in reducing the head loss in the pump and piping syste

Q: 11 psig 17 psig 4 feet 20 psig 6. What is the static pressure per foot of head? 7. What is the level…

A: Ans.6    Pressure difference between 4 ft is 20psig-17 psig=3 psig Per ft is 3/4 psig =0.75 psig/ft…

Q: Describe how the wind turbine works.

A: The wind turbine as name suggests, the main energy sources comes from kinetic energy of the wind.…

Q: Multicylinder pump

A: Where more than one cylinder is being driven by one driver, the arrangement is named according to…

Q: ed between two large open reservo ne elevation When the pump adds

A:

Q: Water jet.

A: For solution  refer below images.

Q: clearance ratio of the compressor.

A: Given; Clearance volume of a reciprocating compressor,  Vc=120 mlVolume of the cylinder at bottom…

Q: If you reverse the valve of the faucet to reduce water flow what will happen to water that flows out…

A: If you reverse the valve of the faucet to reduce water flow what will happen to water that flows out…

Q: Fuel pump __ is a statement of the volume of the fuelflow from the pump.

A: Fuel pump is a device in the vehicle which is used to send the fuel from the tank to the engine…

Q: Define ASME pump [standards used

A: given; Define ASME pump [standards used]

Q: Describe the different parts of a centrifugal pump

A: Centrifugal pumps are used to deliver the liquid from lower level to higher level. Centrifugal pump…

Q: A pump is being supplied with water from an open tank. The water level of the sOurce

A:

Q: In a piping system, what is used to control the flow rate? (a) Pipe (b) Valve (c) Fitting (d) Pump…

A: Valve is used to control the flow rate fluid flowing in pipes. Valve is a device that regulates and…

Q: What will happen when the pressure at any point inside a centrifugal pump goes below the vapor…

A: Given Data⇒ Centrifugal pump Pressure at any point inside pump Vapour pressure corresponding to the…

Q: what is the best type of pump for use in a hydraulic system

A:

Q: dvantages in using a dual cylinder water pumping system using scotch yoke mechanism

A:

Q: Entry of liquid into the pump is axial and exit from the pump

A: Given data;  Blade outer radius,r= 25 mm Power,P=2 KW=2000W N=2000 rpmEntry of liquid into the pump…

Q: Which of the following situations will make a pump noisy? Select all that apply. O Excessive oil…

A: Answer:- All given situations will make the pump noisy.   The various situation that will make the…

Q: discharge pressure at the pump exit

A: Given; A centrifugal pump is required  to pump water to open water tank situated 4 km away from the…

Q: Simple hand operating pump is also called as ______ a. Centrifugal pumps b. Bicycle pump c. Froth…

A: Simple hand operated pump is also called as  a. Centrifugal pump b. Bicycle pump c. Froth Pump  d.…

Q: C) What is the maximum possible mass flow rate that the pump can produce?

A:

Q: Figure shows two possible locations for a water pump in a piping system that pumps water from the…

A: Net positive suction head (NPSH) can be defined as the measurement of fluid's pressure on the…

Q: Power operated pump in which only one side engages the fluid displacement is called.

A: Correct option is:

Q: Explain the operating principles/mechanism: i) ii) To include diagrams of the pumps. Centrifugal…

A: Please find the solution below

Q: Lukewarm water at 60 °C in a storage tank is being pumped at 300 L/min from the tank. The line from…

A: Water temperature, T=60oCWater flow rate, Q=300 L/min=300*10-360m3/s=0.005 m3/sLength of suction…

Q: Factors affecting the actual flow rate of venturi meter.

A: A Venturimeter  measures  the volume/mass  rate of flow for any fluid.

Q: FLOW THROUGH PIPELINE PROBLEM Process water is pumped from the main storage tank (A) to process…

A: Centrifugal pumps are used for converting the rotating kinetic energy into hydrodynamic energy, The…

Q: HOW TO CALCULATE PUMP SIZE

A:

Q: How to a fule pump transfers mechanical energy to a fluid by raising its pressure.

A: A pump is a device which converts mechanical energy into pressure energy

Q: Two types of pumps

A:

Q: Which of the following conditions will cause a pump to be noisy? O All of these conditions will…

A:

Q: Describe a direct-expansion versus a flooded evaporator.

A: Flooded Type Evaporator: Compared to a dry type, a flooded type evaporator transfers heat more…

Q: is type of pump that the oil that comes from the suction side of the pump gets fully transferred to…

A: The pump mainly contains a shaft and an impeller. Both are the necessary parts of the pump to…

Q: What is the difference between the permieter-loop and permiter-radial duct systems?

A: A perimeter loop system is generally well suited for buildings that are built using a concrete slab.…

Q: Decsribe why variable-speed compressor motors are more efficient then single-speed motors im heat…

A: Variable speed compressor are operating on variables speed while single speed motor are operating at…

Q: ) Rate of heat rejection from the turbine

A:

Q: The volume of air delivered by the compressor is called A) Compressor capacity B) Swept volume C)…

A: Given Data⇒ Volume of air delivered by the compressor Problem statement⇒ The volume of air delivered…

Q: Explain the benefits of oil and a one-way valve in a mechanical pump

A: The engine crank shaft is directly linked to the oil pump. In order to reduce wear and tear and…

Q: What is performance characteristics of a centrifugal pump

A: A centrifugal pump is designed to develop certain manometric head and discharge at constant speed…

Q: When choosing the optimal pump, the operating point should be kept close to

A:

Q: Advantages and disadvantages of trash pump

A: Trash Pump:  Trash pumps are usually portable and can handle solid-laden water - making them ideal…

Q: Which type of the pump is different from others in the same group? Select one: a. Plunger pump b.…

A: Answer:-  Option (a) correct. Plunger pump.

Q: compressor

A: Rotary compressors are a positive displacement machines. It hah following features; It is designed…

Q: Determination of Discharge Thru a Siphon Vol

A: Given Distance = 83.5 cm = 0.835 m To find Trials Theoretical discharge Actual discharge Difference…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.