volumertic and non-volumetric quantitative analytical menthods

Q: Define Laboratory testing

A: The objective of the question is to define the term "Laboratory testing" which elaborates briefly…

Q: What is one effective way to calibrate a thermometer?

A:

Q: solution stock Concentration (mL) (mL) (HM) 0.100 100.00 Q2a 0.200 100.00 0.400 100.00 4 0.800…

A: Dilution refers to decreasing the concentration of solute in a solution. This is done by adding…

Q: What is sampling in analytical chemistry?

A: Analytical chemistry is a branch of chemistry in which we analyze the sample by different…

Q: acia SOluti Select one: -5 а. 1.33 х 10 М -4 b. 3.76 x 10 'M -5 C. 2.66 x 10 M -5 M d. 5.32 x 10

A: Answer - The correct option is (d) 5.32*10^-5

Q: According to the chromatography the value of the distance traveled by the solvent is:

A: We need to calculate the distance traveled by solvent.

Q: Which of the following statements is true?   After drying a sample in the oven, you can place it…

A: There are three types of substances or matter. These three types are solid, liquid and gas.…

Q: chromatography

A: chromatography is a process in which the mixture is separated.  In this process we dissolve the…

Q: Table 1. Data for standard addition method Volume of Tablet Volume of standard Absorbance Final…

A: Given Data for standard addition method. Concentration of standard solution in 250 mL…

Q: Name three common uses of High Performance Liquid Chromatography (HPLC) in the laboratory.

A:

Q: Paper chromatography was used to separate the components of a food dye. The food dye separated into…

A:

Q: 1000 mL of 0.45% NaCl IV for 6.5 hours Drop factor: 60 gtt/mL Flow rate: ________ gtt/min

A: IV flow rate An IV flow rate is a way of describing the rate of an intravenous infusion based on the…

Q: It is a type of mixture with particles evenly scattered in a dispersed medium without settling down

A: Mixture is the  combination of  two substance.  There are  two types- 1) Homogeneous  mixture.  2)…

Q: These technique are time consuming, costly and frequently needcomplementary information about sizing…

A: We will determine which techniques are time consuming costly and frequently need complementary…

Q: Shown is a thin-layer chromatography (TLC) plate. In this case, a student decided not to line up the…

A: The R f factor is called retention factor. The expression to find out R f factor in thin layer…

Q: Choose the one correct or one incorrect statement regarding filtration:      gravity filtration…

A: the correct option is:

Q: Color BEFORE adding Color AFTER adding Intensity of color AFTER adding FeCl3 Test Tube # FeCl3 FeCl3…

A: Using a melting point apparatus, Determine the melting point of obtained crude aspirin and…

Q: Test Tube Volume Volume of Water Added Syringe Reading (mL) V w Total Air Volume Trial (mL) V t (mL)…

A: Boyel's law : It states that the temperature always remains constant when the volume of given mass…

Q: 4800 300 e000 1500 MVENUERIl 1000 of CH3 OH

A:

Q: Determine the weight percent (wt%) of selenium in the soil sample and find the absolute uncertainty…

A: Given: To Calculate:  weight percent Se in the soil and the absolute uncertainty in the weight…

Q: Why is it necessary to calibrate lab instruments such as a thermometer and volumetric glassware?

A: An instrument that has the capability to measure the temperatures or temperature changes in a…

Q: What is the correct ratio of sample to KBr? O 1) 1:10 ratio O 2) 1:50 ratio 3) 1:2 ratin

A: Spectroscopy plays an important role in the analysis of chemical compounds. Infrared spectroscopy is…

Q: II. lodometry II. Permanganate IV. Dichromate

A: Indicators can be defined as the  substances that change colour when they are added to basic or…

Q: Sapling Learning 3.18 V Voltmeter Mg Ag KNO, salt bridge 1.0 M Mg" 1.0 MAg Zn Cu

A: By writing half reaction of cell according to given cell.

Q: H20 N2 Oven 90°C latm

A: Use formula ln(P2/P1) = - ΔHR(1T2- 1T1) Where P1 = initial pressure = 1 atm P2 = 9.86 atm ; T1 = 900…

Q: Titrant density (g/mL) Ave density (g/mL) Trial SD (g/mL) RSD (%) A В

A: A question based on research methodology, which is to be accomplished.

Q: Sublimation is preferred over recrystallization when you work with an amount of solid material to be…

A: There are many purification techniques. Sublimation and recrystallization are purification…

Q: Why do we need to press “tare” when weighing in an analytical balance?

A: Solution Analytical balances square measure used for terribly correct, quantitative measurements of…

Q: The color change of a chemical requires an overtitration of 0.04 mL. Calculate the percent relative…

A: Given, Experimental value = 50 mL + 0.04 mL = 50.04 mL True value = 50 mL Calculating the percent…

Q: "unknown C run #1" 1 1 C: \Bruker\Topspin4.0.9 unknown C run #1 10 8 2 [ppm] 0000' 3.9217 z- 2

A:

Q: Which of the following is used as a carrier gas in gas chromatography? A) Helium Carbon dioxide…

A:

Q: What is the most positive characteristic of a Thermoluminescence dosimeter compared to film badges

A: The thermoluminescence dosimeter (TLD) involves the measurement of the ionizing radiation on…

Q: ds Iitensive or extensive. Intensive Extensive Answer Bank temperature color volume boiling point…

A: The physical properties which does not depend on the amount of matter are termed as intensive…

Q: Level = 6ft of water (h20 density = 0.036 Ib/in^3) Find gauge reading in psi = Find gauge reading…

A: As it is known that- 2.31 feet of water head will be equal to 1 Pound per square inch (psi) psig:…

Q: Place 10 drops of the solution to be analyzed, mix thoroughly and centrifuge. ordinary test tube…

A: A centrifuge is a device that uses centrifugal force to separate materials. It separates the…

Q: how to get from molairty to millliters? in conversion factors

A:

Q: What kind of mixture of substance has Distillation and Chromatography has?

A: There are different type of separation techniques or methods, which are used to separate the mixture…

Q: What should you write in your lab notebook if you measure 10 mL of a liquid as accurately as you can…

A: There are different types of glassware which are being used while performing any sort of experiment…

Q: How to use the analytical balance properly?

A: Analytical balances are designed to measure small quantities of mass. It has a glass chambered setup…

Q: Suppose Megan needs to transfer 5.00 mL of a liquid with high precision and accuracy. Which of the…

A:

Q: test tube mL Nickel standard ML 0.6 m H2SO4 blank 10.0 mL 2.0 mL 8.0 mL 2 4.0mL l6.0 mL 3 l6.0 mL…

A:

Q: Active Raw Materials Actual Yield Formulation Dosage Form Packaging Ingredient Potassium 3 kgs.…

A:

Q: 1000 mL of 0.45% NaCl IV for 3 hours Drop factor: 20 gtt/mL Flow rate: ________ gtt/min

A:

Q: assify each property as intensive or extensive. Intensive Extensive Answer Bank hardness volume…

A: An intensive property is one that does not depend on the mass of the substance or system. Example :…

Q: 9 9 A. Cg Hg 03 00 ppm -N 200 180 160 140 120 100 com -9 O

A:

Q: 1. Discuss the following: a) direct method of weighing b) indirect weighing using the analytical…

A: According to Q&A guidelines of Bartleby, we are supposed to answer only the first question out…

Q: Why do you need to “tare” the digital balance before use?

A: we need to tare the digital balance before using because we only want the mass of the substance we…

Q: Describe the procedure involved in flame test. Subject: Analytic chemistry

A: The flame test is used to detect the presence of elements, based on each element's characteristic…

Q: Estimated volume of crucible 25.0 mL  measured volume of crucible 23.0 mL  percent error of…

A: % error=accepted value-experimental valueaccepted valuex100 %